3D Innovations PMCS Network and Device Configurator GEH-6510の取扱説明書

ページ1に含まれる内容の要旨

GE PMCS App Note 31 Page 1 of 5
 
 
 
Technical Note #31
RAS - Host and View Node
Subject: Configuring a Host and a View Node to communicate via modems.
Applies To: PMCS 5.0 / Windows NT 3.51.  For later versions of PMCS and NT
the process is similiar.  Please see your user manuals for exact instructions.
To perform the following tasks, you will need a Windows NT Workstation CD (or
diskettes). Due to the possibility of unique, existing NT system configurations, the
following steps may vary s

ページ2に含まれる内容の要旨

GE PMCS App Note 31 Page 2 of 5 17. RAS Server TCP/IP Configuration dialog: Select radio button: This computer only. Select radio button: Use static address pool. Enter into Begin field: 1.2.3.4. Enter into End field: 1.2.3.14. Click: OK. Note: Any valid address range can be entered. 18. Remote Access Setup dialog: Click: Continue. 19. Setup Message dialog: Message advising you to install MS Loopback Adapter: Click: OK. 20. Network Settings dialog: Click: Add Adapter. 21. Add Network Ada

ページ3に含まれる内容の要旨

GE PMCS App Note 31 Page 3 of 5 computer only. Click: OK. 11. RAS Server TCP/IP Configuration dialog: Select radio button: This computer only. Select radio button: Use static address pool. Enter into Begin field: 1.2.3.4. Enter into End field: 1.2.3.14. Click: OK. Note: Any valid address range can be entered. 12. Remote Access Setup dialog: Click: Continue. 13. Remote Access Setup dialog: Message about how to set RAS permissions, Click: OK. 14. Network Settings dialog: Click: OK. 15. Ne

ページ4に含まれる内容の要旨

GE PMCS App Note 31 Page 4 of 5 14. Remote Access Setup dialog: With your modem displayed and highlighted, Click: Network. 15. Network Configuration dialog: Select Dial out Protocols check boxes: NetBEUI and TCP/IP. Click: OK. 16. Remote Access Setup dialog: Click: Continue. 17. Network Settings dialog: Click: OK. 18. TCP/IP Configuration dialog: Keep defaults, Click: OK. 19. Windows NT Workstation Networking Setup dialog: Click: Restart Computer. 20. Access: Remote Access Service/Remot

ページ5に含まれる内容の要旨

GE PMCS App Note 31 Page 5 of 5 field: 2. Click: OK. 8. DDE Shares dialog: Click: OK. Note: Trusted shares can be lost upon rebooting the computer. If you are experiencing problems with a view node accessing the host node after reboot, try deleting the GE16MODB|* share and performing the steps listed above again. It also may be helpful for troubleshooting purposes to look at NT's Event Viewer on the Host and View nodes. NetDDE on the View Node: If you are experiencing trouble accessing the