ページ1に含まれる内容の要旨
Propane/LP Patio Heater
Owner’s Manual
98LK
WARNING: For
outdoor use only.
MODELS SPC-54PHW, SPC-54PHB, AND SPC-54PHT
IMPORTANT: Read and understand this manual before
assembling, starting or servicing heater. Improper use
of heater can cause serious injury. Keep this manual for
future reference.
GENERAL HAZARD WARNING:
Failure to comply with the precautions and instructions
provided with this heater, can result in death, serious
bodily injury and property loss or damage from hazards
of
ページ2に含まれる内容の要旨
TABLE OF CONTENTS Specifications ...................................................... 2 Servicing .............................................................. 8 Safety Information ............................................... 2 Replacement Parts .............................................. 9 Propane/LP Safety .............................................. 4 Technical Service ................................................ 9 Assembly Instructions .........................................
ページ3に含まれる内容の要旨
16. Use only soapy water (1 part liquid dishwash- SAFETY INFORMATION ing detergent to 3 parts water) to conduct Continued Leak Tests whenever a propane cylinder is 3. Use only propane/LP gas. connected. Bubbles indicate a leak. 4. Use only VAPOR WITHDRAWAL propane 17. Do not adjust gas regulator. If you are unsure supply. The propane cylinder must be arranged of your appliances gas type or pressure, call for vapor-withdrawal, in accordance with the out a gas fitter or plumber. Compress Gas
ページ4に含まれる内容の要旨
ASSEMBLY Installation and repair should be done by a qualified service person. INSTRUCTIONS The heater should be inspected Tools Required: before use and at least annually by #2 Philips Head Screwdriver 1 a qualified service person. More Adjustable Wrench 2 frequent cleanings may be required Inspect heater components for possible shipping as necessary. It is imperative that damage. If any is found, immediately notify the control compartments, burners, and dealer. Check to make sure that
ページ5に含まれる内容の要旨
ASSEMBLY INSTRUCTIONS Continued Pole 4. Insert manifold into pole support (see Figure 2). Insert the manifold assembly through the post by passing through the hole in the post support. N o t e : Make sure hose and regulator assembly Propane/LP Cylinder attached to manifold are never bent or kinked Cover during installation and operation of heater. 5. Attach pole to pole support (Figure 3). Place pole into pole support center connector. Base Tighten six set screws with hex allen wrench s
ページ6に含まれる内容の要旨
MANIFOLD FIXING PLATE AND ASSEMBLY INSTRUCTIONS POLE SUPPORT Continued 1. Locate threaded hole underneath post support. CHECK FOR LEAKS This hole is for mounting manifold fixing plate IMPOR T ANT : The heater must be leak tested be- (see Figure 7). fore any further assembly is done. Use only a soap 2. Align holes on manifold fixing plate with and water solution. DO NOT USE FLAME. threaded holes on pole support. Turn control knob to the "OFF" position. Securely 3. Make sure manifold fixing p
ページ7に含まれる内容の要旨
ASSEMBLY INSTRUCTIONS OPERATING Continued INSTRUCTIONS DOME AND EMITTER WARNING: If you smell gas: Gently lay heater assembly on its side using one of • Shut off gas to the appli- the shipping styrofoam inserts to prop up the top half of heater. Align holes in dome with threaded ance. studs in emitter cover. Secure dome to emitter • Extinguish any open flames. using three cap nuts. Tighten with an adjustable • If odor continues, immediately wrench. Stand heater back to upright position. ca
ページ8に含まれる内容の要旨
OPERATING INSTRUCTIONS STORAGE Continued 1. Allow at least 45 minutes for heater to cool down after using. 2. Store heater upright in a sheltered area away CAUTION: Do not attempt from inclement weather and dust. to slide the viewing hole cover 3. If desired, cover heater after heater has when the main burner is lighting, cooled. operating or hot. 4. If heater is not to be used for an extended period 3. Set the heat level. of time, disconnect and remove propane/LP gas cylinder and store
ページ9に含まれる内容の要旨
REPLACEMENT PARTS TECHNICAL SERVICE A heater which is not working right must be re- WARNING: Use only original paired, but only by a trained, experienced service person. To find the service center closest to you, replacement parts. This heater or if you have further questions about this heater, must use design-specific parts. contact DESA Heating Productsʼ Technical Service Do not substitute or use generic Department at 1-866-672-6040. When calling, parts. Improper replacement please hav
ページ10に含まれる内容の要旨
ILLUSTRATED PARTS BREAKDOWN MODELS SPC-54PHW, SPC-54PHB, AND SPC-54PHT 1 2 3 12 25 4 1 1 5 6 7 8 13 26 10 15 14 17 9 16 20 19 18 21 24 23 27 28 22 29 25 1 10 www.desatech.com 114144-01A 26 2 3 27 4 22 6 28 10 29 20
ページ11に含まれる内容の要旨
PARTS LIST This list contains replaceable parts used in your heater. When ordering parts, follow the instructions listed under Replacement Parts on page 9 of this manual. KEY PART NO. NUMBER DESCRIPTION QTY. 1 114133-01 Reflector 1 2 114102-01 Emitter Assembly 1 3 114104-01 Burner Assembly 1 4 114113-01 Burner Cover Bottom 1 5 114126-01 Orifice, Main Burner 1 6 114130-01 Adiabatic Plate 1 7 114138-01 Tip Switch 1 8 114140-01 Fuel Tube 1 9 114142-01 Valve 1 10 114115-01 Valve Housing Cover
ページ12に含まれる内容の要旨
WARRANTY AND REPAIR SERVICE KEEP THIS WARRANTY Model Serial No. Date of Purchase LIMITED WARRANTY DESA Heating Products warrants this product and any parts thereof, to be free from defects in materials and workmanship for one (1) year from the date of first purchase when operated and maintained in accordance with in- structions. This warranty is extended only to the original retail purchaser, when proof of purchase is provided. This warranty covers only the cost of parts and labor required to r
