ページ1に含まれる内容の要旨
PRE-ASSEMBLED
INSTALLATION INSTRUCTIONS
EARTHSTONE OVENS-6717 SAN FERNANDO RD GLENDALE CA 91201
TELEPHONE: 800-840-4915 818-553-1134 FAX: 818-553-1133
www.earthstoneovens.com e-mail: earthstone@earthlink.net
A MAJOR CAUSE OF OVEN RELATED FIRES IS FAILURE TO MAINTAIN
REQUIRED CLEARANCES (AIR SPACES) TO COMBUSTIBLE MATERIALS. IT IS
OF UTMOST IMPORTANCE THAT THIS OVEN BE INSTALLED ONLY IN
ACCORDANCE WITH THESE INSTRUCTIONS
12/4/2002
ページ2に含まれる内容の要旨
EARTHSTONE WOOD FIRE OVENS 6717 SAN FERNANDO RD, GLENDALE CA 91201 earthstone@earthlink.net www.earthstoneovens.com Pre-Assembled installation instructions. Table of contents Page Instructions for moving and lifting oven Parts list 1 Installation procedures written portion 2-5 Required clearances and air gaps 6 Exhausting 4-10 Operating instructions 11-12 Maintenance instructions 12-13 Type I Exhaust Hood Diagram 14 Clearance Informat
ページ3に含まれる内容の要旨
INSTRUCTIONS FOR LIFTING AND MOVING OVEN ATTENTION: Only proper heavy lifting 3- INSTALLING OVEN machinery and handling equipment should be used for unloading, moving and installing the Slowly lower oven into proper location. Oven oven. This duty should be performed by should be set on a level floor. Shim as professionals trained in this kind of work. necessary to assure that oven is level. Remove Improper handling of the equipment could result horizontal front angle
ページ4に含まれる内容の要旨
EARTHSTONE OVENS PRE-ASSEMBLED INSTALLATION INSTRUCTIONS---U.L. LISTED 1 LIST OF SUPPLIED ITEMS OVEN ADDITIONAL ITEMS METAL DOOR DIGITAL THERMOMETER (REQUIRES 120V AC OUTLET) 120 V AC, 60 HZ, 1 AMP POWER SUPPLY (SUPPLIED) TRAINING VIDEO
ページ5に含まれる内容の要旨
EARTHSTONE OVENS PRE-ASSEMBLED INSTALLATION INSTRUCTIONS---U.L. LISTED 2 PRE-ASSEMBLED INSTALLATION INSTRUCTION GUIDE READ ALL INSTRUCTIONS CAREFULLY BEFORE INSTALLING AND USING THE APPLIANCE. If this oven is not properly installed, a fire may result. To reduce the risk of fire, follow the installation instructions. Please read this entire manual before you install the oven. Failure to follow instructions may result in property damage, bodily injur
ページ6に含まれる内容の要旨
EARTHSTONE OVENS PRE-ASSEMBLED INSTALLATION INSTRUCTIONS---U.L. LISTED 3 INSTALLATION. OPERATING AND MAINTENANCE PREFACE Refer to pages 9, 10 and 11 for complete instructions. 1) On daily basis, and after the oven temperature is at least 500 at F: (a) Ashes are to be removed by a metal ash scoop/shovel or by a suitable fire-safe vacuum cleaner with long metal wand extensions provided by the user.; (b) the oven interior is then to be mopped down
ページ7に含まれる内容の要旨
EARTHSTONE OVENS PRE-ASSEMBLED INSTALLATION INSTRUCTIONS---U.L. LISTED 4 A. INSTALLATION PROCEDURES 1. Mark an outline on the floor of the location desired. This is to assure that you have adequate space. Refer to Fig. 1, pg. 6. 2. Check that there is adequate clearance at the ceiling for the hood. There must be a minimum of 3 inches of clearance between the top of the hood and/or oven and the surface of the drywall above. A height of 105 inc
ページ8に含まれる内容の要旨
EARTHSTONE OVENS PRE-ASSEMBLED INSTALLATION INSTRUCTIONS---U.L. LISTED 5 I TYPE-I EXHAUST HOOD-Installed per NFPA 96, standard for ventilation control and fire protection of commercial cooking operations. (For commercial applications only) 1. If required, a Type 1 hood must be placed above the cooking opening and set on the top of the oven. The minimum exhaust hood dimensions are 36 in. wide 37 in. deep, 22in. high for models 90 and 110, and 40 in. w
ページ9に含まれる内容の要旨
EARTHSTONE OVENS PRE-ASSEMBLED INSTALLATION INSTRUCTIONS---U.L. LISTED 6 ALL CLEARANCES SPECIFIED ARE THE MINIMUM REQUIRED AIR SPACES COMBUSTIBLES 3"MIN. HOOD 3"MIN. 105" 80" OUTSIDE DIAMETER FOR COMMERCIAL USE ONLY MODEL 60 - 33” X 32” Figure 2 MODEL 90 - 50", MODEL 110 - 58" U.M.C. & N.F.P.A. MODEL 130 - 70”, MODEL 160 - 86" Figure 1 3"MIN. COMBUSTIBLES 1"MIN. 1" MIN. HOOD COMBUSTIBLES FEED 1"MIN. OPENING 48" 48" MIN. MIN. 1" MIN. An
ページ10に含まれる内容の要旨
EARTHSTONE OVENS PRE-ASSEMBLED INSTALLATION INSTRUCTIONS---U.L. LISTED 7 GREASE HOOD MODELS 130 AND 160 MODELS 90 AND 110 7” 7” 7” 7” FIGURE 16
ページ11に含まれる内容の要旨
EARTHSTONE OVENS PRE-ASSEMBLED INSTALLATION INSTRUCTIONS---U.L. LISTED 8 ALL MODELS 22" 10” 37” OVERALL EXHAUST HOOD DIMENSIONS ARE MINIMUMS. SECTION FIGURE 17 Oven stand Base plate Ramset red heads (typ.) Embed 2 1/2” min. 4” to 6” conc. Floor slab FIGURE 17-A
ページ12に含まれる内容の要旨
EARTHSTONE OVENS PRE-ASSEMBLED INSTALLATION INSTRUCTIONS---U.L. LISTED 9 DIRECT VENTING FOR ORDERING PARTS MENTIONED ON THIS PAGE CONTACT EARTHSTONE OR YOUR SUPPLIER. Tel: 800-840-4915- 818-553-1134 MODELS 90 & 110 USE 6 INCH INSIDE DIAMETER GREASE DUCT MODELS 130 & 160 USE 8 INCH INSIDE DIAMETER GREASE DUCT 30” min. FIGURE 18 GREASE DUCT HEATING APPLIANCE CHIMNEY ATTACHED TO PRIMARY HOOD THIS DIAGRAM GENERALLY DEPICTS THE INSTALLATION REQUIRED TO MAINTAI
ページ13に含まれる内容の要旨
EARTHSTONE OVENS PRE-ASSEMBLED INSTALLATION INSTRUCTIONS---U.L. LISTED 10 RESIDENTIAL DIRECT VENTING FOR ORDERING PARTS MENTIONED ON THIS PAGE CONTACT EARTHSTONE 800-840-4915 OR YOUR SUPPLIER. MODELS 60 & 90 & 110 USE 6 INCH INSIDE DIAMETER GREASE DUCT/BUILDING HEATING APPLIANCE CHIMNEY CHIMNEY ROUND TOP (P-CT) STORM COLLAR (SC-C1) FLASHING ROOF BRACE KIT (RBK) IF REQUIRED FIGURE 18 GREASE DUCT HEATING APPLIANCE CHIMNEY ATTACHED TO PRIMARY HOOD THIS DIAGRA
ページ14に含まれる内容の要旨
EARTHSTONE OVENS PRE-ASSEMBLED INSTALLATION INSTRUCTIONS---U.L. LISTED 11 WOOD-FIRED PIZZA OVEN OPERATING INSTRUCTIONS WARNING: READ ALL INSTRUCTIONS CAREFULLY. IMPROPER USE OF THIS APPLIANCE MAY RESULT IN A BUILDING FIRE OR PERSONAL INJURY. INSTRUCTIONS MUST BE READ AND THOROUGHLY UNDERSTOOD BY ALL OPERATING AND SUPERVISING PERSONNEL. WATCH TRAINING VIDEO FOR VISUAL OPERATION INSTRUCTIONS. THIS OVEN IS INTENDED FOR ATTENDED OPERATION BY TRAINED
ページ15に含まれる内容の要旨
EARTHSTONE OVENS PRE-ASSEMBLED INSTALLATION INSTRUCTIONS---U.L. LISTED 12 8. a- Before starting, turn "ON" exhaust fan and make-up air blowers. b- Place a small amount of wood and kindling on the hearth over a fire-starter block. Light fire- starter. At any time do not use more than four pieces of wood, c- CAUTION: NEVER USE GASOLINE TYPE LANTERN FUEL, KEROSENE, CHARCOAL LIGHTER FLUID OR SIMILAR PRODUCTS TO START OR "FRESHEN UP" A FIRE
ページ16に含まれる内容の要旨
EARTHSTONE OVENS PRE-ASSEMBLED INSTALLATION INSTRUCTIONS---U.L. LISTED 13 3. Store wood in a cool, dry place well away from any source of flame or heat. If stored outside, keep the fuel covered to protect from rain or snow. If stored inside, fuel should be kept in a covered metal container at least 6 inches above the floor. Keep paper, rags and other easily ignited materials away from wood fuel. Refer to NFPA 96 for wood storage procedures. 4.
ページ17に含まれる内容の要旨
EARTHSTONE OVENS PRE-ASSEMBLED INSTALLATION INSTRUCTIONS---U.L. LISTED 14 Type-I Exhaust Hood Installed per NFPA 96 **IT IS NEVER APPROPRIATE TO USE “CLASS A” OR For Models 90 and 110 “B VENT” IN ANY PART OF THE EXHAUST SYSTEM 36” MIN EXHAUST SYSTEMS SERVING SOLID-FUEL For Models 130 and 160 EQUIPMENT MAY NOT BE COMBINED WITH 40” MIN EXHAUST SYSTEMS SERVING OTHER (NON-SOLID FUEL) COOKING EQUIPMENT Grease filters must be placed at the rear of the hood 22” and
ページ18に含まれる内容の要旨
EARTHSTONE OVENS PRE-ASSEMBLED INSTALLATION INSTRUCTIONS---U.L. LISTED 15 CLEARANCE INFORMATION FOR FACADES 1 inch minimum clearance to combustibles Facade Flue Collar Models 90 and 110 - 6 inch diameter Models 130 and 160 - 8 inch diameter Air gap must be sealed with a non combustible strip. e.g. Aluminum or s/s Any adjacent combustible floor which projects 36” in front of the oven opening must be a minimum of 30 inches away from each side of the door
ページ19に含まれる内容の要旨
EARTHSTONE OVENS PRE-ASSEMBLED INSTALLATION INSTRUCTIONS---U.L. LISTED 16 IMPORTANT: PLEASE READ FOR GAS FIRE OR GAS/WOOD COMBINATION OVENS ONLY Combustion air intake procedures and installation Proper installation: Roof Roof Air flow Air flow Air flow Air flow False Ceiling False Ceiling 24”x24” opening needed for 24”x24” opening needed combustion air. Only one intake should be installed located in the for combustion air. Only front or back of
ページ20に含まれる内容の要旨
EARTHSTONE OVENS PRE-ASSEMBLED INSTALLATION INSTRUCTIONS---U.L. LISTED 17 Improper Installation (cont) 2) Oven is not closed to plenum/attic and is open to HVAC airflow. Roof Air flow Air flow Ceiling Installing a sealed enclosure around the oven shell may cause improper operation by starving the burner system of combustion air. The air flow which travels above will cause “negative pressure” below where the gas burner is located. The air underneat
