ページ1に含まれる内容の要旨
Mid-wheel Powerchair
USER MANUAL
Models:
6Runner 10 (888WNLM)
6Runner 10 DLX (858WM)
6Runner 14 (888WNLLHD)
6Runner 10 (888WNLM) 6Runner 10DLX (858WM)
6Runner 14
(888WNLLHD)
ページ2に含まれる内容の要旨
Table of Contents INTRODUCTION................................................................................ 3 EMI WARNING................................................................................... 4 ELECTROMAGNETIC INTERFERENCE FROM RADIO WAVES ................... 4 POWERED CHAIR ELECTROMAGNETIC INTERFERENCE (EMI) ................ 5 SAFETY INSTRUCTIONS .............................................................. 6-7 FEATURE GUIDE ...........................................
ページ3に含まれる内容の要旨
INTRODUCTION Congratulations on insisting on the best. Shoprider Powerchairs are the ultimate combination of style and comfort. The 6Runner features support easy maneuverability and smooth control for today’s active lifestyle. The innovative design of the 6Runner includes articulating double frames that move in any direction. This intelligent feature keeps all 6 wheels on the ground at all times, even when driving on uneven terrain, hence the name 6Runner. Combine this with the
ページ4に含まれる内容の要旨
EMI WARNING Electromagnetic Interference (EMI) from Radio Wave Sources Powered electric chairs may be susceptible to electromagnetic interference, which is a kind of interfering electromagnetic energy (EM) emitted from sources such as radio stations, TV stations, amateur radio (HAM) transmitters, two-way radios and cellular phones. The interference (from radio wave sources) can cause the power chairs to release its brakes, move by itself or move in unintended directions. It can also
ページ5に含まれる内容の要旨
Powered Chair Electromagnetic Interference (EMI) Because EM energy rapidly becomes more intense the closer one moves to the transmitting antenna (source), the EM fields from hand- held radio sources (transceivers) are of special concern. It is possible to unintentionally bring high levels of EM energy very close to the Powerchair’s control system while using these devices. This can affect the Powerchair’s movement and braking. Therefore, the warnings listed below are recommended to pre
ページ6に含まれる内容の要旨
Safety Instructions Please use your Powerchair to enhance your active lifestyle. With increased mobility, please observe a few rules to ensure safe operation of your Powerchair. So please… 1. Do not drive the Powerchair without reading this manual. 2. Do not exceed the safe climbing maximum angle (Fig. 6-7). 3. Do not use the joystick in an erratic manner when going up or down an incline. 4. Do not carry passengers or exceed the maximum weight limit (Table 2). 5. Do not turn of
ページ7に含まれる内容の要旨
18. Always keep the feet on the leg rest while driving. 19. Always make sure the batteries are fully charged before setting out on a journey. 20. Always charge the Powerchair in a well ventilated area to prevent any possible risk. 21. Always check that the drive wheels are engaged. Someone may have left the Powerchair in freewheel mode. 22. Always reduce your speed when turning sharply. 23. Avoid turning sharply on a slope or gradient. 24. To brake in an emergency simply
ページ8に含まれる内容の要旨
Feature Guide 6Runner 14” – 888WNLLHD Figure 1 1 2 4 3 9 5 7 6 8 (1) Removable Armrests with Width, Height & Angle Adjustment (Flips Up for Easy Sideways Transfer) (2) Programmable VSI Joystick Controller with Adjustable speed & Battery Life Indicator. (3) Charging Port (4) Deluxe Reclining Captain Seat (5) Adjustable Length, Height, Angle Foot Plate (6) Front Castor Assy (7” flat free tire) (7) Frame Serial Number (13 alphanumeric characte
ページ9に含まれる内容の要旨
Feature Guide 6Runner 10” (888WNLM) 6Runner 10” DLX (858WM) Figure 2 1 2 4 3 9 5 7 6 8 (1) Removable Armrests with Width, Height & Angle Adjustment (Flips Up for Easy Sideways Transfer) (2) VSI Joystick Controller with Adjustable speed & Battery Life (3) Charging Port (4) Deluxe Reclining Captain Seat (5) Standard Angle Adjustable Foot Plate (6) Front Castor Assy (7” on 888WNLM,6” on 858WM) (7) Frame Serial Number (13 alph
ページ10に含まれる内容の要旨
Getting to Know Your Shoprider Powerchair The Seat and Arm Assemblies The seat is built for comfort, style, and stability. Your seat comes with a reclining back for comfort. The flip-up arm-rests are especially built for easy side access for getting in and out of your 6Runner, with the greatest of ease. The arm-rests have a built in height adjustment knob, that adjusts the arm pad to a comfortable level for the driver. The seat is covered in a durable long lasting black/grey vinyl fo
ページ11に含まれる内容の要旨
Seat Height Adjustment And Easy Battery Access 1. Tightening knob that allows for the seat to be removed if needed, 1 if not, there is a pivot point that allows for the seat to move up and away from the base. 2. Adjustment pins that can be 2 used to adjust the height of the seat to fit the user. 3. Release levers; allow for the rear of the seat to be lifted and moved away from the base for 3 easy battery access, without removing entire seat. 4 4. U-Hooks ho
ページ12に含まれる内容の要旨
The Joystick Controller (VSI) 8 1. On-Off Button: This button turns the joystick 1 2 controller (hereinafter referred to as VSI) on and off. Do not use this button to stop the 4 3 power chair, except in an emergency. 2. Battery Gauge: This is a 10-segment display, which indicates if the VSI is switched 5 6 on and gives the state of charge of the battery. Additionally, any faults in the Powerchair electrical system are also 7 indicated by this display. Refer to Table 1 for
ページ13に含まれる内容の要旨
Locking/Unlocking the VSI Joystick ****PLEASE NOTE**** LOCK MODE: The VSI controller may be programmed to have a lock mode function enabled to prevent unauthorized use. The locking method is achieved through a sequence of key presses and joystick movements, as detailed below. To lock Powerchair controller: While the controller is switched on, depress and hold the on/off button. After 1 second the controller will bleep. Now release the on/off button. Push the joystick forwar
ページ14に含まれる内容の要旨
The Powerchair will not function while the drive mechanism is disengaged (in freewheel). Both left and right sides must be in drive mode for power chair to operate. Otherwise the Powerchair motors will spin, but the unit will not move, until both freewheel levers are engaged. Unit will spin in circles if only one side is in drive mode. *** DO NOT PUT INTO DRIVE MODE WHILE MOTORS ARE SPINNING **** 6Runner – 888WNLM, 888WNLLHD & 858WM The drive/freewheel levers are found toward the re
ページ15に含まれる内容の要旨
Driving Your Shoprider Powerchair Ramps, Slopes and Cambers The indoor/outdoor Powerchair has the ability to negotiate ramps, slopes and cambers of a low to medium gradient. It is of the utmost importance that the following points are observed: 1. Never attempt to go up or down an incline which has a rough, wet or slippery surface (loose gravel, tree roots, wet grass, polished floor, etc.) 2. Always approach an incline head on, not at an angle 3. Always travel at a speed that y
ページ16に含まれる内容の要旨
Caring for Your Shoprider 6Runner Powerchair First Time Use Prior to using your Powerchair for the first time, you must charge the batteries fully (refer to Battery Charging Procedures). Charging may take up to 12 hours. Charging the batteries completely prior to first time use will benefit battery efficiency and battery life. Tires Since your tires are flat free tires, there is no need to ever worry about tire air-pressure. When tread is worn, it is highly recommended to replace ti
ページ17に含まれる内容の要旨
General Maintenance and Lubrication Inspection for loose wheel bolts, seat and arm tightening bolts, castor nuts and other nuts and bolts is recommended on a regular basis. Most lubricated components on the Powerchair are designed to be maintenance free and are sealed. Therefore, lubrication is not required for these components. However, the driving wheel axles and seat post should always have a very light coat of multi-purpose grease.**NOTE** Never put grease or oil in the breather
ページ18に含まれる内容の要旨
Batteries & Battery Charging Batteries The Shoprider 6Runner Powerchairs are designed to operate on two 12 volt/36Ah or 75Ah sealed lead acid aka SLA (AGM or gel-cell type) maintenance free batteries. The life of the batteries may be affected by temperature, terrain, weight of user, driving methods, and care of batteries. The active user will need to charge the batteries after using approximately 30% of battery capacity. As an inactive user, only using from once a week to every oth
ページ19に含まれる内容の要旨
6Runner 888WNLM,858WM, 888WNLLHD How to Charge Your Unit 1) Plug the A/C power cord into the wall. Plug the male three-pin charger plug into the female 3-pin receiver located on the bottom of the VSI. Turn the switch on if applicable (8Amp charger only) The battery charger’s light indicator is as follows: One light charger (4Amp) Yellow/Amber- Charging Green- Charging Complete Or Two light charger (8Amp) Red (solid)- Power ON Yellow/Amber- Charging Green- Charged NOTE:
ページ20に含まれる内容の要旨
Troubleshooting The Self-Help Guide (Table 1) is intended to assist in the location of a fault that may occur in a certain part of the Powerchair. If after checking the fault from the table below and the fault is still showing, do not use the Powerchair. Turn off the power and consult your provider immediately. Table 1 BATTERY GAUGE FAULT POSSIBLE VSI-50 FAULT CODE Battery voltage is too high, check the battery connections. 10 Bars flash Call your Shoprider Provider. 9 Bars flash
