ページ1に含まれる内容の要旨
Model iH11
Alarm Clock for
®
your iPod
Questions? Visit www.ihomeaudio.com
ページ2に含まれる内容の要旨
Table of Contents Quick Start 1 Controls and Indicators 2 iH11 Display 3 Install Clock Backup Battery 3 Using The Optional Remote Control 4 Install/Replace the Remote Control Battery To check for iPod compatibility Setting Up the iH11 5 Charging your iPod 5 Listening to your iPod 6 Listening to non-docking iPod or other portable audio devices 6 Alarm Operation 7 Sleep Operation 8 Snooze/Dimmer Operation 8 A Consumer Guide to Product Safety 9 Trouble Shooting 10 Solución De Problemas 11 Warranty
ページ3に含まれる内容の要旨
FCC Information This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. NOTE: This equipment has been tested
ページ4に含まれる内容の要旨
Quick Start 3:iPod 1:power 2:inserts dst -1 +1 on o line in clock adj. DC 10V Insert iPod into dock with proper Attach AC adaptor cable to jack on Select the dock insert for your back of the iH11 and plug the other iPod model from the table below insert (iPod must not be in a skin or end into a wall socket. and place insert in dock. case). iPod will charge while docked. Never dock an iPod without Press iPod Button on iH11 to play an insert in place. iPod. iPod Touch 3rd Gen nano thin iPod
ページ5に含まれる内容の要旨
Controls and Indicators Front Panel Alarm Set / Alarm On/Off Button iPod Dock Power Off / iPod Play/Pause Button Alarm Reset Button Hour Set Button Snooze/Dimmer Button Sleep/Minute Set Button Volume + Button Volume - Button Remote Sensor Back Panel Clock Adj. Button dst EXB Expanded Bass Switch DST Switch -1 +1 on o DC Jack Line-in Jack line in clock adj. DC 10V 2
ページ6に含まれる内容の要旨
iH11 Display PM Indicator Battery Low Indicator Daylight Saving Time Indicator iPod Indicator Time Display Alarm Indicator Sleep Indicator Install Clock Backup Battery The iH11 uses a CR2032 button cell backup battery system to provide continuous alarm operation and clock settings in the event of a power failure. If the Backup Battery has been installed and a power failure occurs or the AC adaptor is accidentally disconnected, the display backlight will not remain lit, but current time a
ページ7に含まれる内容の要旨
Using The Optional Remote Control Unit iPod Play/Pause Button Power Off /Alarm Reset Button Forward Button Reverse Button Volume - Button Volume + Button Sleep Button Mute Button Snooze/Dimmer Button Install/Replace the Remote Control Battery The remote control battery is already installed at the factory. When the remote control stops operating or its range seems reduced, it is time to replace the battery with a new one. 1. The battery door is located on the b
ページ8に含まれる内容の要旨
Setting Up the iH11 Setting the Clock Time Note: Press the Clock Adj. Button once during normal operation to view the current time display format (12 hour or 24 hour format). 12 hour is the default format. 1. Press and hold the Clock Adj. Button for 2 seconds until the display flashes. Press the Hour Set Button until the current hour is displayed. Next, press the Sleep/Minute Set Button to set the current minute. 2. Press the Clock Adj. Button again to confirm the clock setting. Yo
ページ9に含まれる内容の要旨
Listening to your iPod 1. Dock the already playing iPod. The iH11 will automatically turn on and you will hear the music playing from your iPod. The iPod Icon will appear at the right lower corner the display, indicating iPod playing mode. For enhanced bass, slide the EXB Expanded Bass Switch located on the back of the unit to the ON position. Note: If the playing song/music loudness is too low on the iPod itself, the iH11 may not detect that the iPod is in play mode. Press the iPod Play/
ページ10に含まれる内容の要旨
Alarm Operation The iH11 Home System for iPod features “Sure Alarm”. If a power failure occurs or the AC adaptor is accidentally disconnected, the unit will change to buzzer alarm to wake you up (provided you have installed backup battery). This unit also features Gentle Waking, which gradually increases the volume of whatever alarm you set. NOTE: TO WAKE TO iPod, YOUR iPod MUST BE PROPERLY DOCKED AND OFF (NOT IN PLAY MODE) OR NO ALARM WILL SOUND. You CANNOT wake to Line in au
ページ11に含まれる内容の要旨
Sleep Operation 1. When the iH11 is off or while listening to your iPod, press the Sleep/Minute Set Button to enter sleep mode. The Sleep Icon will appear on the display to indicate it is in sleep mode. Sleep mode has a Gentle Sleep feature which gradually lowers the volume before it shuts off. 2. You can adjust the sleep timer from 90, 60, 30 or 15 minutes by pressing the Sleep/Minute Set Button again.The unit will automatically turn off after the selected time. 3. When the display chan
ページ12に含まれる内容の要旨
A Consumer Guide to Product Safety When used in the directed manner, this unit has been designed and manufactured to ensure your personal safety. However, improper use can result in potential electrical shock or fire hazards. Please read all safety and operating instructions carefully before installation and use, and keep these instructions handy for future reference. Take special note of all warnings listed in these instructions and on the unit. 1. Water and Moisture – The unit should n
ページ13に含まれる内容の要旨
Trouble Shooting Symptom Possible Problem Solution Unit doesn’t respond AC adaptor isn’t plugged to a wall outlet or Plug the AC adaptor into a wall outlet and plug the connector into (no power) the connector is not plugged into the power the power supply jack on the unit supply jack on the back of the unit Wall outlet is not functioning Plug another device into the same outlet to confirm the outlet is working iPod cannot dock Using no or wrong iPod insert Make sure the dock insert is the prop
ページ14に含まれる内容の要旨
Solución De Problemas Síntoma Posible Problema Solución La unidad no El adaptador de AC no está conectado al Conecte el adaptador de AC al tomacorriente y también funciona (no circula tomacorriente o el conector no está conectado conecte el conector a la ficha en la parte posterior de la unidad corriente eléctrica) a la ficha en la parte posterior de la unidad El tomacorriente no funciona Coloque otro aparato en ese mismo tomacorriente para confirmar si el que no funciona es el tomacorriente
ページ15に含まれる内容の要旨
Limited 90-Day Warranty Information iHome Products, a division of SDI Technologies Inc. (hereafter referred to as SDI Technologies), warrants this product to be free from defects in workmanship and materials, under normal use and conditions, for a period of 90 days from the date of original purchase. Should this product fail to function in a satisfactory manner, it is best to first return it to the store where it was originally purchased. Should this fail to resolve the matter and service stil
