Ingersoll-Rand EXTRUSION PUMP NP623XXXXR8-XXの取扱説明書

ページ1に含まれる内容の要旨

OPERATOR’S MANUAL NP623XXXXR8-XX
RELEASED: 12-10-08
INCLUDING: OPERATION, INSTALLATION AND MAINTENANCE.
REVISED:
INCLUDE MANUALS: 650691-XXX-B Extrusion Pump (97999-832), 66731-X Follower Plate (pn 97999-213),
(REV. 01)
67342-X Follower Assembly (pn 97999-1099), 67347-X Follower Assembly (pn 97999-1102), RM052S-X Two
Post Lift / Ram (pn 97999-1345), & S-636 General Information (pn 97999-636).
6” AIR MOTOR
NP623XXXXR8-XX
23:1 RATIO
EXTRUSION SYSTEM
6” STROKE
For use with 5 gallon / 20 liter dr

ページ2に含まれる内容の要旨

INSTALLATION The NP623XXXXR8-XX Extrusion System comes completely assem- als can be pumped directly from their original drum without air bled. Remove the unit from the crate and place on a level surface. inclusion or excessive waste. The follower plate creates an air tight Install the material hose and dispensing device as required. seal as well as clean-wiping action in its progressive downward When the following instructions are observed, heavy paste materi- movement into the drum. OPERATIN

ページ3に含まれる内容の要旨

PARTS LIST / NP623XXXXR8-XX (size) (size) Item Description Qty Part No. Item Description Qty Part No. 1 Pump Assembly 650691-XX3-B 7 Bolt (7/8” - 14 x 4-1/2”) 97153 (1) (2) 2 Male Elbow (1/2 - 14 NPT x 1/2” o.d. tube) 59756-362 (7/8”) (1) 8 Lock Washer (2) Y14-875 (included with item 3) (3/8" - 16) 9 Nut (4) Y12-6-C 3 Two Post Lift / Ram (1) RM052S-C 10 Mounting Plate 96737 (1) 4 Follower Assembly (see "Model Description (1) (7/8” - 14) Chart", page 1) 11 Nut (2) Y11-14-C (3/8”) 5 Lock Washer (

ページ4に含まれる内容の要旨

DIMENSIONAL DATA 55-21/32” 73-1/2” (1413.6 mm) (1866.8 mm) 21-27/32” 18-3/16” (554.8 mm) (461.9 mm) Figure 4 PN 97999-1406 Page 4 of 4 NP623XXXXR8-XX (en)