ページ1に含まれる内容の要旨
INSTALLATION AND
OPERATION MANUAL
CG-48F, CG-60F AND CG-72F
PRODUCTION GRIDDLES
PLEASE READ ALL SECTIONS OF THIS MANUAL
FOR YOUR SAFETY:
AND RETAIN FOR FUTURE REFERENCE .
DO NOT STORE OR USE GASOLINE
THIS PRODUCT HAS BEEN CERTIFIED AS
OR OTHER FLAMMABLE VAPORS OR
COMMERCIAL COOKING EQUIPMENT AND
LIQUIDS IN THE VICINITY OF
THIS OR ANY OTHER MUST BE INSTALLED BY PROFESSIONAL
APPLIANCE
PERSONNEL AS SPECIFIED .
IN THE COMMONWEALTH OF MASSACHUSETTS
WARNING:
THIS PRODUCT MUST BE INSTALLED B
ページ2に含まれる内容の要旨
IMPORTANT INFORMATION WARNING: This product contains chemicals known to the state of california to cause cancer and/or birth defects or other reproductive harm. Installation and servicing of this product could expose you to airborne particles of glass wool/ceramic fibers. Inhalation of airborne particles of glass wool/ceramic fibers is known to the state of california to cause cancer. Operation of this product could expose you to carbon monoxide if not adjusted properly. Inhalation of carbon
ページ3に含まれる内容の要旨
TABLE OF CONTENTS IMPORTANT INFORMATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2 . . . . . . . . . . . . DIMENSIONS AND SPECIFICATIONS . . . . . . . . . . . . . . . . . . . . . . . . . 4 . . . . . . . . . INSTALLATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4 . . . . . . . . . . . . . . . . Serial Plate Location . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4 . . . . . . . . . . . . . . . . . . . . Gene
ページ4に含まれる内容の要旨
DIMENSIONS AND SPECIFICATIONS INSTALLATION NOTES MINIMUM SUPPLY PRESSURE REQUIRED ELECTRICAL CHARACTERISTICS Combustible Wall Clearances Natural Propane Specifications 7" W .C . (17 .4mbar) 11" W .C . (27 .4mbar) 120 V, Single Phase, 60Hz, 1 amp Sides Back MANIFOLD PRESSURE REQUIRED, 6' (1829mm) AFTER BUILT-IN REGULATOR power supply cord provided 6" (152mm) 6" (152mm) .5” W .C . (8 .75 mbar) 10” W .C . (25mbar) • Gas Input Ratings shown are for • IMPORTANT: Unit must be • NOTE: No cord
ページ5に含まれる内容の要旨
INSTALLATION Continued We suggest installation, maintenance and repairs should be NOTE: The griddle plate may not rest performed by your local authorized service agency listed in evenly on the unit body if the unit is your information manual pamphlet . not properly leveled . 1/2" 1/2" In the event you have any questions concerning the 5 . Each caster has a threaded stem (13mm) (13mm) installation, use, care or service of the product, write or call to aid in leveling only . No caster MAX MAX
ページ6に含まれる内容の要旨
INSTALLATION Continued 4 . The appliance must be isolated from the gas supply WARNING: Electrical Grounding Instructions piping system by closing its individual manual shut off 1 . This appliance is equipped with a three prong valve during any pressure testing of the gas supply piping (grounding) plug for your protection against shock system at test pressures equal to or less than 1/2 PSIG . hazard and should be plugged directly into a properly ( . 45 KPA) . grounded three prong receptac
ページ7に含まれる内容の要旨
OPERATION INSTRUCTIONS Note: During an electrical power interruption, turn power Lighting Instructions switch to the “OFF” position . This unit cannot be made to 1 . First, make certain that the main power switch is set to operate without electrical power . “OFF” Shut Down Instructions 2 . Connect an electrical power cord to 120 volt supply . 1 . Turn main power switch to “OFF” (thermostat dial settings . Turn the gas shut off valve to the “OPEN” position (valve may be left at their set
ページ8に含まれる内容の要旨
ADJUSTMENTS Continued NOTE: Make certain no electrical connections have been indicator goes OFF note the temperature . The measured disturbed . Replace both panels and secure to body . temperature at the time the amber indicator switches off should be no more than ± 5°F from the set temperature . The griddle thermostat is a precision instrument . It is If the error is greater than ±5°F, but less than ± 10° F, then carefully calibrated at the factory so that the dial setting firmly grasp t
ページ9に含まれる内容の要旨
MAINTENANCE & CLEANING 2 . Using a clean cloth, rub a thin and even layer of oil into Stainless Steel the griddle surface . Stainless steel should be cleaned using a mild detergent, . Remove the grease drawer, empty and wash thoroughly a soft cloth and hot water . If it is necessary to use a non- with soap & water . Replace . metallic scouring pad, always rub in the direction of the grain in the metal to prevent scratching . Wash a small area at a Cleaning Instructions (For Heavy Build U
ページ10に含まれる内容の要旨
MAINTENANCE & CLEANING Continued Don’ts . Do not use the griddle as a hot top . A large pan or pot will trap heat and can cause the griddle plate to warp . 1 . Do not use salt to clean the griddle surface . Salt is corrosive and can cause pitting of the griddle . 4 . Do not overheat the griddle to preheat faster . Preheating only takes 15 – 20 minutes . 2 . Do not allow metal utensils (Spatula, scraper, etc . ) to nick and/or dent the surface of the griddle . The edges of these utensils a
ページ11に含まれる内容の要旨
TROUBLE SHOOTING GUIDE PROBLEM CHECKS REQUIRED ACTION REQUIRED 1 . No Heat Is cord set plugged into receptacle? Connect cord to receptacle or check fuse/ breaker Is Manual Gas Valve turned to “ON”? Turn Manual Gas Valve to “ON” Is Main Power switch indicator Turn Main Power switch to “OFF” wait 5 illuminated? minutes, then turn Main power switch to “ON” . If condition persists, send for a qualified service technician . 2 . One Zone Not Hot Enough Is thermostat set to correct Reset the thermos
ページ12に含まれる内容の要旨
