ページ1に含まれる内容の要旨
Installation instructions
and User guide
Freestanding cooker
OR120 double oven models
GB IE
ページ2に含まれる内容の要旨
ページ3に含まれる内容の要旨
1 Contents Safety and warnings 2 Installation instructions 6 Maintenance instructions 13 Introducing your cooker 16 Using your cooktop 17 Cooktop troubleshooting 21 Using your ovens for the first time 22 Clock and timer 23 Using your oven 24 Cooking functions 25 Automatic cooking 27 Using the warmer drawer 28 Care and cleaning 29 Warranty and service 42 Important! SAVE THESE INSTRUCTIONS The models shown in this User Guide may not be available in all markets and are subje
ページ4に含まれる内容の要旨
2 Safety and warnings Installation WARNING! Electrical Shock Hazard Always disconnect the cooker from the mains electricity supply before carrying out any maintenance operations or repairs. Failure to do so may result in death or electrical shock. WARNING! Cut Hazard Take care - panel edges are sharp. Failure to use caution could result in injury or cuts. Important safety precautions General To avoid hazard, follow these instructions carefully before installing or using this product. Ple
ページ5に含まれる内容の要旨
3 Safety and warnings To connect the cooker to the mains, do not use adapters, reducers or branching devices as they can cause overheating and burning. This cooker must be connected to a suitable double pole control unit adjacent to the cooker. No diversity can be applied to this control unit. The cooker must be earthed. Gas This cooker is supplied for use with natural gas only, and cannot be used on any other gas without modification. See the ‘Maintenance instructions’ for modificati
ページ6に含まれる内容の要旨
4 Safety and warnings Operation Your freestanding cooker has been carefully designed to operate safely during normal cooking procedures. Please keep the following guidelines in mind when you are using it: WARNING! Explosion Hazard Do not store flammable materials such as gasoline near the cooktop. Do not store flammable material in the ovens or in the drawers. Do not spray aerosols near the cooktop during use. Failure to do so may result in death or serious injury. WARNING! Electric
ページ7に含まれる内容の要旨
5 Safety and warnings Important safety precautions Isolating switch: make sure this cooker is connected to a circuit which incorporates an isolating switch providing full disconnection from the power supply. Household appliances are not intended to be played with by children. Children, or persons with a disability which limits their ability to use the appliance, should have a responsible person to instruct them in its use. The instructor should be satisfied that they can use the applia
ページ8に含まれる内容の要旨
600 mm 6 Installation instructions Fig. 1 Location The installation conditions, concerning protection against overheating of the surfaces adjacent to the cooker, must conform to Fig.3a or 3b. The appliance must be kept no less than 200 mm away from any side wall which exceeds the height of the hob surface (Fig. 3a or 3b). The appliance must be housed in heat resistant units. The walls of the units must be capable of resisting temperatures of 75 °C above room temperature. Do not install the app
ページ9に含まれる内容の要旨
7 Installation instructions Class 1 Gas connection made using rubber hose which must be visible and easily inspected or using rigid or flexible metal pipe. Fig. 3a Class 2 Subclass 1 Gas connection made using rigid or flexible metal pipe. Fig. 3b 200 mm minimum 200 mm minimum 500 mm minimum 500 mm minimum 20 mm 20 mm 0 mm 0 mm 650 mm 650 mm minimum minimum 450 mm 450 mm minimum minimum
ページ10に含まれる内容の要旨
8 Installation instructions Levelling the cooker Important! Using the supplied adjustable feet is MANDATORY. For safety reasons and to ensure adequate ventilation, the cooker chassis MUST NOT sit directly on the floor, a plinth, or other support surface. The cooker is already fitted with six levelling feet. Level the cooker by screwing or unscrewing the feet (Fig. 4d). Make sure you follow the instructions in Figs. 4a, 4b, and 4c. Fig. 4a Note: bolts are supplied with the cooker in
ページ11に含まれる内容の要旨
9 Installation instructions Moving the cooker Important! Two people must always raise the cooker, as shown, to prevent damaging the adjustable feet. Do not lift the cooker by the door handles. DO NOT DRAG the cooker. Lift the feet clear of the floor. Ventilation requirements (GB & IE only) Fig. 5a Correctly raising the cooker The appliance should be installed in a room or space with an air supply in accordance with BS 5440-2:2000. For rooms with a volume of less than 5 3 3 m : permanent
ページ12に含まれる内容の要旨
10 Installation instructions Gas installation (GB & IE only) Important! This cooker uses NATURAL GAS only and cannot be used on any other gas without modification. This appliance is manufactured for conversion to LPG if required. If the injectors are not supplied they can be obtained from the After-Sales Service. Installation and service regulations Important! This appliance must be installed and serviced only by a suitably qualified and registered person, and in accordance with the current e
ページ13に含まれる内容の要旨
11 Installation instructions Notes: Flexible hoses can be used where the sited ambient temperature of the hose does not exceed 70°C. These hoses must be manufactured in accordance with BS669 part 1 and be of the correct construction for the type of gas being used. Gas hoses designed for natural gas MUST NOT be used for supplying LPG gas (LPG gas hoses can be identified by a either a red band or stripe on the rubber outer coating of the hose). The hose should not be crushed or trappe
ページ14に含まれる内容の要旨
12 Installation instructions Connecting the feeder cable B To connect the feeder cable to the cooker: Remove the four screws that hold shield “A” behind the cooker. C Open the cable clamp “D” completely. Check the position of the U bolts on the terminal block “B” (Fig. 7a) according to the diagram in Fig. 7b and Fig. 7c. Insert the feeder cable into the cable clamp A D and into the cable protector “C”. The “D” supply cable must be of a suitable size for the current requirements of
ページ15に含まれる内容の要旨
13 Maintenance instructions Replacing the burner injectors Semi-rapid burner J If the injectors are not supplied, contact the Fisher & Paykel Authorised Service Centre. Select the injectors to be replaced according to the ‘Table for the choice of injectors’. To replace the injectors: Remove pan supports and burners from the cooktop. Using a wrench, substitute the nozzle injectors “J” (figs. 8a - 8b - 8c) with those Fig. 8a most suitable for the kind of gas used. Triple ring wok The bur
ページ16に含まれる内容の要旨
14 Maintenance instructions Setting the burner minimum F Check whether the flame spreads to all burner ports when the burner is lit with the gas tap set to the minimum position. If some ports do not light, increase the minimum gas rate setting. Check whether the burner remains lit even when the gas tap is turned quickly from the maximum to the minimum position. If the burner does not remain lit, increase the minimum gas rate setting. To adjust the minimum gas rate setting: Semi-rapid a
ページ17に含まれる内容の要旨
15 Maintenance instructions Table for the choice of the Injectors Cat: II 2H 3+ GB IE G 30 - 28-30 mbar G 20 G 31 - 37 mbar 20 mbar Nominal Reduced Power Power BURNERS By-pass Ø injector By-pass Ø injector [kW] [kW] [1/100 [1/100 [1/100 [1/100 mm] mm] mm] mm] Semi-rapid 1,75 0,45 32 65 97 (Z) Triple ring wok 3,50 1,50 65 95 135 (T) 50 69 (F1) inner 1,00 (*) 0,32 (*) 27 (no. 1 (no. 1 crown central central Dual 66 102 (Z) outer 4,50 (#) 1,90 (#) 60 (no. 2 (no. 2 crown outer) outer) Fig. 6 (
ページ18に含まれる内容の要旨
16 Introducing your cooker Thank you for buying a Fisher & Paykel freestanding cooker. Once it is installed and ready to use, you will want to know everything about it to make sure you get excellent results right from the start. This guide introduces you to all its special features. We recommend you read the whole guide before using your new cooker, for both safety and cooking success. For more information, go to www.fisherpaykel.com 11 10 18 15 16 7 8 9 1 2 3 17 4 5 6 14 12 13 Fig. 10 Cooker
ページ19に含まれる内容の要旨
17 Using your cooktop 1 1 . 2 3 3 2 Fig. 11 Cooktop layout 1 Semi-rapid burner 2 Triple-ring wok burner 3 Dual burner Gas burners The knob controls the flow of gas through the safety tap. = closed valve 0 = maximum aperture or flow = minimum aperture or flow You can choose to cook at any heat between and , but never between and OFF. Fig. 12 Burner control knob
ページ20に含まれる内容の要旨
18 Using your cooktop Before using your cooktop Before using your new cooktop, please: Read this user guide, taking special note of the ‘Safety and warnings’ section. Make sure all controls are turned off. Lighting the cooktop 1 Choose the control knob for the burner you want to use. 2 Press the knob down gently and turn it anticlockwise to the position. The ignitors on all the burners will spark. Hold down the knob for approximately 10 seconds after the burner has lit. Releasing the kno
