Stiga SILENCIUM 8217-3033-01の取扱説明書

ページ1に含まれる内容の要旨

D
DEUTSCH
8217-3033-01
Silencium

ページ2に含まれる内容の要旨

S SVENSKA 1. 2. 2

ページ3に含まれる内容の要旨

S SVENSKA 3. 4. 3

ページ4に含まれる内容の要旨

GB ENGLISH  Faulty or damaged parts in the device must be GENERAL replaced immediately.  Never reach into the filling or ejection opening Your garden shredder is a high-quality, efficient when the machine is running. machine.  Do not spray machine with water (this is haz- Please read the following instructions carefully to ardous due to live components). ensure a long life of your garden shredder.  Wear safety gloves during assembly and clean- Do not operate machine before having ing work. r

ページ5に含まれる内容の要旨

GB ENGLISH The cutter automatically draws the shredding ma- CHANGING THE DIRECTION OF terial into the machine through the slow rotation of ROTATION the cutting rollers. Always switch the device off, wait until it comes to If the machine is overloaded, a protective motor a standstill and shift the safety catch before chang- switch ensures that the machine turns itself off au- ing the direction of rotation. tomatically: - turn the shredder on again after about 5 minutes. left position: cutting rol

ページ6に含まれる内容の要旨

GB ENGLISH Generally garden shredders require little mainte- SERVICE nance. To maintain their efficiency and a long life, observe the following: Authorised service agents carry out repairs and - keep vent slits clean and free from obstructions. service. They use genuine spare parts. - check the locking screws (tighten where ne- cessary). Do you do basic repairs yourself? Then make sure - clean the device after shredding. you use genuine spare parts. They fit immediately - the shredder should not

ページ7に含まれる内容の要旨

GB ENGLISH OPERATIONAL FAULTS Problem Possible cause Remedy Motor does not start. - No power supply. -Checkfuses. - Mains cable defective. - Have these checked (electrician). - Machine overloaded. - Overload protection triggered Turn On- Offswitchto“0”andlet machinecool down. Motor hums but does not - Cutting roller blocked. - TurnOn-Offswitchtoleft,thenswitch start. machine off and remove shredding ma- terial. If the blockage cannot be re- moved immediately switch the On-Off switch between cutt