ページ1に含まれる内容の要旨
DATA SHEET
SILICONDRIVE II 2.5" PATA DRIVE
SSD-DXXX(I)-4300
OVERVIEW SISECURE
The SiliconDrive II 2.5" PATA Drive is an SiZone Data zones with different
optimal time-to-market replacement for security parameters.
hard drives and flash cards or in host
SiKey Ties SiliconDrive to a specific
systems that require low power and
host and/or software IP.
scalable storage solutions.
SiProtect Protection software for
password-required, read/write,
SiliconDrive II technology is engineered
or read-only
ページ2に含まれる内容の要旨
REVISION HISTORY SSD-DXXX(I)-4300 DATA SHEET REVISION HISTORY Document No. Release Date Changes 4300D-00DSR February 27, 2009 Initial release. SILICONSYSTEMS PROPRIETARY This document and the information contained within it is confidential and proprietary to SiliconSystems, Inc. All unauthorized use and/or reproduction is prohibited. 4300D-00DSR PAGE II FEBRUARY 27, 2009
ページ3に含まれる内容の要旨
TABLE OF CONTENTS SSD-DXXX(I)-4300 DATA SHEET TABLE OF CONTENTS Overview.......................................................................................................................... i SiSecure........................................................................................................................... i Features........................................................................................................................... i Revision History...................
ページ4に含まれる内容の要旨
TABLE OF CONTENTS SSD-DXXX(I)-4300 DATA SHEET Task File Register Specification................................................................................. 27 ATA Registers............................................................................................................... 28 Data Register ............................................................................................................. 28 Error Register....................................................................
ページ5に含まれる内容の要旨
TABLE OF CONTENTS SSD-DXXX(I)-4300 DATA SHEET Read Sector — 20h, 21h...................................................................................... 56 Read Long Sector(s) — 22h, 23h......................................................................... 57 Read Verify Sector(s) — 40h, 41h ....................................................................... 58 Seek — 7Xh ......................................................................................................... 59 Set Fea
ページ6に含まれる内容の要旨
LIST OF FIGURES SSD-DXXX(I)-4300 DATA SHEET LIST OF FIGURES Figure 1: Physical Dimensions......................................................................................... 1 Figure 2: Pin Locations .................................................................................................... 2 Figure 3: Jumper Settings................................................................................................ 2 Figure 4: True IDE PIO Mode Read/Write Access Timing Diagram .......
ページ7に含まれる内容の要旨
LIST OF TABLES SSD-DXXX(I)-4300 DATA SHEET LIST OF TABLES Table 1: System Performance ......................................................................................... 3 Table 2: System Power Requirements ............................................................................ 3 Table 3: Reliability............................................................................................................4 Table 4: Operational Life Span ...............................................
ページ8に含まれる内容の要旨
LIST OF TABLES SSD-DXXX(I)-4300 DATA SHEET Table 28: ATA Command Set........................................................................................ 40 Table 29: Check Power Mode — 98h, E5h.................................................................... 42 Table 30: Executive Drive Diagnostic — 90h................................................................. 43 Table 31: Format Track — 50h...................................................................................... 44 Ta
ページ9に含まれる内容の要旨
LIST OF TABLES SSD-DXXX(I)-4300 DATA SHEET Table 57: Request Sense — 03h................................................................................... 71 Table 58: Extended Error Codes ................................................................................... 71 Table 59: Translate Sector — 87h................................................................................. 72 Table 60: Wear-Level — F5h................................................................................
ページ10に含まれる内容の要旨
PHYSICAL SPECIFICATIONS SSD-DXXX(I)-4300 DATA SHEET PHYSICAL SPECIFICATIONS The SiliconDrive II 2.5" PATA Drive products are offered in an industry- standard 2.5" PATA Drive form factor. See "Part Numbering" on page 77 for details regarding 2.5" PATA Drive capacities. PHYSICAL DIMENSIONS This section provides diagrams that describe the physical dimensions for the 2.5" PATA Drive. Figure 1: Physical Dimensions Dimension Millimeters Tolerance (mm) Dimension Millimeters Tolerance (mm) A 100.00 ±0.
ページ11に含まれる内容の要旨
PHYSICAL SPECIFICATIONS SSD-DXXX(I)-4300 DATA SHEET PIN LOCATIONS The following diagram identifies the pin locations of the 2.5" PATA Drive. Figure 2: Pin Locations JUMPER SETTINGS The following diagram defines the SiliconDrive II 2.5" PATA Drive jumper settings. Figure 3: Jumper Settings SILICONSYSTEMS PROPRIETARY This document and the information contained within it is confidential and proprietary to SiliconSystems, Inc. All unauthorized use and/or reproduction is prohibited. 4300D-00DSR PAG
ページ12に含まれる内容の要旨
PRODUCT SPECIFICATIONS SSD-DXXX(I)-4300 DATA SHEET PRODUCT SPECIFICATIONS Note: All SiliconDrive II 2.5" PATA Drive values quoted are typical at 25°C and nominal supply voltage. SYSTEM PERFORMANCE Table 1: System Performance Reset to Ready Startup Time (Typical/Maximum) 200ms/400ms Read Transfer Rate (Typical) 34MBps Write Transfer Rate (Typical) 19MBps Burst Transfer Rate 66MBps Controller Overhead (Command to DRQ) 2ms (maximum) SYSTEM POWER REQUIREMENTS Table 2: System Power Requirements DC
ページ13に含まれる内容の要旨
PRODUCT SPECIFICATIONS SSD-DXXX(I)-4300 DATA SHEET RELIABILITY Table 3: Reliability MTBF (@ 25ºC) 4,000,000 hours 14 Bit Error Rate <1 non-recoverable error in 10 bits read PROJECTED OPERATIONAL LIFE SPAN Table 4: Operational Life Span SiliconDrive Part# Capacity Service Life* GB Written per Day SSD-D032G-4300 32GB 217.6 Years @ 402.9GB SSD-D016G-4300 16GB 108.8 Years @ 402.9GB SSD-D008G-4300 8GB 54.4 Years @ 402.9GB SSD-D004G-4300 4GB 27.2 Years @ 402.9GB * There are unlimited read cycles. S
ページ14に含まれる内容の要旨
PRODUCT SPECIFICATIONS SSD-DXXX(I)-4300 DATA SHEET PRODUCT CAPACITY SPECIFICATIONS Table 5: Product Capacity Specifications Number of Product Capacity Number of Number of Number Sectors/ Capacity (Bytes) Sectors Cylinders of Heads Track 4GB 4,110,188,544 8,027,712 7964 16 63 8GB 8,195,604,480 16,007,04015,880 16 63 16GB 16,391,208,960 32,014,080 16,383 16 63 32GB 32,782,417,920 64,028,160 16,383 16 63 ENVIRONMENTAL SPECIFICATIONS Table 6: Environmental Specifications Temperature 0ºC to 70ºC
ページ15に含まれる内容の要旨
ELECTRICAL SPECIFICATION SSD-DXXX(I)-4300 DATA SHEET ELECTRICAL SPECIFICATION PIN ASSIGNMENTS The following table describes the SiliconDrive II 2.5" PATA Drive 44-pin IDE connector signals. Table 7: Pin Assignments Pin IDE-ATA Ultra DMA Pin IDE-ATA Ultra DMA 1 RESET# RESET# 2 GND GND 3 D7 D7 4 D8 D8 5 D6 D6 6 D9 D9 7D5 D5 8 D10 D10 9D4 D4 10 D11 D11 11 D3 D3 12 D12 D12 13 D2 D2 14 D13 D13 15 D1 D1 16 D14 D14 17 D0 D0 18 D15 D15 19 GND GND 20 KEY KEY 21 DMARQ DMARQ# 22 GND GND 23 IOWR# STOP 24
ページ16に含まれる内容の要旨
ELECTRICAL SPECIFICATION SSD-DXXX(I)-4300 DATA SHEET SIGNAL DESCRIPTIONS Table 8: Signal Descriptions Signal Name Pin(s) Type Description A2-A0 36, 33, I Address Inputs. These signals are 35 asserted by the host to access the task registers in the device. -CS0,-CS1 37, 38 I In the true IDE mode, -CS0 is the chip select for the task file registers while -CS1 is used to select the Alternate Status register and the Device Control register. -CSEL 28 I Cable Select. This internally pulled-up
ページ17に含まれる内容の要旨
ELECTRICAL SPECIFICATION SSD-DXXX(I)-4300 DATA SHEET Table 8: Signal Descriptions (Continued) Signal Name Pin(s) Type Description DMARQ 21 O DMA Request. This signal is used for DMA transfers between the host and device. DMARQ is asserted by the device when the device is ready to transfer data to/from the host. The direction of data transfer is controller by -IORD and -IOWR. This signal is used in a handshake manner with - DMACK (i.e., the device waits until the host asserts -DMACK befo
ページ18に含まれる内容の要旨
ELECTRICAL SPECIFICATION SSD-DXXX(I)-4300 DATA SHEET Table 8: Signal Descriptions (Continued) Signal Name Pin(s) Type Description DMARQ# This signal is a DMA request that is used for DMA data transfers between the host (UDMA and device. This signal is asserted by the protocol device when it is ready to transfer data to or active) from the host. For Multiword DMA transfers, the direction of data transfer is controlled by -IORD and -IOWR. This signal is used in a handshake manner with -
ページ19に含まれる内容の要旨
ELECTRICAL SPECIFICATION SSD-DXXX(I)-4300 DATA SHEET Table 8: Signal Descriptions (Continued) Signal Name Pin(s) Type Description IORDY 27 I I/O Channel Ready. The signal is negated to extend the host transfer cycle of any host (True IDE register access. mode) -IORD 25 I Device I/O Read. This is the read strobe signal from the host. The falling edge of (True IDE IORD enables data from the device onto mode) the data bus. The rising edge of IORD latches data at the host. The host does no
ページ20に含まれる内容の要旨
ELECTRICAL SPECIFICATION SSD-DXXX(I)-4300 DATA SHEET Table 8: Signal Descriptions (Continued) Signal Name Pin(s) Type Description HDSTROBE When UDMA mode DMA write is active in all modes, this signal is the data-out strobe (UDMA write generated by the host. Both the rising and protocol falling edge of HSTROBE cause data to be active) latched by the device. The host may stop generating HSTROBE edges to pause an UDMA data-out burst. KEY 20 - Key. Reserved for the Connector Key. STOP Whil
