ページ1に含まれる内容の要旨
ISTRUZIONI PER L’USO
ED IL MONTAGGIO
INSTRUCTIONS DE MONTAGE ET D’UTILISATION
INSTRUCTIONS FOR FITTING AND USE
GEBRUIKS- EN MONTAGE-INSTRUCTIES
GEBRAUCHS- UND MONTAGEANWEISUNG
INSTRUCCIONES PARA EL USO Y MONTAJE
Piano di cottura da incasso in vetroceramica
Plaque de cuisson vitrocéramique à encastrer
Built-in glass ceramic hob
Keramische inbouwkookplaat
Einbau-Glaskeramik-Kochfeld
Encimera de vitrocerámica incorporada
224810 LA1 1
ページ2に含まれる内容の要旨
You now own a glass ceramic hob. Chapters 2 and 3 of these Operating Instructions contain information on how you can make sure that your hob gives many years of service. Contents 1. General 2. For the user 2.1 Important 2.2 Functions 2.3 Twin circuit cooking zone 2.4 Residual heat display 2.5 Choice of pots 3. Cleaning and maintenance 4. For the technician 4.1 Worktop cut-out 4.2 Installation 4.3 Electrical connection 4.4 Service work Disposing of the packaging and your old appliance Please disp
ページ3に含まれる内容の要旨
1. General This appliance may only be connected to the electricity supply by an approved electrician. The plastic covering or veneer of the built-in furniture must have been applied with a heat-resistant adhesive (150°C). SE 62CX Cooking zone 14.5 cm (Twin circuit) cooking zone 12/21 cm Cooking zone 14.5 cm (Twin circuit) cooking zone / fryer 18/26.5 cm 2. For the user 2.1 Important Attention: The surfaces of the heating and cooking zones become hot during use. Keep small children away at all ti
ページ4に含まれる内容の要旨
2.5 Choice of pots Special-purpose electric cooking pots with a surface-ground base must be used. You may also use fireproof glass or porcelain direct on the cooking zone provided that the base is surface-ground. Please observe the manufacturer’s instructions. The size of the pots should be selected in accordance with the size of the cooking zone. The diameter of the pot may not be smaller than the diameter of the cooking zone. Cooking and roasting in cookware that is slightly deformed and does
ページ5に含まれる内容の要旨
3. Cleaning and maintenance Always clean the glass surface after it has cooled down. Even the slightest amount of dirt will burn into the surface the next time you switch it on. Use only recommended cleaners. Steel wool, sponges and powdered cleaning agents must not be used since they may scratch the surface. Do not use oven sprays as these are aggressive and damage the surface. Light amounts of dirt Use a damp cloth or a warm rinse to clean light amounts of dirt from the surface. Rinse off left
ページ6に含まれる内容の要旨
4. For the technician 4.1 Worktop cut-out Carry out all cutting out of furniture units and worktops before fitting the appliance. Remove all sawdust and chips. The dimensions of the worktop recess can be seen in the dimension drawing (figs. 1–3). The worktop cut-out should be properly milled and sealed afterwards with heat and humidity-resistant lacquer. Attention! If the cooking surface is located above furniture parts (side panels, drawers, etc.), then an intermediate bottom must be inserted i
ページ7に含まれる内容の要旨
4.3 Electrical connection (Connected loads and model designation: see front of the operating instructions) This appliance may only be connected to the electricity supply by an approved electrician who must ensure that the installation complies with the statutory regulations (Germany VDE, Austria ÖVE, Switzerland SEV, etc.). The electrician must ensure that these regulations and those laid down by the local electricity supply company are observed. In addition, make certain to observe the assembly
ページ8に含まれる内容の要旨
Type: SE 62 CX Fig. 1 Fig. 2 Fig. 3 Minimum distances to adjacent walls Cut-out dimension Outer dimensions of hob Cable access through the rear panel 22 224810
