Summary of the content on the page No. 1
User's Manual
for Cordless Digital
AT&T System Telephone 7650
Fold open this manual for inforrnatiorz about this
telephone's installation and operation. Please read
Part I - Important Product Information, included
;I, \.;..l,,. ., .,.!.,,<.,.
.. ... ..,.
Part 2
Q 1996 Lucenr Technologies Inc. All righrs reserved.
Prinred in Mexico. Issue 2
AT&T and rhe globe symbol are rrademarks ofAT&T Corp. licensed ro Lucenr Technologies lnc
Summary of the content on the page No. 2
Modular Wall Jack Standard AC Outlet A A Y Reset button 7 Plug in the power cord. Install the base battery. TABLE INSTALLATION Plug the AC adapter on the power Turn the unit over. 1 Choose a spot near an electrical cord into an clzctrical outler. Open the battery cover by gently outlet and a telephone jack. !VOTE: When yu connect the unit to pulling on the movable tab. This phone requires a modular ~111 C~PCI~~CLII ou~ier. the system aiitomati- Connect the %volt battery and t
Summary of the content on the page No. 3
........... I N STA L LAT I0 N...... ...... Base Antenna (extended) PHONE light goes on while handset is on a call. CHARGING light goes on while handset battery is charging. LO BATT BASE goes on when , base battery power is low. \\ Use CLOCK with CHANGE to set or change time/&y. - Use ANNC with CmVGE to a rnrnrnl nrrtoninu nnnnr~nrrmunt Ring Select ' Connect the telephone line cord. Setting the Clock WALL MOUNTING INSTALLATION Plug one end of the telephone line 1 Follow steps
Summary of the content on the page No. 4
0 lnstallinglReplacing Installinglfleplacin~ CAUTION: To reduce the risk the Base Battery the Battery Pack of fire or injury to persons or The base battery provides backup power damage to the telephone, read and fol- to retain memory in case of power Remove the battery case cover on low these instructions carefully. failure. For the handset, use only the the handset by pressing on the indentation and sliding the cover battery provided with this 1 Turn the unit over. downward. p
Summary of the content on the page No. 5
. . TELEPH ONE OPE Temporary Tone Making a Gall Press ;PHONE:, and wait for the 1 If you have dial pulse (rotary) senice, PHONE light to go on. this feature allows you to enter codes or LL hcn you hta1. a cild roi~c. u;;i iitc 2 tones needed to operaLC ansikcl.illg number. machines. or use electronic banking services, calling cards, and other special NOTE: You might e~perience a slight services. This feature will operate most delay.before you hear a dial tone, as the special se
Summary of the content on the page No. 6
This cordless phone can store nine MOTE: The numbers stored in memop telephone numbers that you can dial just might be lost when you chailge the by pressing MEMORY: and one of the handset batteries or ifthe batteries run number buttons. down completely; ifthis happens. you'll need to store the numbers again. Storing a Number in Memory Re~lacins a Stored Number 1 Make sure the handset is OFF. You can replace a stored number by ANS SYSTEM 3 Press %EMi%F. The PHONE light light goes on wh
Summary of the content on the page No. 7
..... OPERA TING RAN If you receive a call while you are out Changing Channels This cordless telephone operates at the of range, the handset might not ring - maximum power allowed by the Federal This cordless telephone has an advanced or if it does ring, the call might not Communications Commission (FCC). 25-channel Autoselect@ feature that connect when you press ilpHoNEl,. Move Even so, the handset and base can minimizes the chance of interference. closer to the base, then press im
Summary of the content on the page No. 8
... ANSWERING SYSTEM OPERATION.. . Answering System aperation from the Base Save Your Messages Mailboxes Automatic Answering Operation This answering system has two voice The system is ready to answer calls After you listen to your messages, the system automatically saves them, and is mailboxes which provide a convenient when it is turned on and the memory is way to share an answering system with not full. ready to answer new calls. utiic~ i~lcil~b~is uf jdili iiuudiuii ul- After playin
Summary of the content on the page No. 9
... ANSWERING SYSTEM OPERATION.. . Answering System operation from the Base Stop message playback or recording \ Forwara7Skip Messages \ Record a memo (with MAILBOX), 1 \ OY/OFF \ / Delete Messages Repeat/Review Messages' Message Volume Control 1. I I Message Window Ring Select 1 If the handset is away from the 1 On the base, tap m. Priority Calling base, press ;ANSSYSTEMI and wait for 2 Select MAlLsoX or ~MAILBOXZ . The Callers to whom you've given the the ANS SYSTEM light t
Summary of the content on the page No. 10
... ANSWERING SYSTEM OPERATION... Answering System Operation fr'om Cordless Handset or Remote Touch Tone Phone You can operate the answering system Play All Messages Record a Memo from the cordless handset, or from any Press and release pr. 1 Press ANSSYSTEM,. touch tone phone away from your home - 2 Press :-. or office. The labels above the number . . .?, Ert-rm?i!hcx xo:'.?r (I or 7). Th: I. .. 1. - . ? ":a ..\. ,&., vir i:.i .UL;!~~> ;ICLLICI>CL 'ik ill system beeps. remind yo
Summary of the content on the page No. 11
E OF DIFFICULTY ....... lfyou hear a two-beep signal when you If you hear noise or interference when If you have difficulty operating this try to use the handset: using the phone: phone, try the suggestions below. The handset and base are not If you still have trouble, call the Make sure the base and handset communicating properly. You National Service Center at 1 800 antennas are fully extended. might be out of range while 222-311 1. You may be out of range. iMove attempting to di
Summary of the content on the page No. 12
P ...... IN CASE OF DIFFICULTY...... If you hear noise in the handset and If the system does not answer after the the buttons don't work: correct number of rings: The base unit and handset might not be Make sure the system is ON; the set to the same security code. Place Message Window should be lit. the handset in the base for at least If Toll Saver is on, the number of 15 seconds to reset the security code. rings changes from four to two when you have messages waiting. In some cases,
Summary of the content on the page No. 13
Summary of the content on the page No. 14
Summary of the content on the page No. 15
Summary of the content on the page No. 16
