ページ1に含まれる内容の要旨
staple gun with 5/16” long
staples
Model 95718
asseMbly and operation instructions
Due to continuing improvements, actual product may differ slightly from the product described herein.
®
3491 Mission Oaks Blvd., Camarillo, CA 93011
Visit our website at: http://www.harborfreight.com
t o preVent serious injury, read and understand
all warnings and instructions before use.
© ®
Copyright 2007 by Harbor Freight Tools . All rights reserved. No portion of this
manual or any artwork contained herei
ページ2に含まれる内容の要旨
specifications Black injection molded Construction/Material housing, thermoplastic handle, steel casing Dimensions 7-1/8” L, 1-5/8” W, 5-13/16” H Activation type Squeeze lever Up to 80 T 50 staples, 3/8 Staples accepted crown width; from 1/4” to 5/8” long Dimensions 4-3/16” l, 9/16” W, 5/8” H save this Manual You will need this manual for the safety warnings and precautions, assembly, oper- ating, inspection, maintenance and cleaning procedures, parts list and assembly diagram. Keep your
ページ3に含まれる内容の要旨
5. do not overreach. Keep proper footing and balance at all times. Proper footing and balance enables better control of this product in unexpected situations. 6. use safety equipment. a lways wear eye protection. Always wear ANSI-approved safety goggles when working with this tool. 7. use clamps (not included) or other practical ways to secure and support the workpiece to a stable platform. Holding the work by hand or against your body is unstable and may lead to loss of control. 8. do
ページ4に含まれる内容の要旨
unpacKing When unpacking, check to make sure that the item is intact and undamaged. If any parts are missing or broken, please call Harbor Freight Tools at the number shown on the cover of this manual as soon as possible. asseMbly instructions note: For additional information regarding the parts listed in the following pages, refer to the Assembly Diagram near the end of this manual. loading the staples 1. Pinch the clip located on the end of the Magazine Unit (2). Pull out the Magazine Un
ページ5に含まれる内容の要旨
Staple tips face upward Staple Channel (3) Figure 2 operating the staple gun 1. Determine whether or not the object being stapled will necessitate extra force from the Staple Gun. This will depend primarily on the thickness of the item being stapled. For instance, a large pad of papers will need more force than one or two sheets being stapled together. 2. Set the Force Selection Lever (4) to either “Normal” or “Max”-see Figure 3. Force Selection Lever (4) Figure 3 3. Place the item that you
ページ6に含まれる内容の要旨
inspection, Maintenance, and cleaning 1. before each use , inspect the general condition of the product. Check for misalignment or binding of moving parts, cracked or broken parts and any other condition that may affect its safe operation. do not use damaged equipment. 2. Remove dirt and debris from the Staple Gun using a clean, soft cloth. Do not use flammable corrosive or abrasive solvents to clean the Staple Gun. troubleshooting problem possible causes probable solutions Staple Gun does
ページ7に含まれる内容の要旨
parts diagraM 1 4 3 2 Staples (5) not shown warranty LIMIted LIfetIMe w ArrAnty Harbor Freight Tools Co. makes every effort to assure that its products meet high quality and durability standards, and warrants to the original purchaser that this product is free from defects in materials and workmanship for the life of the product. This warranty does not apply to damage due directly or indirectly to misuse, abuse, negligence or accidents; repairs or alterations outside our facilities; or to
