Summary of the content on the page No. 1
R
E
K
A
E
P
S
91-000303-050-000_EP590-2Englishmanual_Sep01,2005.qxd 2/13/1950 7:21 PM Page 1
User Manual (Part 2)
5.8GHz Expansion
Handset EP590-2
For use with AT&T
model EP5962
E
M
U
L
O
V
Summary of the content on the page No. 2
91-000303-050-000_EP590-2Englishmanual_Sep01,2005.qxd 2/13/1950 7:21 PM Page 2 You must charge the See pages 2-5 battery and register the STOP! for easy instructions. handset before use. For customer service or product Please also read information, visit our web site at Important Product Information www.telephones.att.com Enclosed in product package. or call 1-800-222-3111. Table of contents Before you begin........................................1 Parts checklist.............................
Summary of the content on the page No. 3
R E K A E P S 91-000303-050-000_EP590-2Englishmanual_Sep01,2005.qxd 2/13/1950 7:21 PM Page 1 Before you begin This cordless telephone operates with If you move out of range during a the maximum power allowed by the phone conversation, you might hear Federal Communications Commission noise or interference. To improve (FCC). Even so, this handset and reception, move closer to the base. EP5962 base can communicate over If you move out of range without only a certain distance — which can pressin
Summary of the content on the page No. 4
R E K A E P S 91-000303-050-000_EP590-2Englishmanual_Sep01,2005.qxd 2/13/1950 7:21 PM Page 2 Battery & charger installation Installation of Battery pack in Handset Follow the step below: 1. Remove the battery compartment cover by pressing on the indentation and sliding downward. Place the new battery pack in the handset with the positive and negative poles aligned in the battery compartment. 2. Replace the battery cover by sliding it upwards. 3. Place the handset in its charger, and allow
Summary of the content on the page No. 5
R R R E E E K K K A A A E E E P P P S S S 91-000303-050-000_EP590-2Englishmanual_Sep01,2005.qxd 2/13/1950 7:21 PM Page 3 Registering the handset Before using your new handset, you must register it with the EP5962 base. During registration, you must Base: Select MENU, then highlight DISPLAY BASE ID enter the 15-digit ID number of the telephone base. DIRECTORY To find this number, go to the EP5962 base, select MAILBOXES MENU, scroll down to highlight DISPLAY BASE ID, SETUP BASE DISPLAY BASE-ID
Summary of the content on the page No. 6
91-000303-050-000_EP590-2Englishmanual_Sep01,2005.qxd 2/13/1950 7:21 PM Page 4 Replacing a handset If you are replacing a handset on a system that has the maximum number of registered handsets (8) or wish to change the assigned handset number of your registered hand- set, you must first deregister all handsets and then re-register all handsets. NOTE: Use this option with EXTREME CAUTION. It will make all handsets unusable until each one has been re- registered. To deregister all handsets: Hig
Summary of the content on the page No. 7
91-000303-050-000_EP590-2Englishmanual_Sep01,2005.qxd 2/13/1950 7:21 PM Page 5 Re-Registering a handset You can re-register handsets after deregistration from the base. Or you can re-register handsets to a new base unit if you have replaced your base unit for any reason. During re-registration, you must enter the 15-digit ID number of the telephone base. To find this number, go to the base, select MENU, scroll down to DISPLAY BASE ID, then select OK. Base: Select MENU, then highlight DISPLAY
Summary of the content on the page No. 8
R E K A E P S 91-000303-050-000_EP590-2Englishmanual_Sep01,2005.qxd 2/13/1950 7:21 PM Page 6 Belt clip & optional headset Install belt clip as shown below if desired. For hands-free telephone conversations, you can use any industry standard 2.5 mm headset (purchased separately). For best results use an AT&T 2.5 mm headset. Snap belt clip into notches on side of handset. Rotate and pull to remove. Plug 2.5 mm headset into jack on side of handset (beneath small rubber cap). 6 E M U L O V
Summary of the content on the page No. 9
R E K A E P S 91-000303-050-000_EP590-2Englishmanual_Sep01,2005.qxd 2/13/1950 7:21 PM Page 7 Quick reference guide For complete instructions, please refer to the manual provided with your EP5962 telephone. Softkeys Off/Clear Press a softkey to select an item During a call, press to hang up. displayed just above the key. While using menus, press to cancel an operation, back up to the previous menu, or exit the menu display. L1/Flash, L2/Flash Press LINE 1 to make or answer a call on RDL MENU
Summary of the content on the page No. 10
91-000303-050-000_EP590-2Englishmanual_Sep01,2005.qxd 2/13/1950 7:21 PM Page 8 www.telephones.att.com Copyright © 2005 Advanced American Telephones. All Rights Reserved. AT&T and the Globe Design are trademarks of AT&T Corp., licensed to Advanced American Telephones. Printed in China. Issue 4 AT&T 09/05. 91-000303-050-000
