ページ1に含まれる内容の要旨
Register your product and get support at
AJ3500
EN User manual
ページ2に含まれる内容の要旨
a
ページ3に含まれる内容の要旨
b
ページ4に含まれる内容の要旨
c a b HR SET TIME c d CLOCK MIN HR MIN
ページ5に含まれる内容の要旨
d a b SET AL 1 HR SET AL 2 c d MIN CLOCK PM HR MIN
ページ6に含まれる内容の要旨
e a b FM/MW RADIO c TUNING f VOL
ページ7に含まれる内容の要旨
EN 1 Important Safety • Read these instructions. • Heed all warnings. • Follow all instructions. • Do not use this clock radio near water. • Clean only with dry cloth. • Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions. • Do not install near any heat sources such as radiators, heat r e g i s t e r s , s t o v e s , o r o t h e r a p p a r a t u s ( i n c l u d i n g a m p l i fi e r s ) t h a t produce heat. • Protect the power cord fr
ページ8に含まれる内容の要旨
• Do not place any sources of danger on the clock radio (e.g. l i q u i d fi l l e d o b j e c t s , l i g h t e d c a n d l e s ) . • W h e r e t h e M A I N S p l u g o r a n a p p l i a n c e c o u p l e r i s u s e d a s t h e disconnect device, the disconnect device shall remain readily operable. 2 Your clock radio Congratulations on your purchase, and welcome to Philips! To fully benefit from the suppor t that Philips off er s, register y our product at www.philips.com/welcome. In
ページ9に含まれる内容の要旨
Overview of the main unit n m l k j a b i h g c f e d a FM/MW frequency indicator • S h o w F M / M W f r e q u e n c y . b HR/MIN • Adjust hour/minute.
ページ10に含まれる内容の要旨
c REPEAT ALARM/BRIGHTNESS CONTROL • S n o o z e a l a r m . • Adjust display brightness. d Display panel • S h o w c u r r e n t s t a t u s . e AL1/AL2 • Turn on/off alarm. • View alarm settings. f RADIO • Turn on/off radio. g FM/MW • S e l e c t F M / M W t u n e r . h SLEEP • S e t s l e e p t i m e r . i CLOCK/SET AL1/SET AL2/SET TIME • S e t t i m e / a l a r m . • View time. j + TUNING - • Tune to radio stations. k AL1/AL2 RADIO·BUZZ • S e l e c t a l a r m s o u r c e f o r
ページ11に含まれる内容の要旨
3 Get started Caution • Use of controls or adjustments or performance of procedures other than herein may result in hazardous radiation exposure or other unsafe operation. Always follow the instructions in this chapter in sequence. Install battery a Warning • R i s k o f e x p l o s i o n ! K e e p b a t t e r i e s a w a y f r o m h e a t , s u n s h i n e , o r fi r e . N e v e r d i s c a r d b a t t e r i e s i n fi r e . • The battery contains chemical substances, so it should be dispos
ページ12に含まれる内容の要旨
Connect power b Caution • Risk of product damage! Ensure that the power voltage corresponds to the voltage printed on the back or underside of the clock radio. • Risk of electric shock! When you unplug the AC adapter, always pull the plug from the socket. Never pull the cord. Plug and set The clock radio has “plug and set” feature. When power is connected, the clock is set automatically. Select time zone Check if the time of the clock radio is consistent with the local time. If not, adjust
ページ13に含まれる内容の要旨
Set clock c In standby mode, you can set clock manually. Tip • In clock setting mode, press and hold HR/MIN for one second, and the hour/minute digits increase or decrease continuously. Select DST (daylight saving time) mode For countr ies with da ylight sa ving time (DST), the clock r adio off er s y ou DST option to adjust summer time . In standby mode, press and hold 12/24H·DST for two seconds. » The clock advances by one hour and [DST] is displayed. Tip • T o e x i t D S T m o d e , r e
ページ14に含まれる内容の要旨
Note • In alarm setting mode, press and hold HR/MIN for one second, and the hour/minute digits increase or decrease continuously. Select alarm sound To select the last heard channel or buzzer as alarm sound, switch AL1/ AL2 RADIO·BUZZ to left or right. Tip • The gentle wake-up function is designed for all alarm sources. Activate/deactivate alarm timer 1 Press AL1/AL2 to view alarm settings. 2 Press AL1/AL2 again to activate or deactivate the alarm timer. » or appears if alarm timer is on and
ページ15に含まれる内容の要旨
Snooze alarm When alarm sounds, press REPEAT ALARM/BRIGHTNESS CONTROL. » The alar m snooz es and repeats r inging fiv e min utes later . T o adjust alar m inter val (in min utes), press REPEAT ALARM/ BRIGHTNESS CONTROL repeatedly. 5 10 15 20 25 30 5 Listen to radio Tune to radio stations e Tip • Position the antenna as far as possible from TV, VCR, or other radiation source. • For better reception, fully extend and adjust the position of the antenna.
ページ16に含まれる内容の要旨
Adjust volume f 6 Other features Set sleep timer This clock radio can switch to standby mode automatically after a preset period. 1 Press SLEEP repeatedly to select sleep timer period (in m i nu t es ) . » When the sleep timer is activated, is displayed. To deactivate the sleep timer: 1 Press SLEEP repeatedly until [OFF] ( o f f ) a p p e a r s . 15 30 60 90 120 OFF Select hotel mode In hotel mode, the alarm can only be activated once at the preset time and will not repe
ページ17に含まれる内容の要旨
Note • To return to normal mode, repeat the above operation. [OFF] is displayed. Adjust display brightness Press REPEAT ALARM/BRIGHTNESS CONTROL repeatedly to select different brightness level: high, mid, and low. 7 Product information Note • Product information is subject to change without prior notice. Specifications Amplifier Rated Output Power 0 . 6 W R M S
ページ18に含まれる内容の要旨
Tuner Tuning Range F M : 8 7 . 5 - 1 0 8 M H z M W : 5 2 0 - 1 62 0 K H z S e ns it i v it y F M : < 2 2 d B u - M o n o , 2 6 d B S / N R a t i o M W : < 9 2 d B u V / M S e a r c h S e l e c t i v i t y F M : < 2 8 d B u M W : < 9 8 d B u V / M Total Harmonic Distortion FM: <3% MW:<5% S i g n a l t o N o i s e R a t i o F M : > 4 5 d B M W : > 4 0 d B General information AC power 2 2 0 - 2 4 0 V ~ , 5 0 / 6 0 H z Operation Power Consumption < 3W S t a n d b y P o w e r C o n s u m p t i o n <
ページ19に含まれる内容の要旨
8 Troubleshooting Warning • Never remove the casing of this apparatus. To keep the warranty valid, never try to repair the system yourself. If you encounter problems when using this apparatus, check the following points before requesting service. If the problem remains unsolv ed, go to the Philips w eb site (www .philips.com/w elcome). When you contact Philips, ensure that the apparatus is nearby and the model number and serial number are available. No power • Ensure that the AC power p
ページ20に含まれる内容の要旨
• Power has been interrupted or the power plug has been disconnected. • Reset the clock/alarm. 9 Notice This product complies with the radio interference requirements of the European Community. An y changes or modifications made to this device that are not expressl y approved by Philips Consumer Lifestyle may void the user’s authority to operate the equipment. Note • The type plate is located on the bottom of the apparatus. Your product is designed and manufactured with high quality mat
