ページ1に含まれる内容の要旨
PDWM 2500
DU DUAL VHF WIRELESS SY AL VHF WIRELESS SYSTEM STEM
OPERATION MANUAL
ページ2に含まれる内容の要旨
DUAL VHF WIRELESS SYSTEM OPERATION MANUAL Avoid exposure of the system to rain or moisture. No user-serviceable parts inside the system. Refer all servicing to a qualified Thank you for buying the PDWM2500 Wireless System. Please technician only. read through these operation instructions so you will know how Handle the wireless system carefully, dropping or other shocks may cause to operate your model properly. After you read it, put it away in a failure. safe place for
ページ3に含まれる内容の要旨
1. Unscrew the battery cover at the end of microphone, put a 9V battery into compartment with correct polarities, then close the cover. 2. Move "ON/OFF" switch to "ON" position, "PWR" indicator comes on b lue. If it does n't come on, please check the voltage of battery or polarities. If the "LOW" indicator comes on, this indicates the battery is dead. Please replace with a fresh battery. 3. The "MUTE" switch cuts off audio output without powering off the microphone. Move the swit
ページ4に含まれる内容の要旨
1.Pull out the antennas A and B. Make sure they are completely extended and vertical. 2.Insert one end of attached audio cable into "AF OUT" on rear panel, and the other end into "MIC IN" or "AUX IN" of amplifier or mixer. 3.Connect the power adaptor from DC 12V of receiver to a main power socket. 4.Switch on the receiver. The power indicator comes on. 5.Switch on the microphone. The "RF" indicator on receiver comes on green. The "LEVEL" indicator will light up when you speak into the mi
ページ5に含まれる内容の要旨
Using the supplied audio cable, connect from the AF Output jack socket to the "MIC IN" / "LINE IN" socket on amplifier. Connect the mains power adaptor from "DC 12V" jack to a suitable mains power socket. Installation Location: At least 3 ft. above ground level At Least 3 ft. away from wall 4
ページ6に含まれる内容の要旨
The wireless microphone is not Turn on the wireless microphone turned on. The on air The microphone receiver is not Turn on the microphone receiver indicator does turned on. and the connected audio equipment not light up The microphone receiver is not Turn on the microphone receiver connected properly. and the connected audio equipment The battery in the wireless Replace the battery. microphone is weak. The microphone receiver is not Turn on the microphone receiver turned on . and th
ページ7に含まれる内容の要旨
A.Overall system Oscillation mode: Quartz controlled Carrier Frequency Range: VHF 160~270MHz Frequency Stability: 30ppm Modulation Mode: FM Max Deviation: 75KHz Dynamic Range: >100dB S/N >60dB T.H.D:
