ページ1に含まれる内容の要旨
Owner's Guide
ページ2に含まれる内容の要旨
,& WARNING: Toreduce the risk of fire or electric shock, do not expose the Wave_ Radio/CD to rain or moisture. As with any electronic product, use care not to spill liquids into any part of the system. Liquids can cause a failure and/or a fire hazard. CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, AFIN DE PREVENIR UN CHOC ELECTRIQUE NE PAS ENLEVER LE COUVERCLE ARRIERE. IL NE SE TROUVEA L'INTERIEUR DO NOT REMOVE COVER (OR BACK). AUCUNE PIECE POUVANT ETRE REPAREEPAR NO USER-SERVICEABLE PARTS INSID
ページ3に含まれる内容の要旨
Where to find... Setting Up Before you begin ........................................................................................................... 4 Unpacking the carton ................................................................................................... 5 Selecting a location for your Wave ®Radio/CD ............................................................. 5 Installing the battery ..........................................................................................
ページ4に含まれる内容の要旨
Before you begin Thank you for purchasing the Bose ®Wave®Radio/CD. Fourteen years of research by Bose Corporation bring you the benefits of award-winning patented acoustic waveguide speaker technology. Using this technology, a tube efficiently transfers energy from a small loudspeaker to the outside air over a whole range of bass notes. And, by folding long waveguides into intricate patterns, they fit into products small enough to be placed comfortably in your home. There is a 27-inch (68-cm) lo
ページ5に含まれる内容の要旨
Unpacking the carton Carefully unpack your system. Save all packing materials for possible future use. The original packing materials provide the safest way to transport your Wave®Radio/CD. If any part of the product appears damaged, do not attempt to use it. Notify Bose®Product Support immedi- ately (see phone numbers on the inside back cover). Check to be sure your Wave Radio/CD contains the parts identified in Figure 1. Figure 1 What comes with your Wave Radio/CD Remote control Mountingstrip
ページ6に含まれる内容の要旨
Installing the battery The 9-volt battery maintains clock and alarm settings and operates the Wave®Radio/CD's backup alarm system for up to 24 hours, during a power loss or while the system is tempo- rarily unplugged. Operating without this battery leaves the memory unprotected, but will not harm the product. Use a standard 9V battery (IEC 6F22 in Europe), available at most retail stores. Use an alkaline battery for longer backup time. Note: The battery does not provide power for Wave Radio/CD o
ページ7に含まれる内容の要旨
Connecting the power cord 1. Unwind the power cord completely to ensure the best FM reception. The FM antenna is built into the power cord. 2. Plug the power cord into an electric outlet (Figure 3). The display panel lights and the time display begins flashing. 3. Press and hold either Time 4 or _, button to stop the flashing and set the time. Figure 3 Connecting the power cord Adjusting the antennas With the FM antenna built into the power cord, adjusting the cord position affects FM radio rece
ページ8に含まれる内容の要旨
Setting up the remote control WARNING: Keep the remote control battery away from children. /t may cause a fire or chemical bum ff mishandled. Do not recharge, disassemble, heat above 212°F (100°C), or indnerate. Dispose of used battery prompdy Rep/ace only with a battery of the correct type and model number. Your remote control may be one of two types (Figure 4A or 4B). Each is identified by the way the battery compartment unlocks to install or replace the battery. 1. Place the remote control fa
ページ9に含まれる内容の要旨
Note: Use only a DuracelL Eveready, Maxell, or Toshiba CR2032 or DL2032 lithium battery (available at electronics stores). If you have difficulty finding a replacement battery, contact Bose_ Product Support (see phone numbers on the inside back cover). 3. Keeping the remote control face down, insert the new battery into the compartment with the + symbol facing up. 4. Gently slide the battery compartment closed. It locks automatically. 5. Use the supplied mounting strip if you want to attach the
ページ10に含まれる内容の要旨
Connecting other components as an option You can use your Wave®Radio/CD to improve the sound of a TV,VCR, computer, or tape player. Or use it as extension speakers for a Bose®Lifestyle_ music system. Connect one of these components to the R (right) and L (left)AUX IN jacks. To play your radio or CD player through external speakers, connect powered speakers with an independent volume control to the system's R (right) and L (left) LINE OUT jacks. Audio cables for these connections are available at
ページ11に含まれる内容の要旨
Connection at Connectien at Wave Radio/CD Note Component Cable component Portable tape player One minip!ug4o' Headphone jack AUX INjacks AUX iN stereo audio cable For best sound, set the player volume control to approxi- @ R mately 3/4of maximum 4) volume. CD changer, tape AUX INjacks You can record from your Wave® One stereo audio Audio output jacks deck, or VCR Radio/CD using the connections from the LiNE OUT jacks. _@_ If there are two sets of variable), outputs (fixed use fixed and so that t
ページ12に含まれる内容の要旨
Using the remote control You can use the remote control to operate the most frequently used functions of the radio, CD player, and alarms. Aim the remote control at the display of your Wave Radio/CD. Use the remote buttons in the same way you use the system control panel. The remote normally works up to 20 feet in front of the system, and 6 feet to either side. Replace the remote control battery when it stops operating, or its range seems reduced (normally every year or two). Keep in mind that l
ページ13に含まれる内容の要旨
Using the radio/CD control panel In addition to controlling the most frequently used functions of the radio, CD player, and alarms, control panel buttons allow you to set the time, alarms, CD mode, and radio presets (Figure 8). Using button combinations on the control panel gives you access to additional special features (such as customizing the display and programming the CD player). For details, refer to the "Quick Reference to Special Functions" on page 28. Three raised dots on the Sleep/Snoe
ページ14に含まれる内容の要旨
Reading the Wave Radio/CD display Flashes when Lights when Alarm 1 is Shows Figure 9 Shows current time, mute is activated, flashes while volume, alarm time, sleep setting Alarm 1, and when selected FM or AM The WaveRadio/CD display time, snooze time, going off preset Indicates nap time, AM/FM Lights number, tone alarm Indicates when CD is frequency, CD time, CD track is set or CD is the CD program item, playing, number, selected going off flashes for battery level brightness source Indicates )a
ページ15に含まれる内容の要旨
Setting the time Function To set the clock - Hold down either Time <1 or _ button or press the same one twice. The time display changes slowly at first, then faster. Release the clock set button to stop. Customizing the display Function hold and press To set AM/PM (12 hour) or Military (24 hour) time - With the system off, hold down Alarm Setup and press On/Off to switch between AM/PM (12 hour)and Military (24 hour) time formats. To select c|ock or source display mode - With the system on, hold
ページ16に含まれる内容の要旨
Controlling the system Rern ntrol Function To turn on/off - Press On/Off once to turn on or off. The system turns on to the last source played. To select a source - Press FM orAM, CD, orAUX. To listen to a component connected to AUX, be sure to turn on the component. Pressing AUX does not turn on the component. = To adjust the volume - With the system on or off, press and hold A either button to reset the volume. The display shows the volume level, volume from 0 (silent) to 99 (loud). With the s
ページ17に含まれる内容の要旨
Using the radio Function To turn the radio on/off - Press On/Off once to turn on or off. The system turns on to the last source played. Or, press FM or AM or any Preset to turn the radio on. To seek a station - Press Track/Tune <_ or l> once to tune in the Track/Tune next strong station. Repeat to locate a station you prefer. After manually tuning (see below), wait 2 seconds for the system to return to seek mode. To manually tune in a station - Tap either Track/Tune <_ or button quickly two or m
ページ18に含まれる内容の要旨
Using the CD player Lift the CD door (as shown). Place the CD, label-side up, on the spindle in the CD well. Gently lower the door more than halfway, until it begins to close by itself. Or continue to close it manually if you prefer. Figure 11 Setting up a CD / Function To turn on/off - Press On/Off once to turn on or off. The system turns on to the last source played. Or, press CD Play _ II to turn on the CD player. In CD mode, the CD begins to play as soon as you load a disc and close the CD d
ページ19に含まれる内容の要旨
Function To display CD information - If the display is in clock mode (see page 15) and the CD is playing, hold down Alarm Setup and press Track/Tune Track/Tune <_ or _ on the control panel only. To display playing time for one track - After pressing CD Stop [], Track/Tune m press Track/Tune <_ or _> to display total time for the selected track. Press OD Play 1_| | to play the selected track. To display elapsed or remaining time for a track or disc - In play or pause mode, hold down Alarm Setup w
ページ20に含まれる内容の要旨
Setting the alarms Note: Youcan set alarms with the Wave Radio/CD on or off Function To enter alarm setup mode - Press and release Alarm Setup. The system is now in alarm setup mode. ALARM 1 flashes for 10 seconds. To select which alarm to set - While ALARM 1 is flashing, set alarm time, volume, and alarm sound (tone o_)), radio, or CD), for Alarm 1. Press Alarm Setup again until ALARM 2 is flashing. While it flashes for 10 seconds, begin to set Alarm 2. To set the alarm time - While the selecte
