Summary of the content on the page No. 1
Manual
Ïäçãßåò
Návod
Instruction
de
k použití åã÷åéñßäéï
booklet
instruções
Elektrická ÇëåêôñéêÝò
Electric Fogão
eléctrico varná deska åóôßåò
hob
ZES 646
Summary of the content on the page No. 2
Thank you for selecting our appliance We wish you lots of enjoyment with your new appliance and we hope that you will consider our brand again when purchasing household appliances. Please read this user manual carefully and keep it throughout the product life cycle as a reference document. The user manual should be passed on to any future owner of the appliance. 2
Summary of the content on the page No. 3
Contents For the User Description of the hob ....................................................................................... 3 Important safety information............................................................................... 4 Before the first use of the appliance .................................................................. 6 Operation .......................................................................................................... 6 Maintenance and Cleaning ....
Summary of the content on the page No. 4
Important safety information These warnings are provided in the interest of safety. You MUST read these warnings carefully before installing or using the hob. Installation • It is most important that this • The exposed parts of this appliance instruction book should be retained become hot during cooking and with the appliance for future remain so for some time even after the reference. Should the appliance be appliance is turned off. Keep children sold or transferred, always ensure that away unt
Summary of the content on the page No. 5
Environmental information The symbol on the product or on • All the materials used are its packaging indicates that this product environmentally friendly and may not be treated as household recyclable. Please make your waste. Instead it shall be handed over contribution to safeguarding the to the applicable collection point for environment by using the special the recycling of electrical and differentiated waste collection electronic equipment. By ensuring channels. this product is disposed
Summary of the content on the page No. 6
Before the first use of the appliance Before using the appliance remove all packaging, including the advertising labels and any protective film. When using the hob for the first time: 1) place on all the plates a pan filled with some water; 2) switch the plates on for about 10 minutes at “maximum” position until water inside the pans boils; 3) then, turn the control knob to “minumum” and allow the plates to run for approximately 20 minutes; 4) open a window for ventilation. Fig. 1 During this t
Summary of the content on the page No. 7
Electric Hotplates Control Rapid Hotplates Rapid Hotplates Rapid Hotplates Rapid Hotplates Rapid Hotplates Light The rapid hotplates are indicated by a red dot, and will heat up more quickly The Hotplates Control Light will come than a normal plate. As the red dots are on each time a cooking zone is switched painted on the plate, they may on. deteriorate during use and even disappear completely after a period of time. This will not affect the performance of the hob. It is important to note that
Summary of the content on the page No. 8
For the correct use of the hot- plates For better efficiency of the electric hotplates and lower electricity consumption: • switch on the hotplates only after placing the pots on them. • For cooking on the electric hotplates it is advisable to use triple-bottom pots of the same width as the cooking zone, or slightly larger (Fig. 3). • Do not use wet pots on the electric hot-plates, and do not place wet lids on the switched off hot-plates, because the moisture and condensate could damage them.
Summary of the content on the page No. 9
• Do not leave a hotplate switched on without a pot or with an empty pot. • Do not place a pot on a cold hotplate or leave it to cool on a switched-off hotplate. This could cause damaging condensation to form. • For faster cooking and to avoid heat dispersion, it is advisable to use flat- bottomed pots, to ensure maximum contact of the bottoms with the cooking zone. • Take care never to lean or reach over a hot electric plate. Always point pan handles inward or over the work surface next to the
Summary of the content on the page No. 10
Maintenance and Cleaning Before any maintenance or The Hotplates cleaning can be carried out, Spills onto the actual plate should be you must DISCONNECT the removed using warm water and a soft hob from the electricity supply. brush, nylon or plastic scourer. To keep the plates looking as new, hotplate This appliance cannot be conditioner can be purchased from most cleaned with steam or with a hardware stores, e.g. "4 Hob" by steam cleaning machine. HomeCare Products (follow the The hob is best c
Summary of the content on the page No. 11
Something not working? If the hob is not working correctly, please carry out the following checks before contacting your local Service Force Centre. IMPORTANT: If you call out an engineer to a fault listed below, or to repair a fault caused by incorrect use or installation, a charge will be made even if the appliance is under guarantee. SYMPTOM SOLUTION The plate does not heat up. Check that the unit is plugged in and the electrical supply is switched on. Check the mains fuse has not blo
Summary of the content on the page No. 12
Instructions for the Installer Engineers technical data Heating elements ratings Rapid front left hotplate Ø 180 mm 2000 W Rapid back left hotplate Ø 145 mm 1500 W Rapid front right hotplate Ø 145 mm 1500 W Rapid back right hotplate Ø 180 mm 2000 W Total rating 7000 W Voltage tension 230 V~ 50 Hz Cut out dimensions Width: 550 mm Depth: 470 mm Overall dimensions Width: 580 mm Depth: 500 mm 12
Summary of the content on the page No. 13
Electrical connections Any electrical work required to the earth symbol or with the install this hob should be 5 5 number 5 5. 5 carried out by a qualified NOTE: electrician or competent The earth wire should be about person, in accordance with the current regulations. 2 cm. longer than the live and neutral wires (Fig. 5). THIS HOB MUST BE EARTHED. 6) Secure the cable by means of The manufacturer declines any liability the clamp screws and refit the should these safety measures not be terminal
Summary of the content on the page No. 14
The replacement of electric cable must be carried out exclusively by the service for- ce centre or by personnel with similar competencies, in accordance with the current regulations. Electrical connection to the ter- minal box The appliance is fitted with a five pole terminal box whose cables are predisposed for a 230 V monophase function (Fig. 6). In case of a different voltage, carry out the connection as shown in the table "CHOICE OF CONNECTION CABLE AND FUSE GUAGE" below. The earth wire shou
Summary of the content on the page No. 15
CHOICE OF CONNECTION CABLE AND FUSE GUAGE (in Amps) Type of Type of Type of Type of Type of Monophase Monophase Monophase Monophase Monophase Triphase Triphase Triphase Triphase Triphase Triphase Y Triphase Y Triphase Y Triphase Y Triphase Y Biphase Y Biphase Y Biphase Y Biphase Y Biphase Y connection connection connection 3f. + neutre 3f. + neutre 3f. + neutre 2f. + neutre 2f. + neutre 2f. + neutre connection connection 3f. + neutre 3f. + neutre 2f. + neutre 2f. + neutre 1 2 3 4 1 2 3 4 1 2 3 4
Summary of the content on the page No. 16
Installation The hob must be installed according to the instructions supplied. Please, ensure that, once the hob is installed, it is easily accessible for the engineer in the event of a breakdown. When the hob is first installed Once the hob has been installed, it is important to remove any protective materials, which were put on in the factory. The manufacturer will not accept liability, should the above instructions or any of the other safety instructions incorporated in this book be ignored.
Summary of the content on the page No. 17
• Fix the hob with the relevant fixing clamps (Fig. 8). The edge of the hob forms a double seal which prevents the ingress of liquids. Sealing gasket Fig. 8 17
Summary of the content on the page No. 18
Building In On base cabinet with door a 80 Proper arrangements must be ensured in the construction of the b cabinet, to prevent possible contact with the overheated housing of the top during operation. The recommended solution for avoiding this problem is illustrated in fig. 9. The panel under the top must be easily removed to allow securing and Fig. 9 release of the top in case of technical a a a) removable cabinet panel a a service intervention. b b b) possible space useful for b b On base
Summary of the content on the page No. 19
Service and original spare parts This appliance, before leaving the factory, has been tested and studied by many experts and specialists, in order to give you the best results. Any repair work which needs to be carried out should be done with the utmost care and attention. For this reason we recommend that for any problem you contact the dealer who sold it to you, or our nearest authorized Service Centre, specifying the nature of the problem, the appliance model (Mod.), the product number (Prod.
Summary of the content on the page No. 20
European guarantee This appliance is guaranteed by • The appliance is installed and used Electrolux in each of the countries listed in accordance with instructions at the back of this user manual, for the issued by Electrolux and is only used period specified in the appliance within the home, i.e. is not used for guarantee or otherwise by law. If you commercial purposes. move from one of these countries to • The appliance is installed in another of the countries listed below the accordance with
