American Water Heater DCGの取扱説明書

デバイスAmerican Water Heater DCGの取扱説明書

デバイス: American Water Heater DCG
カテゴリ: 給湯器
メーカー: American Water Heater
サイズ: 3.11 MB
追加した日付: 11/23/2014
ページ数: 26
説明書を印刷

ダウンロード

使い方は?

私たちの目的は、皆様方にデバイスAmerican Water Heater DCGの取扱説明書に含まれたコンテンツを可能な限り早く提供することです。オンラインプレビューを使用すると、American Water Heater DCGに関してあなたが抱えている問題に対する解決策の内容が素早く表示されます。

便宜上

説明書American Water Heater DCGをこちらのサイトで閲覧するのに不都合がある場合は、2つの解決策があります:

  • フルスクリーン表示 – 説明書を(お使いのコンピュータにダウンロードすることなく)便利に表示させるには、フルスクリーン表示モードをご使用ください。説明書American Water Heater DCGのフルスクリーン表示を起動するには、全画面表示ボタンを押してください。
  • コンピュータにダウンロード - American Water Heater DCGの説明書をお使いのコンピュータにダウンロードし、ご自身のコレクションに加えることもできます。デバイス上のスペースを無駄にしたくない場合は、いつでもManualsBaseサイトでダウンロードすることもできます。
American Water Heater DCG 取扱説明書 - Online PDF
Advertisement
« Page 1 of 26 »
Advertisement
印刷版

多くの人々は画面表示ではなく印刷された説明書を読むほうを好みます。説明書を印刷するオプションも提供されており、上記のリンクをクリックすることによりそれを利用できます - 説明書を印刷。説明書American Water Heater DCGを全部印刷する必要はなく、選択したページだけを印刷できます。紙を節約しましょう。

要旨

次のページにある説明書American Water Heater DCGの内容のプレビューは、以下にあります。次のページにある説明書の内容をすぐに表示したい場合は、こちらをご利用ください。

内容要旨
ページ1に含まれる内容の要旨

Commercial Gas
Water Heater
Installation
Instructions and
Use & Care Guide
for models with prefix DCG and ADCG
To obtain technical, warranty or service assistance during
or after the installation of this water heater, call toll free:
1-800-456-9805
When calling for assistance, please have the following
information ready:
1. Model number
2. 7 digit product number
3. Serial number
4. Date of installation
5. Place of purchase
Table of Contents . . . . . . . . . . . . . . . . . . . . . . . . . . 2

ページ2に含まれる内容の要旨

what can happen if the instructions are not followed. Table of Contents Water Heater Safety . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-2 Installation Instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-5 Unpacking the Water Heater . . . . . . . . . . . . . . . . . . . . . . 3 Installation Requirements . . . . . . . . . . . . . . . . . . . . . . . ..4 Site Location . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Clea

ページ3に含まれる内容の要旨

INSTALLATION INSTRUCTIONS Massachusetts code requires this water heater to be Consumer Information installed in accordance with Massachusetts Plumbing This water heater is design-certified by CSA and Fuel Gas Code 248 CMR Sections 2.00 and 5.00. International as a Category I, non-direct vented water heater which takes its combustion air either from the A data plate identifying this water heater can be found installation area or from air ducted to the unit from the on the front of the water heate

ページ4に含まれる内容の要旨

Site Location • Select a location near the center of the water piping system. The water heater must be installed indoors and in a vertical position on a level surface. DO NOT install in bathrooms, bedrooms, or any occupied room normally kept closed. • Locate the water heater as close to the gas vent as practical. Consider the vent system piping and combustion air supply requirements when selecting the water heater location. The FLAMMABLES FLAMMABLE VAPORS venting system must be able to

ページ5に含まれる内容の要旨

Important: Figure1: Minimum Clearance Locations The water heater should be located in an area where leakage of the tank or connections will not result in dam- age to the area adjacent to the water heater or to lower floors of the structure. Due to the normal corrosive Back Sides action of the water, the tank will eventually leak after an extended period of time. A suitable metal drain pan should be installed under the water heater as shown below, to help protect the property from damage which

ページ6に含まれる内容の要旨

COMBUSTION/VENT PIPE SYSTEM Important: Check to make sure the vent pipe is not blocked in any way. • Venting should be as direct as possible with a minimum number of pipe fittings. Carbon Monoxide Hazard • Exhaust gas vents must be installed with U.L. Follow all instructions to locate and install listed type B vent pipe according to the vent the vent pipe system. manufacturer’s instructions and the terms of its listing. Instructions can be found in this manual, • Single wall vent connectors

ページ7に含まれる内容の要旨

For buildings that are not well sealed (do not have tight Air Requirements fitting doors and windows) natural air infiltration may provide sufficient air required for combustion and venti- lation. For buildings using tight construction (newer and renovated structures), the air supply shall be introduced An adequate air supply shall be provided from the outdoors, regardless of whether the space is for combustion and ventilation of this confined or unconfined. water heater. An insufficient supply

ページ8に含まれる内容の要旨

Air Opening Requirements Figure: 2 Equipment Location and Combustion/Ventilation Air (a) EQUIPMENT LOCATED IN CONFINED SPACES; ALL AIR FROM Requirements INSIDE THE BUILDING. Two permanent openings (top and bottom) shall be provided connecting the confined space (e.g., closet/small room) with the unconfined space. Each opening shall have a free area of one square inch per 1,000 BTU/hour (22 cm²/kW) input of all appliances in the confined space, but not less than 100 square inches (645 cm²). b)

ページ9に含まれる内容の要旨

Draft Hood/Damper Installation Flue Outlet Reducer Some units are shipped with a flue outlet reducer (See Figure 3B). Use only the flue outlet reducer supplied with this unit. The flue outlet reducer should be Do not operate water heater with damper connected to the top of the flue damper and sealed by in closed position, it must be in the open high temperature silicon. The vent pipe must be installed according to all local position during water heater operation. and state codes or, in the abs

ページ10に含まれる内容の要旨

WATER SYSTEM PIPING Piping Installation Space Heating Piping, fittings, and valves should be installed according to If this unit is to be used to supply both space heating and the installation drawing (Figure 4). If the indoor installation domestic potable (drinking) water then the following area is subject to freezing temperatures, the water piping instructions must be followed: must be protected by insulation. 1. All piping and components used must be suitable Water supply pressure should n

ページ11に含まれる内容の要旨

Figure 6: Commercial Unit with Auxiliary Booster Heater - Two Temperature (With or Without Building Recirculation) Outlet Hot Water Boosted to Fixtures Temperature Thermometer Shut-off valve Shut-off valve Temperature and Thermometer Pressure Relief Valve Temperature and Pressure Relief Valve Check Valve Typical Pre-Heater Booster Heater Thermal Expansion Shut-off valve Tank 1 1/2” Cold Shut-off valve water supply Pre-Heated Water to the Booster Pressure Reducing Valve Note: Install a vacuum r

ページ12に含まれる内容の要旨

Figure 8: Commercial Unit with Auxiliary Storage Heater - Forced Circulation With or Without Building Recirculation - Top Inlet/Outlet Connections Thermal Outlet Expansion Boosted Pressure Tank Temperature Reducing Thermometer Hot Water Thermometer 1 1/2” Cold Valve to Fixtures Pre-Heated water supply Water to the Booster Shut-off valve Check valve Shut-off valve Temperature and Pressure Relief Valve Temperature and Pressure Relief Valve Typical Pre-Heater Booster Heater Note: Install a vacuum

ページ13に含まれる内容の要旨

must not exceed the working pressure of the water Temperature and Pressure heater as stated on the data plate. Important: Only a new temperature and pressure relief Relief Valve valve should be used with this water heater. Do not use an old or existing valve as it may be damaged or not adequate for the working pressure of the new water heater. Do not place any valve or piping between the relief valve and the tank. The Temperature & Pressure Relief Valve: • Must not be in contact with any electri

ページ14に含まれる内容の要旨

GAS SUPPLY AND PIPING how to turn off the gas to this unit. 2. Install a drip leg as shown. The drip leg must be no less than 3 inches (76mm) long for the accumula- tion of dirt,foreign material and water droplets. 3. Install a ground joint union between the water heater and the manual shut-off valve. This is to allow easy servicing. 4. Turn the gas supply on and check for leaks. Use a chloride-free soap and water solution (bubbles Explosion Hazard forming indicate a leak) or other approve

ページ15に含まれる内容の要旨

Gas Pressure Testing Important: This water heater and its gas connection must be leak tested before placing the appliance in operation. • If the code requires the gas lines to be tested at a pressure of 14” W.C. or greater, the water heater and its manual shut-off valve must be disconnected from the gas supply piping system and the line capped. Explosion Hazard • If the gas lines are to be tested at a pressure Have a qualified service technician make less than 14” W.C., the water heater mu

ページ16に含まれる内容の要旨

ELECTRICAL CONNECTIONS Electrical Installation 1. Shut off the power at the electrical service box. 2. Loosen the screws securing the access panel to the electrical compartment. (The electrical wiring diagram can be found on the inside of the access panel.) Set the access panel aside. 3. Connect the electrical supply to the water heater in accordance with local utility requirements and codes or, in the absence of local codes, with the National Electrical Code, ANSI/NFPA 70 and/or the C

ページ17に含まれる内容の要旨

WIRING DIAGRAM 17 17

ページ18に含まれる内容の要旨

INSTALLATION CHECKLIST Water Heater Location Requirements Vent Termination • Centrally located with the water piping system. Vertical Located as close to the gas piping and vent • Vertical gas vents must terminate with a listed pipe system as possible. cap or other roof assembly and be installed • Located indoors and in a vertical position. according to their manufacturer’s instructions. Protected from freezing temperatures. Water System Piping • Proper clearances from combustible surfaces

ページ19に含まれる内容の要旨

OPERATING YOUR WATER HEATER Read and understand these directions thoroughly Water Heater Operation before attempting to operate the water heater (see When the thermostat calls for heat, it will signal the Lighting Instructions on page 20). Check the data plate damper to open. Once the damper fully opens, it will on the front of the water heater for the correct gas. Do signal the igniter to light the pilot. The pilot will then not use this water heater with any gas other than the ignite the mai

ページ20に含まれる内容の要旨

OPERATING INSTRUCTIONS 7. Turn gas control knob counterclockwise to “ON”. 8. Set thermostat to desired setting. 1. STOP! Read the safety information above on this 9. Turn on all electric power to the label. appliance. 2. Turn off all electric power to the appliance. 3. Set the thermostat to the lowest setting. 4. This appliance is equipped with an ignition device which automatically lights the pilot. Do not try to light the pilot by hand. 5. Turn the gas control knob clockwise to


類似の説明書
# 取扱説明書 カテゴリ ダウンロード
1 American Water Heater 318281-000 取扱説明書 給湯器 25
2 American Water Heater 505 取扱説明書 給湯器 3
3 American Water Heater 701022 取扱説明書 給湯器 2
4 American Water Heater 186965-000 取扱説明書 給湯器 3
5 American Water Heater 319339-000 取扱説明書 給湯器 3
6 American Water Heater 6510319 取扱説明書 給湯器 2
7 American Water Heater 71681 取扱説明書 給湯器 2
8 American Water Heater 1010 319869-000 取扱説明書 給湯器 1
9 American Water Heater 316888-004 取扱説明書 給湯器 1
10 American Water Heater AGT-705-NI 取扱説明書 給湯器 0
11 American Water Heater Co.381T1206NOX 取扱説明書 給湯器 1
12 American Water Heater Co.395T1996NOX 取扱説明書 給湯器 0
13 American Water Heater Co.(A)BCG385T500-8N 取扱説明書 給湯器 1
14 American Water Heater AGT-705-PI 取扱説明書 給湯器 0
15 American Water Heater Co.395T1806NOX 取扱説明書 給湯器 1
16 A.O. Smith 000 取扱説明書 給湯器 8
17 A.O. Smith 101 取扱説明書 給湯器 3
18 A.O. Smith 12 40GPC T 100 取扱説明書 給湯器 4
19 A.O. Smith 104 Series 取扱説明書 給湯器 3
20 A.O. Smith 104 - 110 取扱説明書 給湯器 6