ページ1に含まれる内容の要旨
™
BEL AIR
OWNER’S MANUAL
ページ2に含まれる内容の要旨
ページ3に含まれる内容の要旨
CONTENTS INTRODUCTION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 MOUNTING RECOMMENDATIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 FAN INSTALLATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 INTELI•TOUCH OPERATION . . . . . . . . .
ページ4に含まれる内容の要旨
MOUNTING RECOMMENDATIONS Before mounting your Casablanca fan, read the following helpful recommendations. The location of the fan, air circulation, and fan size are all important factors to consider before installation. Location Ceiling fans have practical uses in almost every room in your home. We suggest you follow these mount- ing recommendations as you decide where to install your Casablanca fan. • For safety reasons, the fan blades must be a minimum of 7' above the floor. • Do not locate th
ページ5に含まれる内容の要旨
™ BEL AIR INSTALLATION INSTRUCTIONS Unpacking: Before assembling and installing your ceiling fan, remove all parts from the shipping cartons and check them against the parts listed here. Before discarding packaging material, be certain that all parts have been removed. IMPORTANT! To avoid possible damage to the Halogen bulb holder the fan must be placed on the styrofoam packaging from the box. After removing the top cover from the upper half of the styrofoam, take the packaging from the box and
ページ6に含まれる内容の要旨
™ BEL AIR CROSSBAR MOUNTING BRACKET INSTALLATION Proceed with installation as follows: Step 1. Route the wires from the ceiling outlet box through the crossbar mounting bracket center hole. Attach the bracket, CEILING FAN with ground wire and ridges down, to the ceiling fixture out- APPROVED let box with the mounting hardware included with the outlet OUTLET BOX RIDGE box. SIDE Tighten the screws firmly by hand only, being careful not to DOWN bend the bracket by over tightening. CEILING WIRING CA
ページ7に含まれる内容の要旨
™ BEL AIR INSTALLING THE FAN BODY TOP COVER IMPORTANT! To avoid possible damage to the Halogen bulb holder the fan must be placed on the styrofoam packaging from the box. After removing the top cover from the upper half of TOP COVER the styrofoam, take the packaging from the box RETAINING and put it on the floor. Place the fan in the SCREWS recessed circle that the top cover was in. Step 3. Locate the three tabs on the top of the fan motor assembly. Remove the three top cover retaining screws
ページ8に含まれる内容の要旨
ページ9に含まれる内容の要旨
™ BEL AIR BLADE HOLDER HARDWARE BLADE SCREW FLAT WASHER (4 PER BLADE) (4 PER BLADE) CENTER STYLE BLADE HOLDER & BLADE BLADE SCREW Step 12. Blade Installation (4 PER BLADE) Attach the blades to the blade holders with four blade screws FLAT WASHER and four steel washers pro- (4 PER BLADE) vided for each blade. Hand tighten securely. INSTALLING THE HALOGEN BULB Step 13. Screw the 100 Watt Halogen bulb into the socket. Do not touch the glass bulb with your fingers–it is extremely important that the
ページ10に含まれる内容の要旨
R INTELITOUCH© INSTALLING THE W-32 WALL CONTROL The wall control installs in the same manner as an ordinary light switch, using an existing junction box and wiring. This controller is designed to signal the fan microcomputer as well as perform normal switching operations. For this reason the following precautions must be observed: 1. Use only the Casablanca W-32 wall control. 3. Do not use more than one fan per wall control. 2. Do not use any additional control with your Inteli-Touch 4. No othe
ページ11に含まれる内容の要旨
R INTELI•TOUCH OPERATION ' POWER The button is normally left in the on position. Always turn the power off during cleaning or servicing the fan and during thunderstorms. It is also used to exit or enter additional programs. POWER must be left on to retain a previously set fan speed or light level. INTELI•TOUCH OPERATION ' SPEED CONTROL There are six individual speed settings for the fan; each speed is indicated by an audible tone of increasing pitch. FAN CONTROL To select the desired fan speed:
ページ12に含まれる内容の要旨
R ® INTELI•TOUCH OPERATION ' LIGHT-MINDER PROGRAM The Light-Minder program automatically turns OFF the fan mounted lights after two hours. To enter the Light-Minder Program: 1. Turn the OFF for at least three seconds. 2. Turn the ON. 3. Immediately operate the buttons in the following sequence: + + + + + + 4. A series of tones indicates this command has been accepted. The fan and light will operate normally using the buttons to turn them on and off. But, if the lights are left on, they wil
ページ13に含まれる内容の要旨
R TROUBLESHOOTING Before Requesting Service: Please follow this troubleshooting guide before contacting your dealer for assistance. Caring for Finishes: For cleaning, a soft brush or lint-free cloth Never Lubricate this Fan! should be used to prevent scratching the finish. A vacuum cleaner The precision motor at the heart of your Casablanca fan features brush nozzle can remove heavier dust. Surface smudges or an accu- sealed bearings that are lubricated for life. Do not attempt to oil mulation o
ページ14に含まれる内容の要旨
R COMFORT•TOUCH ' W-21 MOUNTING PARTS WALL BRACKET ANCHOR (4) ‘AAA’ ALKALINE WALL BRACKET BATTERY (3) REMOTE CONTROL REMOTE CONTROL SCREW (4) W-21 WALL BRACKET COMFORT•TOUCH ' W-21 WALL BRACKET INSTALLATION Installation of Remote Control Mount control in convenient location The wall mounting bracket for the remote control should be WALL located in a position that is approximately eye level. Secure 1 MOUNTING the wall mounting bracket with the 1 /4" screws or anchors BRACKET provided, making sure
ページ15に含まれる内容の要旨
R COMFORT•TOUCH ' IMPORTANT OPERATING NOTES Turning On Your Fan Labeling The fan will not receive any signals for the first 20 sec- If you have more than one onds after power on. This allows the electronics to warm up Comfort•Touch fan in your home, we and stabilize. suggest you put an adhesive room Power Failure identification label on the back of The remote control is not affected by household power fail- the control. Labels are in the remote SPACE FOR LABEL ure as it is battery operated. Once
ページ16に含まれる内容の要旨
ページ17に含まれる内容の要旨
ページ18に含まれる内容の要旨
R TROUBLESHOOTING Before Requesting Service: Please follow this troubleshooting guide before contacting your dealer for assistance. Caring for Finishes: For cleaning, a soft brush or lint-free cloth Never Lubricate this Fan! should be used to prevent scratching the finish. A vacuum cleaner The precision motor at the heart of your Casablanca fan features brush nozzle can remove heavier dust. Surface smudges or an accu- sealed bearings that are lubricated for life. Do not attempt to oil mulation o
ページ19に含まれる内容の要旨
761 CORPORATE CENTER DRIVE • POMONA, CA 91768 TOLL FREE: 888-227-2178 www.CasablancaFanCo.com ©COPYRIGHT 1999 CASABLANCA FAN COMPANY • U.S. PATENT PENDING
