Honda Automobiles 08L07-SJC-100の取扱説明書

ページ1に含まれる内容の要旨

Accessory Application Publications No.
All 28614
MOTORCYCLE WHEEL GUIDE
INSTALLATION
RIDGELINE
Issue Date
P/N 08L07-SJC-100
INSTRUCTIONS
FEB 2005
Put this information in the glove box with the vehicle owner's manual.
PARTS LIST INSTALLATION
Customer Information: The information in this
installation instruction is intended for use only by
Front wheel guide
skilled technicians who have the proper tools,
equipment, and training to correctly and safely add
equipment to your vehicle. These procedures

ページ2に含まれる内容の要旨

2. Remove the front bed panel (six torx bolts). 4. While wearing eye protection, enlarge the eight holes to 9 mm from the outer surface side of the front bed panel. Remove all burrs from the edges of the holes with a file. DRILL (9 mm drill bit) FRONT BED PANEL FRONT BED (front surface) PANEL TORX BOLTS (6) 3929032H Installing one wheel guide in the center position HOLES (8) 3. Center punch the eight marked locations on the front bed panel. While wearing eye protection, drill a 3 mm hole through

ページ3に含まれる内容の要旨

Installing Wheel Guides in the Outer Positions (Two USE AND CARE kits are required)  Place the front wheel in the front wheel guide. 7. Center punch the 16 marked locations on the front Secure the bike with three tie-downs (commercially bed panel. While wearing eye protection, drill a 3 available) and attach the tie-downs to the tie-down mm hole through each of the 16 marked locations. hooks in the bed. Enlarge the 16 holes to 9 mm. Remove all burrs from the edges of the holes with a file. TIE-