ページ15に含まれる内容の要旨
600 550 min Building the appliance in under a UPPER LOWER SUPER. INFER. worktop The dimensions of the recessed installation area E must correspond with those indicated in the figure. E D319 2. Fasten the appliance to the worktop or the sides, a applying the sealing strip between the refrigerator and adjacent cabinet using the fixing brackets (E). b S.I.004 The appliance could be inserted between two units (a) or as an end unit (b). S.I.006 3. The appliance is equipped with adjustable support f
ページ16に含まれる内容の要旨
50mm 20mm A PR166 PR168 8. Should the lining up of the furniture door be neces- 5. Place guide (A) on the inside part of the furniture sary, use the clearance of slots. door, up and down as shown in the figure and At the end of operations, it is necessary to check if mark the position of external holes. After having the door of the furniture closes properly. drilled holes, fix the guide with the screws sup- plied. A B C D PR167/1 PR33/2 9. Fix cover (D) on guide (B) until it clips into place. 6.
ページ17に含まれる内容の要旨
25 - 80 Fitting the plinth Important For the efficient operation of the appliance, it is important that the original ventilation grid is used. S.I.007 n For an opening height dimension A=820 mm and a plinth height dimension a=100 mm, the plinth may be fitted without adjustments. The same applies to an opening height dimension B=870 mm and a plinth height dimension b=150 mm. n For plinth heights greater than a=100 mm, b=150 mm, a cut should be made in the plinth, 580 mm wide, in the centre of the
ページ18に含まれる内容の要旨
ページ19に含まれる内容の要旨
ページ20に含まれる内容の要旨
© Electrolux Household Appliances Limited 2002
ページ1に含まれる内容の要旨
FREEZER
ZU 9120 F
INSTRUCTION BOOKLET
2222739-85
ページ2に含まれる内容の要旨
CONTENTS Instructions for the User Instructions for the Installer Important Safety Instructions 3 Technical Specifications 12 Description of the Appliance 4 Installation 12 Positioning 12 Operation 4 Before use 4 Electrical Connection 13 Freezer controls 4 Starting your appliance 5 Building-in instructions 14 Temperature control 5 Grid preparation 14 Warning light (red) 5 Door reversal 14 Acoustic alarm 5 Building in the appliance under a worktop 15 Freezing fresh food 5 Fitting the plinth 17 Fr
ページ3に含まれる内容の要旨
IMPORTANT SAFETY INSTRUCTIONS These warnings are provided in the interests of your safety. Ensure that you understand them all before installing or using this appliance. Your safety is of paramount importance. If you are unsure about any of the meanings of these warnings contact the Customer Care Department. Prior to Installation General Safety n Check the appliance for transport damage. Under n This appliance contains hydrocarbons in its no circumstance should a damaged appliance be cooling uni
ページ4に含まれる内容の要旨
Servicing At the end of the Appliance Life n This product should be serviced by an autho- n When disposing of your appliance use an autho- rised engineer and only genuine spare parts rised disposal site. should be used. n Remove the plug and ensure that any locks or n Under no circumstances should you attempt to catches are removed, to prevent young children repair the appliance yourself. Repairs carrier out being trapped inside. by inexperienced persons may cause injury or serious malfunctionin
ページ5に含まれる内容の要旨
Starting your appliance Freezing fresh food Insert the plug into the wall socket. The appliance In any 24 hour period you can freeze up to 20 kg of can be activated/deactivated by pressing the fresh food. ON/OFF button .The pilot light will light up to Activate fast freeze by depressing the fast freeze ¯ ˜ show that the appliance is on. switch 24 hours before you want to freeze your ` fresh food, the yellow light illuminates. This time ´ can be shortened, depending on the quantity of food Tempe
ページ6に含まれる内容の要旨
Important Thawing In the event of a power failure causing the Frozen food, prior to being used, can be thawed in temperature within your freezer to rise, do the fridge or at room temperature depending on the not re-freeze the food without checking its time available. Small food items may even be condition. cooked from frozen; in this case cooking will take The following guidelines should assist you: longer. Ice-cream: once thawed should be discarded. Any frozen food which is allowed to thaw acci
ページ7に含まれる内容の要旨
DEFROSTING The freezer compartment will become progressively covered with frost. This should be removed with the special plastic scraper provided, whenever the thick- ness of the frost exceeds 1/4". During this operation it is not necessary to switch off the power supply or to remove the foodstuffs. However, when the ice becomes very thick on the inner liner, complete defrosting should be carried out and it is advisable to carry out this operation when the appliance is empty. To carry out comple
ページ8に含まれる内容の要旨
MAINTENANCE AND CLEANING Before any maintenance or cleaning work is carried out, DISCONNECT the appliance from the ELEC- TRICITY supply. Warning This appliance contains hydrocarbons in its cooling unit maintenance and recharging must therefore only be carried out by authorised technicians. Internal cleaning Clean the inside and accessories with warm water and bicarbonate of soda (5ml to 0.5 litre of water). Rinse and dry thoroughly. NEVER USE DETERGENTS, ABRASIVE POW- DERS, HIGHLY PERFUMED CLEAN
ページ9に含まれる内容の要旨
SOMETHING NOT WORKING? Before contacting your local Service Force Centre check the following points. IMPORTANT: If you call out an engineer to a fault listed below, or to repair a fault caused by incorrect use or installation, a charge will be made even if the appliance is under guarantee. Symptom Solution No power to appliance - Check there is power at the socket. - Check there is not a power cut by checking the household lights. - Check the fuse has not blown. The temperature in the freezer i
ページ10に含まれる内容の要旨
SERVICE AND SPARE PARTS In the event of your appliance requiring service, or if When you contact the Service Force Centre you will you wish to purchase spare parts, please contact need to give the following details: your local Service Force Centre by telephoning:- 1. Your name, address and post code 2. Your telephone number 08705 929929 3. Clear and concise details of the fault 4. The model and serial number of the appliance Your telephone call will be automatically routed to the (found on the r
ページ11に含まれる内容の要旨
GUARANTEE CONDITIONS Standard guarantee conditions We, Zanussi, undertake that if within 24 months of the date of purchase this Zanussi appliance or any part there- of is proved to be defective by reason only of faulty workmanship or materials, we will, at our option repair or replace the same FREE OF CHARGE for labour, materials or carriage on condition that: n The appliance has been correctly installed and used only on the electricity supply stated on the rating plate. n The appliance has been
ページ12に含まれる内容の要旨
TECHNICAL SPECIFICATIONS DIMENSIONS Height 81,5 cm Width 56 cm Depth 53,8 cm POWER SUPPLY VOLTAGE AND FREQUENCY 220-240 V / 50 Hz TOTAL POWER ABSORBED 100 W AVERAGE DAILY UNITS ELECTRICITY (*) 0,76 kWh GROSS CAPACITY 95 l NET CAPACITY 86 l STAR RATING (*)This figure is based on standard test results in accordance with European Standard EN153. Actual con- sumption will depend on how the appliance is used and where it is located. INSTALLATION For building-in and door reversal instructions please W
ページ13に含まれる内容の要旨
ELECTRICAL CONNECTION WARNING: This appliance complies with the E.E.C. Directive THIS APPLIANCE MUST BE EARTHED. No. 87/308 of 2.6.87 relative to radio interference The manufacturer declines any liability suppression. should this safety measure not be observed. This appliance complies with the following E.E.C. Directive: If the plug that is fitted to your appliance is not suit- - 73/23 EEC of 19.2.73 (Low Voltage Directive) and able for your socket outlet, it must be cut off and the subsequent
ページ14に含まれる内容の要旨
BUILDING-IN INSTRUCTIONS Before carrying out any work, remove the plug from Door reversal the power socket. The appliance must be unplugged before starting work. To reverse the opening direction of the door, proceed as follows: Grid preparation F1 Remove the grid from the appliance pulling it towards F 1 you by hand. B G 3 Right door opening: Remove the left side (A) of the grid cutting it from the rear (see figure, a). F1 F 2 A a S.I.003 A 1. remove the top hinge (1) taking care not to let the
