ページ1に含まれる内容の要旨
Stadium-Seating Tandem Stroller
Owner’s Manual
(Model 01-068/668)
Read all instructions BEFORE assembly and www.djgusa.com
4358-4206 12.17.02
USE of this stroller.
KEEP INSTRUCTIONS FOR FUTURE USE.
If you are missing parts or have any questions
about this stroller, contact us first!
Contact our Consumer Relations Department at
www.djgusa.com and click on “contact us”,
or FAX 24 hours a day at 1-800-207-8182,
or call 1-800-544-1108 Mon. thru Thur. 7 a.m. to
6 p.m. and Fri. 7 a.m. to 4:30 p.m.
ページ2に含まれる内容の要旨
WARNINGS ! WARNING: Never leave child unattended. Always keep child in view when in stroller. Please read the following and keep for future reference: ! WARNINGS: Avoid serious injury from falling or sliding out. Always use DO NOT: seat belt. Check frequently to make sure it is secure. – use stroller on stairs or escalators. This stroller is for use by one (1) child in each seating – allow children to play with or hang onto the stroller. area only. – allow children to climb into the stroller una
ページ3に含まれる内容の要旨
Parts List NOTE: Please check that you have all the parts shown BEFORE assembling your Stroller. Parts List: A. Frame H. Rear Canopy B. 2 Single Rear Wheels I. Parent Tray C. 4 Washers (Hardware Bag) J. Rear Child Tray D. 2 Cotter Pins (Hardware Bag) K. Front Canopy E. 2 Rear Hub Caps L. Front Child Tray F. 1 Rear Axle M.Front Seat G. 2 Dual Front Wheels K I J H L M F D A C C G B E 3
ページ4に含まれる内容の要旨
Assembly Instructions 1 To Unfold: Place stroller frame on end as shown. Grasp handle, pull back and up View of unfolded stroller. sharply until frame opens and locks with a click. 2 To Install Rear Wheels: Remove protective packing from axle ends and discard. Remove Cotter pins and washers from axle and set aside. 1 washer Slide 1 washer onto axle so washer cotter is against the brake. Put one of the pin single wheels onto axle with hub to the inside. Slide on another washer. Insert straight si
ページ5に含まれる内容の要旨
4 To Install Front Seat: Face seat forward and align sockets To attach seat in rear-facing position, Rotate seat 180 degrees, align sock- on seat with brackets on frame. Push press red buttons on sides of seat to ets with brackets and push down down until seat locks with a click. release locks, lift seat off brackets. until seat locks with a click. 5 To Install Canopies: pin Front Canopy: Align canopy tabs with Rear Canopy: The rear canopy comes Snap canopy hinge brackets onto frame sockets in s
ページ6に含まれる内容の要旨
7 To Install Trays: (continued) Front seat Tray: Align tubes on tray Rear seat Tray: Slide tabs on tray brack- To remove, grasp tray as shown, press ends with holes on both sides of ets into slots on rear seat “armrests” tabs with thumbs to release locks, pull seat. Push in until tray locks with a as shown. Push down until tray locks up and out. snap. To remove, push both red but- with a snap. tons next to tray, pull out. To Use 8 Using Restraint System: Adjusting Harness Straps: To adjust shoul
ページ7に含まれる内容の要旨
9 To Recline Seat Backs: release bar Front Seat: Squeeze release bar on Rear Seat: To lower seat back, squeeze To raise seat back, squeeze har- back of seat as shown, tilt seat back to harness release on back of seat ness release and push release up recline position. To return to upright, pulling release back while moving towards seat back while moving squeeze release bar, pull to upright. seat back to the desired position. seat to the desired position. 10 To Use Rear Seat as carriage: seat side
ページ8に含まれる内容の要旨
11 To Use Front Footrest: 12 To Use Rear Brakes: Red Button To raise footrest, lift up until you hear To lock brake: With stroller stopped, To unlock brake, lift up levers with a “click.” To lower, press in on red press down on both rear brake toe. button, lift slightly and lower footrest. levers with foot. 13 To Use Swivel Locks: With front wheels straight, press To unlock, pull levers up. down on front wheel levers between each set of wheels to lock. 8
ページ9に含まれる内容の要旨
14 To Attach Car Seats: ® ® ® If you have an Eddie Bauer , Cosco or Safety 1st 02-600 or 22-600 series infant car seat(s), the following instructions explain how to attach the car seat(s) to the stroller. Complete instructions for using the car seats are located on the back of the car seat. Rear seat: Remove mounting bar Place mounting bar into the two With back of stroller seat in the re- from between frame beneath front holes on the inside of stroller arms. clined position, pull up on the 1-h
ページ10に含まれる内容の要旨
16 To Fold: Fold rear canopy back to handle. Grip red release handle, slide to left and Weight of stroller front will cause frame With brakes on, push down on han- squeeze to release frame lock. to fold. dle to raise front wheels as shown. Rear seat side boards must be Front wheels may need to be rotated Attach lock strap on frame side. unsnapped from frame and folded in 180˚ to make latching frame easier. when folding stroller. 17 To Remove Pads for Washing: Unsnap buckle and feed buckle and Un
ページ11に含まれる内容の要旨
18 To Replace Pads after Washing: Set pad in stroller as originally posi- Thread shoulder straps and Re-thread shoulder straps through tioned. Feed crotch strap and buckle adjusters through seat back pad. Re- strap adjusters and adjust as per page through hole in seat pad. attach pad to seat with attachment 6. Re-installation is complete. strips. One Year Limited Warranty Dorel Juvenile Group, Inc. (DJG) warrants this product to the original retail purchaser as follows: This product is warranted
ページ12に含まれる内容の要旨
Replacement Parts Order Form Complete the form below. Your model number with color code and manufacturer date code MUST be included on the form to ensure proper replacement parts. Your model number with color code and the date code can be found on a sticker on the stroller frame. Payment in U.S. dollars must accompany your order. Choose parts needed from the list below. You can cross reference your parts with the illustration on pages 2 and 3. Return the form with payment to: Please make money o
