ページ1に含まれる内容の要旨
Start
Here!
Quick Start Guide - next page
DSS
2115
Digital Spread Spectrum
provides the longest range,
the clearest sound
and the best privacy.
QUICK START
GUIDE
ページ2に含まれる内容の要旨
INSTALLATION & SAFETY Choosing the best location for your DSS2115 When choosing a location for your phone there are a number of appliances the phone should not be near, and areas you should avoid. ! CHOOSE - This symbol indicates a central location important operating and servicing instructions. AVOID - Television sets and AVOID - other electronic Microwave appliances ovens AVOID - Moisture AVOID - Computers AVOID - Other Cordless phones CHARGE - the new phone for 15 - 20 hrs and raise the DON’T
ページ3に含まれる内容の要旨
This page is a very condensed version of the Owners Manual. It is designed to allow you to get your phone installed and operating as quickly as possible - however it does not attempt to explain any of the advanced features of the DSS2115 . Start Here! Quick Start Guide Installing the Base Unit AC Adaptor cord the AC Adaptor into AC Adaptor cord Raise the antenna. Make sure the AC Adaptor remains switched ON at all times. Use only the Uniden AC Adaptor supplied with this unit. Telephone Cord AC
ページ4に含まれる内容の要旨
CAUTION fire, T860 Installing the Handset Battery Press the battery cover and slide it off. Connect the battery plug to the socket at the rear of the battery compartment. Make sure the plug is the right way round. Press firmly until it clicks into place. Position the battery in the compartment and slide the cover into place. NOTE Place the handset on the base Unit and charge it uninterrupted for 12 hours. Making a Call Answering a Call Pick up the handset and press . Han
ページ5に含まれる内容の要旨
CONTENTS i Installation & Safety ii, iii Quick Start Guide 1 Contents Controls & Functions 2, 3 Introduction 4 Welcome 4 Features 4 Included in your Package 4 Battery Maintenance 5 Battery use time (per charge) 5 When the Battery Charge becomes Low 5 Cleaning the Battery Contacts 5 Adjusting the Ringer and Earpiece Volume 6 Installing the Belt Clip 6 Headset Installation 6 Using Your New Phone 7 Making and Receiving Calls 7 Call Transfer 8 Redialling a Call 8 Travelling out of Range 9 Keylock /
ページ6に含まれる内容の要旨
* 6 9 # rocket/ C.wait 1 7 4 CONTROLS & FUNCTIONS 1 28/09 12:30 01 JIM STATEN 02 9599 3355 memory flash/ reg vol talk cid def 2abc 3 ghi jkl mno 5 pqrs wxy 8tuv 0 3 delete/ redial/P select page 15 16 17 1 Headset jack 10 Flash/Registration key 2 Belt clip slot 11 CID key 3 Battery compartment 12 Volume control keys 4 Memory key 13 Alpha Numeric keypad 5 Talk key 14 Delete/Page key 6 Rocket/C.Wait key 15 Select key 7 Handset aerial 16 Handset Microphone 8 Handset spea
ページ7に含まれる内容の要旨
18 Charging contacts 19 Base unit aerial 20 In Use/Charge LED 21 Page key 22 Telephone line 23 DC In 9V 24 Registration key 22 23 24 Rear of Base Unit Top of Base Unit 19 18 in use/ charge 20 page 21 900MHz 3 DIGIT AL SPREAD SPECTR UM
ページ8に含まれる内容の要旨
WELCOME Congratulations on your purchase of the Uniden DSS2115 cordless telephone. This phone is designed for reliability, long life and outstanding performance utilising the latest in 900 MHz Digital Spread Spectrum Technology. COMPANY PHILOSOPHY To bring outstanding wireless communication products to people’s lives throughout the world. FEATURES l 900MHz Digital Spread Spectrum Technology l Alpha display Caller ID l Multi Handset (capable of up to 7 handsets) l 2 way Communication: Handset to
ページ9に含まれる内容の要旨
BATTERY MAINTENANCE Battery use time (per charge) From fully charged 7.5 hours continuous use. NOTE 4 days when the handset is in the standby mode. Use only the genuine A full charge will take at least 12 hours if Low Battery is displayed - however the Uniden Battery supplied phone will be ready for a short call after one hour. with your phone. When the battery charge becomes low Replacement batteries are If the phone is not in use, Low Battery flashes and the keys will not operate if the phone
ページ10に含まれる内容の要旨
* 6 9 # rocket/ C.wait 1 7 4 ADJUSTING THE RINGER AND EARPIECE VOLUME Ringer tone and volume The phone has four ringer tone and volume RINGER A HIGH combinations. In the standby mode, press or on the handset repeatedly. The display shows the setting. Earpiece volume Pressing or during a call will change the TALK LOUD 1 earpiece volume of the handset. The telephone will keep this setting for all calls and display the setting for each call. Loud
ページ11に含まれる内容の要旨
* 6 9 # rocket/ C.wait 1 7 4 MAKING AND RECEIVING CALLS Basic phone operation When Handset When Handset On Base Off Base 28/09 12:30 01 JIM STATEN 02 9599 3355 memory flash/ reg vol talk cid button abc def 2 3 ghi jkl mno 5 pqrs 8tuv wxy 0 redial/P select delete/ page To answer 1. 1. INCOMING CALL INCOMING CALL a call (phone ringing) 2. Press . 2. Pick up handset. TALK LOUD 1 3. 3. TALK LOUD 1 - - Auto talk answers the call as soon as the handset is pi
ページ12に含まれる内容の要旨
CALL TRANSFER During a call, you can transfer the call to another optional handset (maximum 7 handsets). 1. Press . TRANSFER TO NOTE ( 1 7 HAND 2. Press [handset No. ]. The hanset number is shown on the right side of If the called handset is not the display. answered within 20 seconds, 3. Press . the call will return to the 4. Called handset rings and cal is transferred. original handset. REDIALLING A CALL The last three
ページ13に含まれる内容の要旨
Redial from talk mode TALK LOUD 1 1. Press . NOTE 2. Press - the last number dialed will be displayed and redialed. Only the last number dialed can be accessed TALK LOUD 1 95993355 after talk has been pressed. TRAVELLING OUT OF RANGE During a call, noise will increase if you move your handset too far from your base unit. If the range limit of your base unit is exceeded, your call will terminate within 10 seconds.
ページ14に含まれる内容の要旨
STORING PHONE NUMBERS AND NAMES Memory Dialing allows you to dial a number using just a few key strokes. You can store up to 59 phone numbers in the memory. MEMORY STORE Since each step must be completed within 10 01 EMPTY seconds, it may be advisable to review these instructions before starting. 02 EMPTY 1. Press and hold until MEMORY STORE is displayed. STORE NAME 01 2. Press or or enter a two digit NOTE number ( )
ページ15に含まれる内容の要旨
MAKING CALLS WITH MEMORY DIALLING Memory Dialling from Standby 1. Press once, the handset displays 01 FRED your programmed memory locations. 02 JOHN SMITH 2. Press and or enter a two-digit 03 KAY JONES number ( ) to select the memory 0 1 5 9 location you would like to dial. 3. Press - the displayed number is TALK LOUD 1 dialed. 0295993355 Display a Memory Number or Name Use and to
ページ16に含まれる内容の要旨
EDITING A STORED NAME AND PHONE NUMBER 1. Press and hold until MEMORY STORE MEMORY STORE is displayed. 01 FRED 2. Press and or enter a two-digit number 02 JOHN SMITH ( ) to select the memory 0 1 5 9 location you would like to edit. 3. Press - the screen displays the EDIT MEMORY 01 memory location number you have selected. DELETE MEMORY 01 4. Press or to select ‘Edit Memory’, then G
ページ17に含まれる内容の要旨
0 1 5 9
ページ18に含まれる内容の要旨
REGISTRATION The original handset supplied with the Main Base is already registered as Handset 1, this leaves Handset numbers 2 - 7 available. It is very important to allocate each handset a different number to enable functions such as Call Transfer. Registration Process Follow this process for each additional Handset (DSS2105) that needs to be registered to the Main Base If a handset is registered at or for registering your Main Handset. any time as handset 1, all 1. Remove the handset from it
ページ19に含まれる内容の要旨
CALLER ID You must subscribe to the Caller ID service from your local telephone company to use these features. When the telephone rings, the Caller ID feature allows you to view the caller’s name and NOTE phone number on the display before you answer the phone. The handset displays the phone number of the incoming call, the name, time and the number of calls. Additionally, you can Caller ID information may dial the displayed number and store the information for memory dialing. not be displayed
ページ20に含まれる内容の要旨
Viewing the Caller ID Message List The Caller ID list stores information for up to 60 incoming calls-even unanswered calls. 1. Press - the summary screen is displayed. HANDSET 1 The screen shows the number of new messages and total messages. NEW :1 2. Press to display the latest Caller ID TOTAL: 3 message. 3. Press to see the next message, or press 5/11 12:30 pm to see previous message. FRED 4. Press again to return to standby. 02 9597 9035 Delet
