ページ1に含まれる内容の要旨
SETUP INSTRUCTIONS
AD-14
Duplex Unit
CF1501/CF2001
WARNING
• Before setting up this unit, be sure to unplug the power cord of the copier.
• Parts inside the copier are extremely hot. Before replacing the spring, be sure to wait approxi-
mately 20 minutes after turning off the copier and checking that the area around the fusing unit
has cooled down. In addition, touching any part other than those specified may result in burns.
CAUTION
• Keep all packing materials out of the reach of children.
•
ページ2に含まれる内容の要旨
n n Duplex Unit Unpacking the Duplex Unit Preparing to Install the Duplex Unit 1. Remove the duplex unit from its box, and then check that the following accessories 1. Turn off the copier, unplug the power cord are also enclosed. and the interface cable from the copier. Then, open the manual bypass tray. (1) Flat-head screws. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 (2) Wiring cover . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
ページ3に含まれる内容の要旨
Duplex Unit 4. Grasp the upper right-side door as shown, 7. Re-install the paper output cover. and then carefully open the door completely while making sure to support it. NOTE Be sure to support the door while carefully opening it; otherwise, it may be damaged. C4657U026AA 5. Remove the two screws securing the paper output cover, and then remove the cover. C4657U020AB C4657U022AA 6. Remove the spring indicated in the illustra- 8. Using the two screws, secure the paper out- tion, and then repl
ページ4に含まれる内容の要旨
n Duplex Unit 3. Plug the two connectors from the duplex unit Installing the Duplex Unit into the connectors on the copier. 1. Align the two tabs on the duplex unit with the two holes in the copier, and then install the duplex unit. C4657U009AA C4657U013AA C4657U005AA NOTE While supporting the duplex unit, open the door on the right side of the copier, and make sure that the tabs are secured within the holes in the copier door. C4657U010AA C4657U006AA 4. Secure the cable of the duplex unit wit
ページ5に含まれる内容の要旨
n Duplex Unit 5. Touch “1st.”. Checking and Adjusting the Paper Reference Position NOTE Perform the procedure below after adjusting the paper reference positions for the paper feed unit and the large-capacity cabinet. 1. Display the Tech. Rep. Mode screen. (For details about displaying the Tech. Rep. C4657P002CA Mode screen, refer to the Service Manual.) 6. Press the Start key. A test page is printed. C4658P001CA 2. Touch “Machine Adjust”. C4004O068CA 7. Measure the width of loss for the tes
ページ6に含まれる内容の要旨
Duplex Unit 8. Adjust the paper reference positions for the 2nd, 3rd and 4th drawers in the same way (by repeating steps 5 through 7). NOTE The 4th drawer is only available if two optional paper feed units are installed. 4657-7744-12 – 5 –
