Our goal is to provide you with a quick access to the content of the user manual for Aiphone DUAL MASTER CHIMECOM SYSTEM C-123LW. Using the online preview, you can quickly view the contents and go to the page where you will find the solution to your problem with Aiphone DUAL MASTER CHIMECOM SYSTEM C-123LW.
If looking through the Aiphone DUAL MASTER CHIMECOM SYSTEM C-123LW user manual directly on this website is not convenient for you, there are two possible solutions:
Many people prefer to read the documents not on the screen, but in the printed version. The option to print the manual has also been provided, and you can use it by clicking the link above - Print the manual. You do not have to print the entire manual Aiphone DUAL MASTER CHIMECOM SYSTEM C-123LW but the selected pages only. paper.
Below you will find previews of the content of the user manuals presented on the following pages to Aiphone DUAL MASTER CHIMECOM SYSTEM C-123LW. If you want to quickly view the content of pages found on the following pages of the manual, you can use them.
Dual Master ChimeCom System
- REFER TO INSTALLATION MANUAL INSIDE C-123L/A BOX FOR STANDARD
INSTALLATION INFORMATION -
The C-123LW Dual Master ChimeCom set provides chime, communication, and door release for one door and two
inside locations. This supplemental instruction manual addresses many of the additional functions and modifications
for the Chime Com system, including installation and troubleshooting information.
C-ML/A Master station with door
WIRING DIAGRAM: Dual Master Chime Com System with DAK-2S Dual Master Adaptor Master #1 Please read and understand all instructions before installation. Door Master #2 C-ML/A C-D 1 1 C-ML/A Component Module* 1 Component Module* E E E * Install bare wire SKK-620 SKK-620 end to "1" terminal (DAK-2S contains two + + + + component - - - - modules) EL-9S PT-1210N (AC Transformer) L L L L IMPORTANT!!! Each master REQUIRES an SKK-620 power supply, or 4 "C"batteries. (Do not install both on one
60H-2A 8 THA1 547 WIRING DIAGRAM: C-123L/A System with External Signaling using RY-AC Relay Component Module* C-D C-ML/A 1 1 Output of RY-AC (Yellow wires) provide a momentary dry contact closure while E the call button on the door E station is being pressed. 12V DC SKK-620 BELL power supply WHITE YELLOW RED NOTE:Negatives of + + + RY-AC power supplies must BLACK YELLOW - - - be tied together. Power source for bell Component Module* Normally Open Dry L If a DAK-2S is not available, in
INSTALLATION TIPS: 1. Use shielded wire for the communication path, and ground one end of the shield to an earth ground. 2. Run intercom wire at least 20" away from AC wiring, fluorescent lights or dimmer switches. 3. Keep intercom cable away from alarm, data, phone, video cables, and any other potential source of interference. 4. Door release wires must be in a separately jacketed cable from the intercom wires. Use two separate cables; one for audio and one for door release. 5. When i
|2||Aiphone Door HID-SS||Door||15|
|4||Aiphone Door RY-3DL||Door||28|