ページ1に含まれる内容の要旨
DO NOT
DISCARD
Owner’s Manual
Installation and Operation
Models:
ESCAPE-I35-C
ESCAPE-I35LP-C
ESCAPE-I30-C
ESCAPE-I30LP-C
NOTICE
DO NOT DISCARD THIS MANUAL
• Important operating • Read, understand and follow • Leave this manual with
and maintenance these instructions for safe
party responsible for use
instructions included. installation and operation.
and operation.
WARNING
WARNING: If the information in these
HOT SURFACES!
instructions is not followed exactly, a fi re
Glass and other surfac
ページ2に含まれる内容の要旨
Read this manual before installing or operating this appliance. Please retain this owner’s manual for future reference. This Owner’s Manual should be retained for future A. Congratulations reference. We suggest that you keep it with your other Congratulations on selecting a Heat & Glo gas fi replace, an important documents and product manuals. elegant and clean alternative to wood burning fi replaces. The information contained in this Owner’s Manual, unless The Heat & Glo gas fi replace you h
ページ3に含まれる内容の要旨
Safety Alert Key: • DANGER! Indicates a hazardous situation which, if not avoided will result in death or serious injury. • WARNING! Indicates a hazardous situation which, if not avoided could result in death or serious injury. • CAUTION! Indicates a hazardous situation which, if not avoided, could result in minor or moderate injury. • NOTICE: Used to address practices not related to personal injury. Table of Contents A. Congratulations . . . . . . . . . . . . . . . . . . . . . . . . . . . .
ページ4に含まれる内容の要旨
B. Limited Lifetime Warranty Hearth & Home Technologies Inc. LIMITED LIFETIME WARRANTY Hearth & Home Technologies Inc., on behalf of its hearth brands (”HHT”), extends the following warranty for HHT gas, wood, pellet, coal and electric hearth appliances that are purchased from an HHT authorized dealer. WARRANTY COVERAGE: HHT warrants to the original owner of the HHT appliance at the site of installation, and to any transferee taking ownership of the appliance at the site of installation within
ページ5に含まれる内容の要旨
B. Limited Lifetime Warranty (continued) WARRANTY CONDITIONS: WARRANTY EXCLUSIONS: - - - - - This warranty is void if: LIMITATIONS OF LIABILITY: 4021-645C 12-29-10 Page 2 of 2 Heat & Glo • Escape-I35-C, Escape-I30-C • 2201-901 Rev. H • 5/12 5
ページ6に含まれる内容の要旨
Listing and Code Approvals 1 1 A. Appliance Certifi cation D. High Altitude Installations NOTICE: If the heating value of the gas has been reduced, MODELS: ESCAPE-I30-C, ESCAPE-I30LP-C, these rules do not apply. Check with your local gas utility ESCAPE-I35-C, ESCAPE-I35LP-C or authorities having jurisdiction. LABORATORY: Underwriters Laboratories, Inc. (UL) When installing above 2000 feet elevation: TYPE: Vented Gas Appliance Heaters • In the USA: Reduce input rate 4%
ページ7に含まれる内容の要旨
User Guide Operating Instructions 2 2 • Keep remote controls out of reach of children. A. Gas Fireplace Safety • Never leave children alone near a hot fi replace, whether operating or cooling down. WARNING • Teach children to NEVER touch the fi replace. HOT SURFACES! Glass and other surfaces are hot during • Consider not using the fi replace when children will be operation AND cool down. present. Hot glass will cause burns. Contact your dealer for more information, or visit: www. • DO NOT t
ページ8に含まれる内容の要旨
CLEAR SPACE 3 FT. IN FRONT OF FIREPLACE C. Fan Kit (optional) E. Decorative Doors, Fronts and Surrounds If desired, a fan kit may be added. Contact your dealer to WARNING! Risk of Fire! Install ONLY doors, fronts or order the correct fan kit. surrounds approved by Hearth & Home Technologies. Unapproved doors or fronts may cause appliance to over- D. Clear Space heat. WARNING! DO NOT place combustible objects in front This appliance has been supplied with an integral of the fi replace or bl
ページ9に含まれる内容の要旨
H. IPI Battery Tray/Battery Installation I. Control Module Operation TM The IntelliFire Plus system has a battery backup option. 1. The control module has an ON/OFF/REMOTE selector Battery longevity and performance will be affected by the switch that must be set. See Figure 2.6. service temperatures of this appliance. OFF Position: Appliance will ignore all power inputs and NOTICE: Batteries should only be used as a power source will not respond to any commands from a wall switch or i
ページ10に含まれる内容の要旨
5. Module Reset Switch J. Before Lighting Fireplace This module may lock-out under certain conditions. Before operating this fi replace for the fi rst time, have a When this occurs, the appliance will not ignite or qualifi ed technician: respond to commands. The module will go into lock-out • Verify all shipping materials have been removed from mode by emitting three audible beeps, then continuously inside and/or underneath the fi rebox. displaying a RED/GREEN error code at its status indi
ページ11に含まれる内容の要旨
K. Lighting Instructions (IPI) FOR YOUR SAFETY LIGHTING READ BEFORE LIGHTING INSTRUCTIONS (IPI) WARNING: If you do not follow these instructions exactly, a fi re or explosion 1. This appliance is equipped with an ignition may result causing property damage, personal injury or loss of life. device which automatically lights the burner. DO NOT try to light the burner by hand. • Immediately call your gas supplier A. This appliance is equipped with an intermittent pilot ignition (IPI) device fr
ページ12に含まれる内容の要旨
L. After Appliance is Lit Initial Break-in Procedure • The appliance should be run three to four hours continuously on high. • Turn the appliance off and allow it to completely cool. • Remove fi xed glass assembly. See Section 12.I. • Clean fi xed glass assembly. See Section 3. • Replace the fi xed glass assembly and run continuously on high an additional 9 hours. This cures the materials used to manufacture the fi re- place. NOTICE! Open windows for air circulation during ap- pliance break-in. •
ページ13に含まれる内容の要旨
Maintenance and Service 3 3 Doors, Surrounds, Fronts Any safety screen or guard removed for servicing must be replaced prior to operating the appliance. Frequency: Annually By: Homeowner When properly maintained, your appliance will give you many years of trouble-free service. We recommend an- Tools needed: Protective gloves, stable work surface nual service by a qualifi ed technician. • Assess condition of screen and replace as necessary. A. Maintenance Tasks-Homeowner • Inspect for
ページ14に含まれる内容の要旨
• Remove all foreign objects. Venting • Verify unobstructed air circulation. Frequency: Seasonally By: Homeowner Firebox Tools needed: Protective gloves and safety glasses. Frequency: Annually • Inspect venting and termination cap for blockage or obstruction such plants, bird nests, leaves, snow, debris, By: Service Technician etc. Tools needed: Protective gloves, sandpaper, steel wool, • Verify termination cap clearance to subsequent construc- cloths, mineral spirits, primer and touch-up
ページ15に含まれる内容の要旨
Burner Ignition and Operation Frequency: Annually By: Service Technician Tools needed: Protective gloves, vacuum cleaner, whisk broom, fl ashlight, voltmeter, indexed drill bit set, and a manometer. • Verify burner is properly secured and aligned with pilot or igniter. • Clean off burner top, inspect for plugged ports, corrosion or deterioration. Replace burner if necessary. • Replace Glowing embers with new dime-size pieces. DO NOT block ports or obstruct lighting paths. Refer to Sectio
ページ16に含まれる内容の要旨
Installer Guide Getting Started 4 4 A. Typical Appliance System NOTICE: Illustrations and photos refl ect typical installations and are for design purposes only. Illustrations/diagrams are not drawn to scale. Actual product may vary from pictures in manual VERTICAL TERMINATION CAP (SECTION 8.E) VENT PIPE (SECTION 8) 3 INCH FLEX LINERS (SECTION 8) MANTEL AND MANTEL LEG SECTION 5.B AND 11.A SURROUND OR FRONT NOT SHOWN SECTION 2.E AND SECTION 8 HEARTH EXTENSION GAS LINE (SECTION 9) ACCESS T
ページ17に含まれる内容の要旨
B. Design and Installation Considerations D. Inspect Appliance and Components Heat & Glo gas inserts are designed for installations into • Carefully remove the appliance and components from solid fuel masonry or factory built fi replaces that have the packaging. been installed in accordance with the National, Provin- • The vent system components and decorative doors and cial, State and local building codes. Fireplaces are to be fronts may be shipped in separate packages. constructed of non-c
ページ18に含まれる内容の要旨
Fireplace Size Requirements 5 5 • The metal fl oor of the solid fuel fi rebox may be removed A. Minimum Fireplace Opening to facilitate the installation of the insert. Minimum fi replace opening requirements are shown in • Cutting of any sheet metal parts of the fi replace in which Figure 5.2. the gas fi replace insert is to be installed is prohibited, WARNING! Risk of Fire or Burns! Provide adequate except the fl oor as tested for and as noted above and in clearance around air openings an
ページ19に含まれる内容の要旨
TOP VIEW A G** FRONT VIEW F E D H C B MINIMUM FIREPLACE SIZE ESCAPE-I35-C ESCAPE-I30-C ESCAPE-I35LP-C ESCAPE-I30LP-C Location Inches Millimeters Inches Millimeters A Rear Width 25-1/2 648 21-1/2 546 B Front Width 35 889 30-1/4 768 C Glass Opening Width 31-1/2 800 26-3/4 679 D Glass Opening Height 20 508 18 457 E Height-Front 24-7/8 632 22-7/8 581 F Height-Rear 22-1/4 565 20-5/8 524 G** Unit Depth 18-1/4 464 16-7/8 429 H Venting Depth 13-3/8 340 12-1/8 308 * Note: If exhaust collar on insert and
ページ20に含まれる内容の要旨
B. Mantel and Wall Projections WARNING! Risk of Fire! Comply with all minimum clear- EXISTING NON-COMBUSTIBLE FACING ances to combustibles as specifi ed. Framing or fi nishing material closer than the minimums listed must be construct- ed entirely of noncombustible materials (i.e., steel studs, 12 IN. concrete board, etc). MAX. Clearance to combustible material under the insert is 1/4 inch (6 mm). Clearance from top of fi replace opening for combustibles extending 12 inches max. is 12 inches.
