ページ1に含まれる内容の要旨
Home Automation, Inc.
Model 70A00-1
GSM Cellular Communications Center
Operation Manual
Document Number 70I00-1 Rev A
August, 2009
ページ2に含まれる内容の要旨
ページ3に含まれる内容の要旨
Contents Description......................................................................... 1 Use with security systems… ........................................................1 Everyday use…............................................................................2 Contents of Box............................................................................3 SIM Card......................................................................................3 Installation.................
ページ4に含まれる内容の要旨
Important Safety Instructions: 1. Read all safety and operating instructions before using. 2. This product should not be used near water. 3. Only use dry cloth to clean this product. 4. Do not block any ventilation openings. 5. Do not install this product near any heat sources; such as, radiators, heat registers, stoves, or other appliances (including heat producing amplifiers) that produce heat. 6. Only use attachments specified by the manufacturer. 7. Unplug this apparatus during
ページ5に含まれる内容の要旨
Description The C3 Cellular Communications Center is a wireless cellular communicator that allows phone calls to be made over the GSM cellular network using the existing telephones in your home. The C3 can be used when there is no landline in your home or the landline is temporarily unavailable. Use with security systems… The C3 allows any existing security panel to communicate alarm conditions using the GSM cellular network. The C3 checks the status of the existing PSTN telephon
ページ6に含まれる内容の要旨
Everyday use… When the C3 is connected to the GSM cellular network, attached telephones can be used to make calls. If a landline is present, you will hear the normal dial tone and you can make your call as normal using the landline service. However, if the landline is currently unavailable, you will hear a different tone which indicates the C3 is in cellular mode and the call will be made using the cellular network. If the landline is available, but you still want to make the call us
ページ7に含まれる内容の要旨
Contents of Box GSM Antenna Telephone Cable GSM Wireless Receiver Platform OPERATION MANUAL Operation Manual Backup Battery Pack Plug-in AC Adapter C3 Cellular Communications Center SIM Card A GSM (Global System for Mobile communications) SIM card (Subscriber Identity Module) is required for operation. The SIM card contains subscriber information about your cellular service including the telephone number. Typically, an additional l
ページ8に含まれる内容の要旨
Installation ⑤ PSTN Jack ② Power Switch ④ Phone Jack ① Antenna Jack ③ Power Jack ① Antenna Jack (SMA): Connects the supplied antenna ② Power Switch: Turns the unit On or Off ③ Power Jack: Connects the 12V Power Adapter ④ Phone Jack: Connects to house telephones or alarm panel ⑤ PSTN Jack: Connects to PSTN telephone line Install the Antenna 1) Screw the antenna onto the antenna base. 2) Attach the SMA connector of the base to the C3 Antenna Jack. 3) Locate the
ページ9に含まれる内容の要旨
Installing or Replacing the Battery 1) If applicable, remove the battery compartment door screw located on the battery door tab. 2) Open the battery compartment by pressing down on the battery door tab and removing the battery compartment door. 3) If applicable, remove the battery pack by disconnecting the battery cable from the battery connector. 4) Install the battery pack by connecting the battery cable to the connector on the inside of the battery compartment. 5) Reinstall the bat
ページ10に含まれる内容の要旨
Installing the SIM Card Caution: The C3 must be switched off before installing or removing the SIM card. Do not install or remove the SIM card when the power is on; otherwise the SIM card may be damaged. The GSM network cannot be used if the SIM card is damaged. 1) If applicable, remove the SIM card compartment door screw located on the SIM card door tab. 2) Open the SIM card compartment by pressing down on the SIM card door tab and removing the SIM card compartment door. 3) Open
ページ11に含まれる内容の要旨
Connecting Telephones Connect analog telephone(s) to the modular jack labeled “PHONE” on the C3 unit. If a PSTN landline isn’t present, the GSM network can be used as the primary telephone service. RJ11 HOUSE PHONE JACK(S) TO ALL HOUSE TELEPHONES Primary GSM service without a security system TO SECURITY PANEL RED(-) GREEN(+) RED(-) GREEN(+) RJ11 HOUSE PHONE JACK(S) Primary GSM service with a security system 7
ページ12に含まれる内容の要旨
Connecting a PSTN Landline Connect the incoming PSTN landline to the modular jack labeled “PSTN” on the C3 unit. If a PSTN landline is present, the GSM network is used to backup the PSTN telephone service. If the landline service is unavailable, the GSM network will be used. TELEPHONE NETWORK INTERFACE CUSTOMER ACCESS SURGE ARRESTOR SURGE ARRESTOR MUST BE GROUNDED! RJ11 HOUSE PHONE TO TELCO JACK(S) INTERFACE AT SURGE ARRESTOR TO ALL HOUSE TELEPHONES Backup GSM service without a secu
ページ13に含まれる内容の要旨
Operation Turn on the unit by moving the Power Switch to the “On” position. When the unit is first switched on, the C3 unit searches for a network before calls can be made. Power Indicator Signal Strength Network Indicators In Use Indicator Indicator When the unit is turned on, the Power Indicator will illuminate and the Network Indicator will flash quickly while the C3 searches for a network. When a network is found, the Network Indicat
ページ14に含まれる内容の要旨
Making Calls To make a phone call, simply pick up a connected telephone and listen for a dial tone. Whenever a connected phone is taken off-hook, the In Use Indicator is illuminated. If a PSTN landline is connected, you will hear the normal dial tone. Simply make your call as normal. If the landline is temporarily unavailable, the C3 will automatically switch to GSM mode. If a PSTN landline is not present or is temporarily unavailable, the GSM network will be used. You will he
ページ15に含まれる内容の要旨
Receiving Calls When a call is made to either the landline phone number or the cellular number assigned to the SIM card, the connected phones will ring as normal. Simply pick up a handset to answer the call. Ending Calls While on a call using either the landline or the GSM network, to disconnect the call, simply hang up the handset. Troubleshooting Symptom Problem Always hear busy SIM card in not installed or the SIM card signal when the is not making a proper connectio
ページ16に含まれる内容の要旨
Specifications Operating Temperature: -10°C - +40°C Noise: not to exceed 60dB (A) Humidity: 5% - 95% relative humidity, non-condensing Atmosphere Pressure: 86 - 106KPa Input Voltage: 100 – 240VAC Operating Power: DC 12V, 1500mA Frequency: GSM/GPRS 850/ 900/1800/1900MHz Power Output: --Class 4 (2W @ 850/900MHz) --Class 2 (1W @1800/1900MHz) Channel Interval: 200 KHz Receive Sensitivity: -100dBm Frequency Error: ≤0.1ppm Dimensions: 8.625” x 5.5” x 1.5” Preventing Malfunction
ページ17に含まれる内容の要旨
Federal Communication Commission Notice: This equipment complies with Part 68 of the FCC rules. Located on the equipment is a label that contains, among other information, the ACTA registration number and ringer equivalence number (REN). If requested, this information must be provided to the telephone company. The REN is used to determine the quantity of devices which may be connected to the telephone line. Excessive REN’s on the telephone line may result in the devices not ringin
ページ18に含まれる内容の要旨
If trouble is experienced with this equipment, please contact: Home Automation, Inc. 4330 Michoud Blvd. New Orleans, LA 70129, USA Phone: 504-736-9810 Fax: 504-253-2957 If trouble is causing harm to the telephone network, the telephone company may request you to remove the equipment from the network until the problem is resolved. This equipment uses the following USOC jacks: RJ11C It is recommended that the customer install an AC surge arrester in the AC outlet to which this d
ページ19に含まれる内容の要旨
IMPORTANT NOTE: FCC Radiation Exposure Statement: This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 50cm between the radiator and your body. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, purs
ページ20に含まれる内容の要旨
