ページ1に含まれる内容の要旨
!
I
e STAR'I"
CONTROL
OPERATINGSTATUS
SYMBOLS
_Jl LINT SCREEN
B SAFETY DOOR
SWITCH
1_ ERFORMANCE
GUIDE LABEL
_DEL NO. PLATE
m m m
If you need SERVICE or PARTS for your Kenmore dryer:
ELECTRIC
Be ready to give your Sears Service Department the model number, serial number and date of
purchase. Write in below. The plate i¢1with model and serial numbers is located behind the
MODEL 64291
dryerdoor.
iii
GAS
,.1tO. [ M MODEL 74291
I
MODEL NO. SERIAL NO.
DATE OF PURCHASE
ページ2に含まれる内容の要旨
How to dry a load of laundry Set Cycle Selector Control Ill. Remove load when dry. b/_ Clean lint screen before each load. [_) ush the Start Control Ill1to start Put laundry into dryer and shut the door. your dryer. I! |l Ill Cycle Selector Control il Start Control Use this control to select the proper drying method for the type of Use this control to start the dryer. Be sure the door is closed. items in the load. The control can be set for Timed Drying or Air. Opening the door stops the dryer.
ページ3に含まれる内容の要旨
Ill CYCLi_ SELECTOR CONTROL NORMAL Cycle PERMANENT PRESS Cycle Use this cycle to get up to 120 minutesof drying time at high heat followed Use this cycle to get up to 50 minutes of drying time at high heat followed by a 5 minute (approx.) cooldown. by a 10 minute (approx.) cooldown. • Set the Cycle Selector Control to the amount of time you want in the • Set the Cycle Selector Control to the amount of time you want in the Normal Cycle. Permanent Press Cycle. • Push the Start Control. • Push the
ページ4に含まれる内容の要旨
FEATURES E1 Lint Screen [[3 Performance Guide Label Keep the lint screen clean. A lint-clogged screen will slow down the flow Located inside the dryer door. Gives information on what to do if dryer of air. This makes drying time longer and wastes energy. Clean the lint does not perform normally. screen before each load as follows: NOTE: If dryer drum is stained, clean it with a damp cloth and mild !. With dryer off, remove the screen by pulling straight up. detergent. 2. Roll the dry lint off th
