ページ1に含まれる内容の要旨
W32CO Mantel and Base
ASSEMBLY AND INSTALLATION INSTRUCTIONS
Important: Read entire instruction sheet before Tools required:
assembling or installing mantel kit.
• Power Screwdriver with #2 Phillips Bit
If any wood pieces are missing or damaged, contact the
These mantels are only approved for use with any
dealer where you purchased this mantel for replacement. If
DESA Heating, LLC 32" electric and gas fireplace sys -
hardware is missing or damaged, contact DESA Heating, LLC
tem. Do not use
ページ2に含まれる内容の要旨
AssemblING mANTel Important : more than one person is required to lift assembled mantel. l ift mantel by leg assemblies. l ifting by header or mantel top could damage mantel. Use the following illustrations to assemble mantel. Use only screws provided. Header #4 Right Leg Assembly #2 Right Leg Left Leg Assembly #2 Assembly #3 1 1 / " 4 Screws Header into Groove on Legs Header Assembly Block 1 1 / " 4 Screws Base #1 Left Leg Flush Assembly #3 Figure 3 - Installing mantel Base IMPOR
ページ3に含まれる内容の要旨
6. Fireplace with louver door: Lower bottom louver door. electric Fireplace Installation Use two screws provided in hardware package and attach This mantel can be used with DESA Heating, LLC electric fireplace to wooden base. Close louver door. fireplaces. Electric fireplaces install from the front of mantel. Fireplace with fixed louver: Before installing logs or To install electric fireplace see fireplace instruction manual. burner assembly (see owner’s manual) remove screws securing fl
ページ4に含まれる内容の要旨
DESA Heating, LLC 2701 Industrial Drive Bowling Green, KY 42101 www.desatech.com 1-866-672-6040 123677-01 Rev. A 123677 01 04/08 NOT A UPC
