ページ1に含まれる内容の要旨
PLCD69MP
OWNER’S MANUAL
Mobile Audio System
• PLL Synthesizer Stereo Radio
• Digital Compact Disc Player
• Automatically Memory Storing
• Hiding Panel
• Preset Equalization
• Auxiliary Input Function
• Remote Conrol
ページ2に含まれる内容の要旨
CONTENTS Installation .....................................................................................................3 DIN Front-Mount (Method A) ..................................................................................3 Installing the unit...............................................................................................3 Removing the unit .............................................................................................4 DIN Rear-Mount (Method B) .........
ページ3に含まれる内容の要旨
INSTALLATION Notes: DIN FRONT-MOUNT (Method A) • Choose the mounting location where Installing the unit the unit will not interfere with the normal driving function of the driver. 1 2 • Before finally installing the unit, connect the wiring temporarily and make sure it is all connected up 53 properly and the unit and the system 3 work properly. • Use only the parts included with the unit to ensure proper installation. (Fig. 1) The use of unauthorized parts can cause malfunctions. 1. Dash
ページ4に含まれる内容の要旨
INSTALLATION Removing the unit 1. Factory-installed radio bracket 2. Car radio mounting bracket 3. Screw 1 4. After aligning the car radio mounting 2 bracket with the factory-installed radio bracket, tighten the screws (M5x4mm) at 2 places on each side. 5. When fixing factory-installed radio bracket with the screws, use a 3 standard-tipped screwdriver to pry the tabs of the car radio mounting bracket to make them fit into the holes in the factory-installed radio bracket. 6. Movable panel fra
ページ5に含まれる内容の要旨
USING THE FRONT PANEL 1. When open the car lock (ACC ON), 3. Then insert a disc in the disc slot, the the panel of the unit will change from panel will automatically turn up to State 1 to State 2 (see below), the State 2. Press (eject) button again, hidden panel will turn up. the panel will turn down to eject the disc. If you don’t insert a disc in again, the panel will automatically turn up about 10 seconds. If you don’t want to wait, press (eject) button, the panel will also turn
ページ6に含まれる内容の要旨
WIRING CONNECTION MAIN UNIT ANTENNA CONNECTOR (GREEN) FUSE SUBWOOFER IGNITION RED CABLE SWITCH (B+) YELLOW MEMORY BACK-UP (GREY) Rch RED RCA CABLE BLACK GROUND (B–) Lch WHITE BLUE POWER ANTENNA WHITE GREY FRONT Lch FRONT Rch SPEAKER SPEAKER WHITE/BLACK GREY/BLACK GREEN VIOLET REAR Lch REAR Rch SPEAKER SPEAKER GREEN/BLACK VIOLET/BLACK 6
ページ7に含まれる内容の要旨
OPERATION 16 4 11 10 26 17 25 8 9 2 13 12 18 19 20 21 14 22 15 6 3 24 1 7 23 5 GENERAL OPERATION the following order: Volume Bass Treble Balance Fader • ON/OFF When the hiding panel turns up (in By pressing volume up button (11) or State 2), press button (9) to turn on volume down button (12), it is possible the unit. When system is on, press to adjust the desired sound quality. button (9) to turn off the unit. • LOUDNESS • SOUND ADJUSTMENT Press LOU/BND button (13) for several Press
ページ8に含まれる内容の要旨
OPERATION • SET THE CLOCK • RESET Press the DSP button (15), and the RESET button (25) must be activated clock is shown on the display. with either a ball point pen or thin metal Then hold down the button until the object. RESET button (25) is to be clock flashes. Then press the activated for the following reasons: MANU/SKIP button (17) to change - Initial installation of the unit when all hours or MANU/SKIP button (16) to wiring is completed. change minutes. - All the function buttons do
ページ9に含まれる内容の要旨
OPERATION • AUTOMATICALLY MEMORY RADIO OPERATION STORING & PROGRAM SCANNING - Automatic Memory Storing • BAND SELECTION Press AMS button (18) for several At tuner mode, press LOU/BND button seconds, the radio searches from (13) shortly to select the desired band. the current frequency and checks The reception band will change in the the signal strength level until one following order: cycle search is finished. FM1 FM2 FM3 AM And then 6 strongest stations are stored into the corresponding
ページ10に含まれる内容の要旨
OPERATION CD OPERATION • CD OPEN/CLOSE/EJECT When the front panel is in State 2 and the unit is on, press (eject) button (4), the panel will change into State 3 and display the disc slot (5). Then insert a disc into the slot, the panel will automatically turn up. Press (eject) button (4) again to eject the disc. And after about 10 seconds, the panel will turn up. • SELECT TRACKS Press MANU/SKIP button (16) or MANU/SKIP button (17) to move to the previous track or the following
ページ11に含まれる内容の要旨
OPERATION REMOTE CONTROL HANDSET 1 7 4 3 8 9 6 5 13 2 12 10 11 14 15 FUNCTION KEYS & CONTROL 1. PWR = Power ON/OFF Button 2. DSP (0) = Display Button (_, -, +, 0) 3. SEL = Select Button (Character Shift Right) 4. VOL = Volume Up Button [Charater Select (A, B~8,9,0)] 5. VOL = Volume Down Button [Charater Select (A, B~8,9,0)] 6. BND (ENTER) = Band Select Button (Enter Button) 7. MOD (7) = Mode Button (S, T, U,7) 8. TUNE/SEEK = Tune/Seek Down Button (V, W, X, 8) 9. TUNE/SEEK = Tune/Seek Up Button (
ページ12に含まれる内容の要旨
OPERATION • Press DSP button, ID3 TAG is MP3 OPERATION (FOR WITH MP3 displayed by this key if available, OPERATION VERSION ONLY) supported TAG is Songname, Artist, Album, Year, Comments. If not During MP3 operation, these buttons available, there is displayed bellows serve the followings: some words in LCD Unknown Songname, Unknown Artist, No 1.“Searching track directly” in Digital Album Title, Unknown Year, No Audio CD. Comments also if not available ID3 2.“Searching File Name” in Di
ページ13に含まれる内容の要旨
OPERATION Note: • For a non-MP3 file, even though the file name extension is “.MP3”, the unit A. Notes on discs: cannot recognize it. • Attempting to use non-standard shape discs (e.g. square, start, heart) may D. Notes on multi session disc: damage the unit. Be sure to use round • If the first track of the first session is shape CD discs only for this unit. audio CD data, then the unit will play • Do not stick paper or tape etc., onto only the audio CD data. the label side or the recordi
ページ14に含まれる内容の要旨
SPECIFICATION GENERAL Power Supply Requirements : DC 12 Volts, Negative Ground Chassis Dimensions : 178 (W) x 165 (D) x 50 (H) Tone Controls - Bass (at 100 Hz) : ± 10 dB - Treble (at 10 KHz) : ± 10 dB Maximum Output Power : 4 x 60 Watts Current Drain : 15 Ampere (max.) CD PLAYER Signal to Noise Ratio : More than 55 dB Channel Separation : More than 50 dB Frequency Response : 20 Hz - 20 KHz RADIO FM Frequency Coverage : 87.5 to 107.9 MHz IF : 10.7 MHz Sensitivity (S/N = 30 dB) : 3 µ V Stereo Sepa
ページ15に含まれる内容の要旨
ページ16に含まれる内容の要旨
www.pyleaudio.com 88-C1731-23
