ページ1に含まれる内容の要旨
Touch screen PLL clock radio
28034 Operating instructions
ページ2に含まれる内容の要旨
Illustration 2 1 Speaker 2 Snooze button 3 Volume control 4 Touch screen LCD display 1 3 4 5 Alarm icons 6 Memory preset button 7 Memory button 8 Display 9 Timer 5 10 Power / Sleep button 13 11 Mode button 12 Up / down buttons 12 6 13 Band button 11 7 10 8 9 2
ページ3に含まれる内容の要旨
Touch screen display Your alarm clock radio has a an innovative touch screen interactive display. Use the pad of your finger or use the touch screen pointer rod to operate (see diagram for location). We recommend the pointer rod to avoid finger prints. Light sensor Pull out the display Your alarm clock radio has a pull out display for easier viewing. Push to open and pull the display out as required. Push again to close. Pointer Electrical requirements Check the voltage on the rating plate of yo
ページ4に含まれる内容の要旨
Battery back-up facility (battery not included) Unit will work without a battery being fitted Your clock radio is equipped with a battery back-up facility. 1 Remove the battery compartment cover (underneath the unit) by pushing in the clip and lifting off. 2 Insert a battery size 9 volts PP3/6LR61 (Ensure battery is inserted correctly). 3 Replace the battery compartment cover. Should a power interruption occur the clock will continue to run, however, time keeping will not be accurate. The time w
ページ5に含まれる内容の要旨
3 Press the MODE button once, the current time will flash. You must adjust the time whilst the clock display is flashing. Repeatedly press the UP or DOWN buttons to change the time by 1 minute increments. Or hold down UP or DOWN buttons to change the clock rapidly. The minutes will carry over to the hours if, for example, the minutes change from 59 to 00 the hour will increment by 1. 4 The PM symbol will appear to indicate 12:00 midday has been reached. 5 Press the MODE button to confirm setting
ページ6に含まれる内容の要旨
Setting the alarms 1 You can set two independent alarms to sound (by buzzer or by radio) each day of the week (Monday to Sunday) or from Monday to Friday or only weekend. Repeatedly press the MODE button until the alarm 1 time appears and flashes. 2 Press the UP or DOWN to set the alarm time. 3 Repeatedly press the SNOOZE button to the set the alarm to sound every day. (SUN MON TUE WED THU FRI SAT appears) or Monday through to Friday (MON TUE WED THU FRI appears) or only Sunday and Saturday (SUN
ページ7に含まれる内容の要旨
Radio operation • To obtain maximum FM reception fully extend the wire FM aerial (which is located at the rear of the unit) and alter the direction of the wire for best results. • The aerial for the MW waveband is located inside the unit. To obtain maximum MW reception rotate the clock radio. 1 Press the POWER / SLEEP button. 2 Adjust the VOLUME control to a suitable level. 3 Press the BAND button to either MW or FM as desired. 4 Press UP or DOWN buttons to select the desired station. Hold UP or
ページ8に含まれる内容の要旨
Last station memory function The frequency of the last station tuned to before switching off the unit will be stored in the memory. When the unit is switched on again, it will receive this station in the respective waveband. When changing the waveband, the last station tuned to in each waveband will also be stored in the memory. Setting the sleep function • Repeatedly press POWER / SLEEP twice for 2 seconds, until the sleep icon and sleep time 10 appears. The radio turns on. • To increase the s
ページ9に含まれる内容の要旨
At the end of the preset time, the buzzer will sound and the timer icon will flash. Press TIMER button to switch off the buzzer. Using the display function 1 When the radio is on, each press of the DISPLAY button will display the following in turn: LCD display frequency clock + date year + date alarm 1 alarm 2 clock + temperature clock + second 2 In standby mode (with timer not set), each press of the DISPLAY button will display the following in turn: LCD display clock + date
ページ10に含まれる内容の要旨
Backlight When the mains power is connected to the unit, the backlight will always be on. It will dim automatically depending upon the darkness. The backlight will be extinguished in the event of a power cut and a backup battery is fitted. The display will still display the time. Warning labels WARNING: to reduce the risk of electric shock, do not expose this appliance to rain or moisture. ATTENTION: To reduce the risk of electric shock, do not remove the cover. There are no user serviceable par
ページ11に含まれる内容の要旨
Maintenance Do not expose your clock radio to extreme of temperatures. The product should be kept in a warm environment free from dust and damp. For external cleaning use only a soft, clean, damp cloth. Use of detergents may damage the finish. Technical specification AC Power supply : 230V 50Hz Battery back-up : 9V DC type 6LR61/PP3 (not included) Radio : FM 87.5MHz - 108MHz : MW 522Khz - 1620kHz VENTILATION WARNING The normal ventilation of the product shall not be impeded for intended use. HA
ページ12に含まれる内容の要旨
Guarantee Morphy Richards products are manufactured to internationally accepted quality standards. In addition to your statutory rights, Morphy Richards guarantee your product to be free from manufacturing and component defects for a period of TWO YEARS from date of purchase. If your product proves to be defective within 28 days of purchase, the Morphy Richards dealer from whom the product was purchased will be pleased to replace it free of charge. Should your product develop a defect within the
