ページ1に含まれる内容の要旨
ASSEMBLY INSTRUCTIONS
FOR FIRST ACT MD700
SEVEN PIECE DRUM SET
CRASH
CYMBAL
10” TOM DRUM
DRUMSTICKS
HI-HAT
12” SNARE
CLUTCH
TOM MOUNTING ARM
DRUM
HI-HAT
CRASH
CYMBALS
CYMBAL
STAND
DRUM SEAT
HI-HAT
TENSION
STAND
ROD
SNARE
STAND
18” BASS DRUM
13” FLOOR
TOM
BASS DRUM
PEDAL WITH
FELT BEATER
© 2004 FIRST ACT INC. ALL RIGHTS RESERVED MD700
ページ2に含まれる内容の要旨
7 PIECE DRUM SET DRUMS [A] 12” Snare Drum [B] 10” Tom Drum [C] 13” Floor Tom Drum [D] 18” Bass Drum CYMBALS [E] 12” Hi-hat Cymbals (2) [F] 14” Crash Cymbal STANDS / HARDWARE / DRUM HEADS [G] Snare Stand [H] Hi-hat Stand [I] Cymbal Stand [J] Bass Drum Pedal w/ Felt Beater [K] Tom Tom Mounting Arm w/ Memory Clamp [L] Bass Drum Spurs (2) [L.1] Retractable Rubber w/ Spiked Tip [M] Floor Tom Legs (3) [N] Bass Drum Tension Rods w/ Washers (12) [O] Bass Drum Rim Claws (12) [P] Bass Drum Hoops (2) [Q
ページ3に含まれる内容の要旨
ASSEMBLY INSTRUCTIONS FOR FIRST ACT MD700 SEVEN PIECE DRUM SET Thank you for purchasing the First Act MD700 seven piece drum set. By following these simple steps you’ll be set up and playing in no time! Be sure to look over the Drum Contents page and identify the parts and hardware that you’ll be using to assemble the drum set. You’ll need the drum tuning key to complete set up and tuning. After set up, use the Drum Tuning Diagrams and Instructions below on how to tune your drums. Assembl
ページ4に含まれる内容の要旨
Spread the legs at the base of the cymbal stand (I) and set evenly on the floor. Insert the top tube of the cymbal stand into the tripod base. Adjust height as necessary and tighten. Spread tripod legs out evenly. The wider the legs are spread the more stable the stand will be while playing. Place the 14” crash cymbal (F) over the threaded top of the cymbal stand leaving one washer and one cymbal felt on the underside and one cymbal felt and washer on top. Tighten wing nut leaving enough
