ページ1に含まれる内容の要旨
MODEL ACC-31
6-DISC CD CHANGER WITH
WIRED COMMANDER
COMPACT
DIGITAL AUDIO
INSTALLATION MANUAL
ページ2に含まれる内容の要旨
PACKING LIST MAIN UNIT CD Changer ACC31 DIGITAL AUDIO 6 DISC COMPACT DISC CHANGER BY AUDIOVOX INSTALLATION PARTS Phillips Hex -Head Changer Mounting Brackets Self-tapping screw Bolt (Small), w/Flat (M5 x 12), Washers and Lockwashers w/Lockwashers 8 pcs. each 6 pcs. each R L 1 each 5 Meter Din Cable Floor Mounting Brackets Screw Hole Cover Labels 1 pc. 1 pc. 1 each LR ACCESSORIES CD Magazine Index seal sheet Installation Manual Owner's guide P/N:ACC31MAZ 1 pc. 1 pc. 1 pc. 1 pc. 2
ページ3に含まれる内容の要旨
BEFORE INSTALLING THE UNIT Transport Lock Screws The mechanism in the CD changer is "locked" into place during shipment by the 4 transport screws, two on each side. Be sure to remove the screws prior to installation. Retain these screws for future use when transporting the unit for service/maintenance. CAUTION After removing the transport lock screws, place the supplied seals over the screw holes. These seals are used to keep dust out of the unit, which could cause a malfunction. Instal
ページ4に含まれる内容の要旨
ACC31 DIGITAL AUDIO 6 DISC COMPACT DISC CHANGER ACC31 DIGITAL AUDIO 6 DISC COMPACT DISC CHANGER BY AUDIOVOX BY AUDIOVOX INSTALLATION The unit can be installed horizontally (position H), or vertically at a 90° angle (position V). The position of the built-in anti-vibration springs (left and right side), must correspond to the mounting position chosen. If the springs are not set correctly for the type of installation chosen, the anti-vibration compensation will not be effective and
ページ5に含まれる内容の要旨
PROCEDURE FOR VERTICAL INSTALLATION Note If the anti-vibration spring position has been changed and verified for vertical mounting (as shown on page 4), start with step 2. Set the anti-vibration springs to position "V" Attach a mounting bracket to each side of the unit, using 1 2 as shown below . the hex head bolts and washers. POSITION "V" Bracket Bracket Hex head bolt and washer Determine the mounting location and drill two mounting holes. Mount the unit in place, using two self-tapping Phill
ページ6に含まれる内容の要旨
VEHICLE COMPONENT LAYOUT NOTE: 1. Check with your Rampage/Audiovox audio dealer to be sure your stereo is directly compatible with this CD changer. 2. When used with Rampage Model AV-427 car stereo, be sure Changer Selector switch on bottom of radio chassis is set to position "B". 6
ページ7に含まれる内容の要旨
© 2000 Audiovox Electronics Corporation, Happauge, N.Y. 11788 Printed in China 128-5943 8