ページ1に含まれる内容の要旨
Owner’s manual
E
DUCATI620Sport
1
ページ2に含まれる内容の要旨
E 2
ページ3に含まれる内容の要旨
Hearty welcome among Ducati fans! Please accept our Note best compliments for choosing a Ducati motorcycle. We Ducati Motor Holding S.p.A. declines any liability think you will ride your Ducati motorcycle for long whatsoever for any mistakes incurred in drawing up this journeys as well as short daily trips. Ducati Motor Holding manual. The information contained herein is valid at the S.p.A. wishes you smooth and enjoyable riding. time of going to print. Ducati Motor Holding S.p.A. We are steadil
ページ4に含まれる内容の要旨
TABLE OF CONTENTS Rear brake pedal 24 Gear change pedal 24 Setting the gear change and rear brake pedals 25 Main components and devices 26 Location 26 Tank filler plug 27 Seat catch and helmet hooks 28 General 6 Side stand 29 Warranty 6 Shock absorber adjusters 30 E Symbols 6 Shock absorber 31 Useful information for safe riding 7 Carrying the maximum load allowed 8 Directions for use 32 Identification data 9 Running-in recommendations 32 Pre-ride checks 33 Co
ページ5に含まれる内容の要旨
Charging the battery 50 Routine maintenance record 84 Chain adjustment 51 Chain lubrication 52 Replacing bulbs 53 Beam setting 57 Tyre pressures 58 Checking engine oil level 60 Cleaning and replacing the spark plugs 61 Cleaning the motorcycle 62 Storing the bike away 63 E Important notes 63 Technical data 64 Overall dimensions 64 Weights 64 Top-ups 65 Engine 66 Timing system 66 Performance data 67 Brakes 67 Transmission 68 Frame 69 Wheels 69 Tyres 69 Spar
ページ6に含まれる内容の要旨
GENERAL Symbols Ducati Motor Holding S.p.A. advises you to read this booklet carefully so as to become familiar with your motorcycle. In case of any doubts, please call a Ducati Dealer or Authorised Workshop. The information contained herein will prove useful on your trips - and Ducati Motor Holding S.p.A. wishes you smooth, enjoyable riding - and will help you keep the performance Warranty of your motorcycle unchanged for a long time. In your own interest, and in order to guarantee product E r
ページ7に含まれる内容の要旨
Useful information for safe riding Always signal your intention to turn or pull to the next lane in good time using the suitable turn indicators. Warning Be sure you are clearly visible and do not ride within the Read this section before riding your motorcycle. blind spot of vehicles ahead. Be very careful when tackling road junctions, or when Accidents are frequently due to inexperience. Always riding in the areas near exits from private grounds, car make sure you have your licence with you whe
ページ8に含まれる内容の要旨
Carrying the maximum load allowed Your motorcycle is designed for long-distance riding, carrying the maximum load allowed in full safety. Even weight distribution is critical to preserving these safety features and avoiding trouble when performing sudden manoeuvres or riding on bumpy roads. Information about carrying capacity The total weight of the motorcycle in running order including rider, pillion passenger, luggage and additional E accessories should not exceed 385 Kg. Arrange your luggage
ページ9に含まれる内容の要旨
Identification data All Ducati motorcycles have two identification numbers, for frame (fig. 1) and engine (fig. 2). Frame number Engine number E Note These numbers identify the motorcycle model and should always be indicated when ordering spare parts. fig. 1 fig. 2 9
ページ10に含まれる内容の要旨
CONTROLS 1 3 6 Warning This section details the position and function of all E the controls you need to drive your motorcycle. Be sure to read this information carefully before you use the 8 4 controls. 7 5 Position of motorcycle controls (fig. 3) 2 1) Instrument panel. 2) Key-operated ignition switch and steering lock. 3) Left switch. 9 4) Clutch lever. 10 5) Cold start lever. 6) Right switch. 7) Throttle twistgrip. 8) Front brake lever. 9) Gear change pedal. 10) Rear brake pedal. fig. 3 10
ページ11に含まれる内容の要旨
7) Orange EOBD light Instrument panel (fig. 4) When on, engine operation is inhibited. It goes out after a 1) Blue light . few seconds (usually 1.8 - 2 sec.). Comes on when high beam is on. 8) Speedometer (km/h). 2) Green light . Gives road speed. Comes on and flashes when a turn indicator is on. a) LCD (1): 3) Yellow light . - Odometer (km). Comes on when there are about 4 liters fuel left in the Gives total distance covered. tank. - Trip meter (km). 4) Green light N. Give
ページ12に含まれる内容の要旨
LCD unit functions When the ignition key is turned to ON, the instrument OFF panel carries out a Check of all instruments (pointers, display, lights) (see fig. 5 and 6). 120 140 LCD (1) 6 7 100 160 5 8 80 180 Turn the key to ON and press (B) (fig. 6) to display trip 4 60 200 9 meter and odometer alternatively. 3 220 40 2 10 20 240 Resetting the trip meter 1 E -1 0 km/h 260 0 min X1000 11 Keep (B) pressed (fig. 6) for more than 2 seconds. When the TRIP function is enabled (trip meter), display (L
ページ13に含まれる内容の要旨
Oil temperature When the oil temperature goes below 50 °C (122 °F), "LO" will be displayed. "HI" will be displayed when the temperature exceeds 170 °C (338 °F). Fuel light "FUEL" will be displayed when the fuel warning light E comes on. Maintenance indicator After the first 1,000 Km/621 m and then every 10,000 Km/ 6210 m, "MAInt" will be displayed for 5 seconds when turning the key to ON. It reminds you of the routine maintenance servicing to be done. Instrument panel lighting Turn the key
ページ14に含まれる内容の要旨
The immobilizer system The key A performs the same functions as the keys B, For improved anti-theft protection, the motorcycle is and is also used to wipe off and re-program other black equipped with an IMMOBILIZER, an electronic system keys, if needed. that inhibits engine operation whenever the ignition switch is turned off. Note Accommodated in the handgrip of each ignition key is an The three keys have a small plate (1) attached that electronic device that modulates an output signal. This re
ページ15に含まれる内容の要旨
Code card The keys come with a CODE CARD (fig. 8) that reports: A) (fig. 9) the electronic code to be used to be used in case of engine block, i.e. bike did not start after key-ON. B) (fig. 9) the part no. code for the keys to be reported to the DUCATI Service network when you are ordering any duplicate keys. E Important Keep the CODE CARD in a safe place. However, it is advisable to keep the electronic code printed on the CODE CARD handy when you ride your motorcycle, in fig. 8 case it is neces
ページ16に含まれる内容の要旨
Procedure to disable immobilizer engine block Note through throttle twistgrip Should the throttle twistgrip be released before the 1) Turn the key to ON and fully open throttle. Keep it set time, the warning light turns on again. It is then open. The EOBD warning light turns off after 8 seconds. necessary to bring the key to OFF and restart the 2) Release the throttle as soon as the EOBD warning procedure from point (1). light turns off. 3) EOBD pilot light will flash. Count a number of flashes
ページ17に含まれる内容の要旨
Operation Duplicate keys When the ignition key is turned to OFF, the immobilizer If you need any duplicate keys, contact the DUCATI inhibits engine operation. Service network with all the keys you have left and your When the ignition key is turned back to ON to start the CODE CARD. engine, the following happens: DUCATI Service will program new keys and re-program 1) if the CPU recognised the code, the CODE light on the your original keys, up to 8 keys in total. instrument panel will flash briefl
ページ18に含まれる内容の要旨
LOCK P N Ignition switch and steering lock (fig. 10) A It is located in front of the fuel tank and has four B positions: A) ON: lights and engine on; B) OFF: lights and engine off; C) LOCK: steering locked; C D) P: parking light and steering lock. D Note To move the key to the last two positions, press it E down before turning it. Switching to (B), (C) and (D), you will be able to take the key out. Warning fig. 10 This vehicle is equipped with an energy-saving CPU. If the key stays ON for a lo
ページ19に含まれる内容の要旨
Left switch (fig. 11) 1) Dip switch, light dip switch, two positions: 4 position = low beam on; position = high beam on. 1 2) Switch = 3-position turn indicator: centre position = OFF; position = left turn; position = right turn. To reset turn indicators, turn switch to central position E and push in. 3) Button = warning horn. 2 3 fig. 11 4) Button = high-beam flasher. 19
ページ20に含まれる内容の要旨
Clutch lever (fig. 12) When you pull in the lever (1), you will disengage the engine from the gearbox and therefore from the driving wheel. Using the clutch properly is essential to smooth riding, especially when moving off. Important Using the clutch properly will avoid damage to transmission parts and spare the engine. E Note It is possible to start the engine with side stand down and the gearbox in neutral. When starting the bike with a gear engaged, pull the clutch lever (in this case the 1
