ページ1に含まれる内容の要旨
Instruction
ESPAÑOL: PÁGINA 21
manual FRANÇAIS: PAGE 41
15 Horsepower
4000 PSI
4 GPM
Pressure Washer
PCK4040SP
IMPORTANT
Please make certain that the person who
To learn more about Porter-Cable
is to use this equipment carefully reads
visit our website at:
and understands these instructions before
starting operations.
http://www.porter-cable.com
The Model and Serial No. plate is located on the frame.
Record these numbers in the spaces below and retain
for future reference.
Model No.
Type
Seri
ページ2に含まれる内容の要旨
GENERAL INFORMATION Congratulations! You have purchased a high quality product from America’s leading manufacturer of pressure washers. This pressure washer, when properly used and maintained, will provide trouble free service. Please read and follow these instructions for proper use and maintenance. All sales of pressure washers are final. Do not return this product to the retailer. Call 1-888-559-8550. If you experience any problems and need assistance, please call us at our toll fre
ページ3に含まれる内容の要旨
SAFETY GUIDELINES / DEFINITIONS This manual contains indicates an imminently hazardous situation which, if not information that is im- avoided, will result in death or serious injury. portant for you to know and understand. indicates a potentially hazardous situation which, if not This information re- avoided, could result in death or serious injury. lates to protecting indicates a potentially hazardous situation which, if not YOUR SAFETY and avoided,may result in minor or moderate injury PREVEN
ページ4に含まれる内容の要旨
HAZARD WHAT CAN HAPPEN HOW TO PREVENT IT Breathing exhaust fumes will cause Operate pressure washer in a well serious injury or death! ventilated area. Avoid enclosed RISK TO areas such as garages, basements, BREATHING etc. Never operate unit in a location occupied by humans or animals. Some cleaning fluids contain sub- Use only cleaning fluids specifically stances which could cause injury recommended for high pressure to skin, eyes, or lungs. washers. Follow manufacturers recommendati
ページ5に含まれる内容の要旨
HOW TO PREVENT IT HAZARD WHAT CAN HAPPEN Do not use chlorine bleach or any Unsafe operation of your pressure other corrosive compound. washer could lead to serious injury RISK OF or death to you or others. Become familiar with the operation UNSAFE and controls of the pressure washer. OPERATION Keep operating area clear of all persons, pets, and obstacles. Do not operate the product when fatigued or under the influence of alcohol or drugs. Stay alert at all times. Never defeat the sa
ページ6に含まれる内容の要旨
The powerful spray from your pressure washer is capable of causing damage to surfaces such as wood, glass, automobile paint, auto striping and trim, and delicate objects such as flowers and shrubs. Before spraying, check the item to be cleaned to assure yourself that it is strong enough to resist damage from the force of the spray. Avoid the use of the concentrated spray stream except for very strong surfaces like concrete and steel. Operating without flow of water will result in equipment damag
ページ7に含まれる内容の要旨
ASSEMBLY 1. Place handle assembly onto frame and connect handle to frame. 2. Connect wand to gun. Tighten securely. 3. Attach high pressure hose to gun. Tighten securely. 5. Assemble grommet kit and quick-connect nozzles as described in instructions supplied. 6. Add engine oil (supplied) to engine. Refer to engine manual supplied by engine manufacturer for correct procedure. NOTE: There will be a slight amount of oil in the engine from factory testing. NOTE: The high pressure pump was filled
ページ8に含まれる内容の要旨
OPERATION Know Your Pressure Washer READ THIS OWNER’S MANUAL AND SAFETY RULES BEFORE OPERATING YOUR UNIT. Compare the illustrations with your unit to familiarize yourself with the location of various controls and adjustments. Save this manual for future reference. Quick Connect Nozzles Spray Quick Gun Connect Wand Engine High Pressure Hose High Pressure Pump PRESSURE WASHER High Pressure Pump: Increases the pressure of the water supply. Engine: Drives the high pressure pump. High Pressure Hose:
ページ9に含まれる内容の要旨
Starter Grip: Pulling starter grip operates recoil starter to crank engine. Fuel Valve Lever: Opens / closes connection between fuel tank and carburetor. Engine Switch: Enables and disables ignition system pressure washer operating features PRESSURE WASHER TERMINOLOGY NOTE: Become familiar with this terminology before operating. PSI: Pounds per Square Inch. The unit of measure for water pressure. Also used for air pressure, hydraulic pressure, etc. GPM: Gallons Per Minute. The unit of measure
ページ10に含まれる内容の要旨
TO USE WAND Your pressure washer is equipped with five spray nozzles. Each nozzle is color coded and delivers a specific spray pattern for a particular cleaning purpose. The size of the nozzle determines the size of the fan spray and the pressure out of the nozzle. The 0º, 15º , 25º, and 40º nozzles are high pressure nozzles. The chemical nozzle is a low pressure nozzle. The nozzles are housed in receptacles on the panel of the pressure washer handle. Colors on the panel identify nozzle locat
ページ11に含まれる内容の要旨
TO SIPHON CHEMICALS/CLEANING SOLVENTS Siphoning chemicals or cleaning solvents is a low pressure operation. NOTE: Use only soaps and chemicals designed for pressure washer use. Do not use bleach. 1. Press chemical hose onto barbed fitting Barb fitting located near high pressure hose connection of pump as shown. 2. Place other end of chemical hose with filter on it into container holding chemical/cleaning solution. 3. Install low pressure (black) nozzle into quick connect fitting of wand, see H
ページ12に含まれる内容の要旨
STARTING Prior to starting, refer to your engine manual for proper starting procedures for your engine type. 1. In a well ventilated outdoor area Add fresh high quality unleaded gasoline with a pump octane rating of 86 or higher. Do not overfill. Wipe up spilled fuel before starting the engine. Refer to engine manual for correct procedure. 2. Check engine oil level. See Engine Operators Manual for correct procedure. NOTE: There will be a slight amount of oil in the engine from factory testing.
ページ13に含まれる内容の要旨
MAINTENANCE WHEN PERFORMING MAINTENANCE, YOU MAY BE EXPOSED TO HOT SURFACES, WATER PRESSURE, MOVING PARTS, OR FIRE RESULTING IN SERIOUS INJURY OR DEATH. BEFORE PERFORMING ANY MAINTENANCE OR REPAIR, DISCONNECT SPARK PLUG WIRE, LET ENGINE COOL AND RELEASE ALL WATER PRESSURE. THE ENGINE CONTAINS FLAMMABLE FUEL. DO NOT SMOKE OR WORK NEAR OPEN FLAMES WHILE PERFORMING MAINTENANCE. To ensure efficient operation and longer life of your pressure washer, a routine maintenance schedule should be prepared
ページ14に含まれる内容の要旨
WAND If the nozzle becomes clogged with foreign materials, such as dirt, excessive pressure may develop. If the nozzle becomes partially clogged or restricted, the pump pressure will pulsate. Clean the nozzle immediately using the nozzle kit supplied and the following instructions: 1. Shut off the pressure washer and turn off the water supply. 2. Pull trigger on gun handle to relieve any water pressure. 3. Disconnect the wand from the gun. 4. Remove the high-pressure nozzle from the wand. Remo
ページ15に含まれる内容の要旨
STORAGE ENGINE Consult the Engine Owners Manual for the manufacturer's recommendations for storage. PUMP It is recommended that you follow these steps to protect the internal seals of the pressure washer when STORING THE UNIT FOR AN EXTENDED PERIOD and/or WHEN FREEZING TEMPERATURES ARE EXPECTED. NOTE: If storing the unit for more than 30 days *RV antifreeze needs to be run through the pump. This helps prevent damage within the pump head. *RV anti- freeze is not only added for winterizing, but fo
ページ16に含まれる内容の要旨
TROUBLESHOOTING GUIDE CAUSE PROBLEM CORRECTION No fuel. Add Fuel. Engine will not Low oil (if equipped with low oil Add required amount of oil. start (see Engine shutdown). Manual for further engine Pressure builds up after two Squeeze gun trigger to relieve troubleshooting) pulls on the recoil starter or after pressure. initial use. Push primer bulb 3 times or choke Not primed or choked. engine. Attach spark plug wire. Spark plug wire not attached. Engine ON/OFF switch in OFF Place engine ON/O
ページ17に含まれる内容の要旨
CAUSE CORRECTION PROBLEM Wand not in low pressure. See How to Use Wand paragraph in Will not draw the Operation Section. chemicals Chemical filter clogged. Clean filter. Chemical screen not in Insure end of chemical hose is fully submerged into chemical. chemical Dilute chemical. Chemical should be Chemical too thick. the same consistency as water. Pressure hose is too long Lengthen water supply hose instead of pressure hose. Chemical build up in chemical Have parts cleaned or replaced injector.
ページ18に含まれる内容の要旨
LIMITED WARRANTY PORTER-CABLE CORPORATION warrants to the original purchaser that all products covered under this warranty are free from defects in material and workmanship. Products covered under this warranty include air compressors, air tools, service parts, pressure washers, and generators, which have the following warranty periods: 3 YEARS - Limited warranty on 2-stage oil-free air compressor pumps that operate at 1725 RPM. 2 YEARS - Limited warranty on oil-lubricated air compressor pumps.
ページ19に含まれる内容の要旨
NOTES 19- ENG D26221
ページ20に含まれる内容の要旨
QUICK FACTS CALL 1-888-559-8550 TO FIND A LOCAL AUTHORIZED SERVICE CENTER NEAR YOU FOR REPAIRS AND SERVICE PART PURCHASES. Use fresh high quality gas. GAS Add stabilizer to fuel tank and run engine for 5 minutes before storage. Pump oil: Refer to owners manual supplied with this unit. OIL Engine oil: Refer to engine manual supplied with this unit. Some units are equipped with a low oil sensor and adequate oil must be added or the unit will not start. Use only cold water. WATER Don't operate unit
