Carrier SERIES 131 58PAVの取扱説明書

デバイスCarrier SERIES 131 58PAVの取扱説明書

デバイス: Carrier SERIES 131 58PAV
カテゴリ: 暖炉
メーカー: Carrier
サイズ: 0.2 MB
追加した日付: 8/15/2014
ページ数: 12
説明書を印刷

ダウンロード

使い方は?

私たちの目的は、皆様方にデバイスCarrier SERIES 131 58PAVの取扱説明書に含まれたコンテンツを可能な限り早く提供することです。オンラインプレビューを使用すると、Carrier SERIES 131 58PAVに関してあなたが抱えている問題に対する解決策の内容が素早く表示されます。

便宜上

説明書Carrier SERIES 131 58PAVをこちらのサイトで閲覧するのに不都合がある場合は、2つの解決策があります:

  • フルスクリーン表示 – 説明書を(お使いのコンピュータにダウンロードすることなく)便利に表示させるには、フルスクリーン表示モードをご使用ください。説明書Carrier SERIES 131 58PAVのフルスクリーン表示を起動するには、全画面表示ボタンを押してください。
  • コンピュータにダウンロード - Carrier SERIES 131 58PAVの説明書をお使いのコンピュータにダウンロードし、ご自身のコレクションに加えることもできます。デバイス上のスペースを無駄にしたくない場合は、いつでもManualsBaseサイトでダウンロードすることもできます。
Carrier SERIES 131 58PAV 取扱説明書 - Online PDF
Advertisement
« Page 1 of 12 »
Advertisement
印刷版

多くの人々は画面表示ではなく印刷された説明書を読むほうを好みます。説明書を印刷するオプションも提供されており、上記のリンクをクリックすることによりそれを利用できます - 説明書を印刷。説明書Carrier SERIES 131 58PAVを全部印刷する必要はなく、選択したページだけを印刷できます。紙を節約しましょう。

要旨

次のページにある説明書Carrier SERIES 131 58PAVの内容のプレビューは、以下にあります。次のページにある説明書の内容をすぐに表示したい場合は、こちらをご利用ください。

内容要旨
ページ1に含まれる内容の要旨

CANADIAN GAS ASSOCIATION
58PAV, 58RAV
Induced-Combustion Furnaces
Service and Maintenance Instructions
For Sizes 045-155, Series 131
NOTE: Readtheentireinstructionmanualbeforeperformingany
service or maintenance.
This symbol → indicates a change since the last issue.
Index Page
SAFETY CONSIDERATIONS..................................................1-2
ELECTROSTATIC DISCHARGE (ESD) PRECAUTIONS
PROCEDURES.........................................................................2
CARE AND MAINTE

ページ2に含まれる内容の要旨

The ability to properly perform maintenance on this equip- Neverstoreanythingon,near,orincontactwiththefurnace, ment requires certain expertise, mechanical skills, tools, and such as: equipment. If you do not possess these, do not attempt to 1. Spray or aerosol cans, rags, brooms, dust mops, vacuum perform any maintenance on this equipment other than those cleaners, or other cleaning tools. procedures recommended in the User’s Manual. FAILURE 2. Soap powders, bleaches, waxes or other cleaning co

ページ3に含まれる内容の要旨

d. Furnaces are equipped with permanent, washable filters. Clean filters with tap water. Spray water through filter in opposite direction of airflow. e. Rinse and let dry. Oiling or coating of filters is not recommended or required. f. Reinstall filters. g. Replace blower access door. AIRFLOW h. Restore electrical power to furnace. 2. Upflow Each furnace requires 1 or 2 filters which are installed in the blower compartment. (See Fig. 6.) To remove filte

ページ4に含まれる内容の要旨

VENT PIPE DRAFT ENCLOSURE MOUNTING SAFEGUARD SCREWS AUXILIARY SWITCH LIMIT SWITCH RELIEF (WHEN USED) BOX FLUE CONTROL MOUNTING COLLECTOR BOARD SCREWS BOX CONTROL DRAFT BOARD MANUAL SAFEGUARD RESET LIMIT SWITCH RELIEF SWITCH BOX FILTER RETAINER MANUAL WASHABLE RESET LIMIT FILTER SWITCHES A92063 A92064 Fig. 6—Model 58PAV Upflow Fig. 7—Model 58RAV Downflow 9. Loosen setscrew holding blower wheel on motor shaft. 18. Reconnect wires to auxiliary limit switch on blower housing (d

ページ5に含まれる内容の要旨

8. Cleancellsusingfield-providedsmallwirebrush,steelspring 13 11 32" 32" cable, reversible electric drill, and vacuum cleaner. BURNER a. Assemble wire brush and steel spring cable. (1.) Use 48 in. of 1/4-in. diameter high-grade steel spring cable (commonly known as drain clean-out or Roto- CELL PANEL Rooter cable). (2.) Use1/4-in.diameterwirebrush(commonlyknownas 25-caliber rifle cleaning brush). HOT SURFACE NOTE: Thematerialsneededinitems(1.)and(2.)canusuallybe IGNITOR purchased at local ha

ページ6に含まれる内容の要旨

→ELECTRICAL CONTROLS AND WIRING a. LEDflashesafaultcode4times.Recordthisfaultcodefor further troubleshooting. b. Inducer motor operates for 10 sec, then turns off. Theremaybemorethan1electricalsupplytotheunit.Check c. Hot surface ignitor is energized for 15 sec, then de- accessoriesandcoolingunitforadditionalelectricalsupplies. energized. d. Main blower operates at cooling speed for 10 sec, then The electrical ground and polarity for 115-v wiring must be turns off. maintained properly. Refer to

ページ7に含まれる内容の要旨

FIELD 24-VOLT WIRING FIELD 115-, 208/230-, 460-VOLT WIRING FACTORY 24-VOLT WIRING FACTORY 115-VOLT WIRING THERMOSTAT W R G Y FOUR FIELD-SUPPLIED TERMINALS WIRE FUSED DISCONNECT TWO-WIRE 208/230- OR HEATING- 460-VOLT ONLY THREE PHASE W BLK BLK R WHT WHT 208/230- VOLT GND GND G SINGLE AUXILIARY 115-VOLT FIELD- PHASE J-BOX C GND SUPPLIED CONTROL FUSED CONDENSING Y BOX DISCONNECT UNIT TWO 24-VOLT NOTE: If any of the original wire, WIRE TE

ページ8に含まれる内容の要旨

8 (WHEN USED) SCHEMATIC DIAGRAM TO 115VAC FIELD DISCONNECT SW2 NOTE #12 (WHEN USED) G BLOWER PRS LGPS R DSS ALS NEUTRAL (NATURAL GAS & PROPANE) NOTE #4 OFF L1 PCB Y ORN EQUIPMENT GROUND DELAY W SW1 C L2 OM ILK LO BLOWER OFF DELAY HUM SPARE-1 MED LO SELECTION CHART TEST/TWIN YEL NOTE #6 HEAT MED HI PL4 1 2 LED BLU HI 90 SEC SPARE-2 START (WHEN USED) HI/LO OL L1 NOTE #8 BLWR 135 SEC FRS2 RED 1-M 3-P COOL RED CAP COM PL1 180 SEC 3 2 1 LS COM GV BLWM EAC-1 WHT 225 SEC 6 4 5 FSE HSIR 9 8 7 RED 2-C E

ページ9に含まれる内容の要旨

TEST STATUS 3 2 1 6 5 4 9 8 7 SERVICE LABEL SERVICE LED CODE STATUS CONTINUOUS OFF - Check for 115VAC at L1 and L2, and 24VAC at SEC-1 and SEC-2. CONTINUOUS ON - Control has 24V power. RAPID FLASHING - Line voltage (115V) polarity reversed. If twinned, 24V power to one furnace may be out of phase with 24V power to other furnace. EACH OF THE FOLLOWING STATUS CODES IS A TWO DIGIT NUMBER WITH THE FIRST DIGIT DETERMINED BY THE NUMBER OF SHORT FLASHES AND THE SECOND DIGIT BY THE NUMBER OF L

ページ10に含まれる内容の要旨

10 TROUBLESHOOTING GUIDE START NO NO NO Is red LED status light on? Is there 115v at L1 and L2? Is door switch closed? Close door switch and go to start. YES YES YES NO NO NO Is there 24v at SEC-1 and SEC-2? Is there 115v going to switch? Is circuit breaker closed? YES YES Replace door switch. Close circuit breaker and Replace control board. go back to start. YES Replace transformer. Check for continuity in wire from circuit breaker to furnace. Is red LED status light blinking YES Check for

ページ11に含まれる内容の要旨

11 31 PRESSURE, DRAFT Unplug ignitor harness from control 11 NO PREVIOUS FAULT - Faults SAFEGUARD (WHEN USED), center and inititate another are erased after 48 hrs or OR AUXILIARY LIMIT (WHEN component test sequence and check NO whenever power (115V or 24V) Replace control board. USED) SWITCH WILL NOT for 115v between pins 1 and 2 on is interrupted. Run system CLOSE OR REOPEN - If open the board. Was there 115v present through a heating or cooling longer than 5 minutes, induc

ページ12に含まれる内容の要旨

Copyright 1994 CARRIER Corp. • 7310 W. Morris St. • Indianapolis, IN 46231 58pr9sm Manufacturer reserves the right to discontinue, or change at any time, specifications or designs without notice and without incurring obligations. Book 1 4 PC 101 Catalog No. 535-835 Printed in U.S.A. Form 58P,R-9SM Pg 12 9-94 Replaces: 58P,R-8SM Tab 6a 8a


類似の説明書
# 取扱説明書 カテゴリ ダウンロード
1 Carrier 58CLA 取扱説明書 暖炉 2
2 Carrier 58DE 取扱説明書 暖炉 0
3 Carrier 58CTA/CTX 取扱説明書 暖炉 6
4 Carrier 58DFA 取扱説明書 暖炉 2
5 Carrier 58DH 取扱説明書 暖炉 2
6 Carrier 58B 取扱説明書 暖炉 2
7 Carrier 58CMA 取扱説明書 暖炉 3
8 Carrier 58DHL 取扱説明書 暖炉 1
9 Carrier 58BB 取扱説明書 暖炉 1
10 Carrier 58BD 取扱説明書 暖炉 1
11 Carrier 58DP 取扱説明書 暖炉 1
12 Carrier 58DX 取扱説明書 暖炉 1
13 Carrier 58DR 取扱説明書 暖炉 0
14 Carrier 58DRC 取扱説明書 暖炉 1
15 Carrier 58EFA 取扱説明書 暖炉 1
16 Adams Condensing Oil-Fired 取扱説明書 暖炉 2
17 AirComm Corporation 10016 取扱説明書 暖炉 0
18 AirComm Corporation 7516 取扱説明書 暖炉 0
19 AirComm Corporation 50 取扱説明書 暖炉 0
20 Air King 9320 取扱説明書 暖炉 2