BEA Bollards 10EMSQ475X user manual

Summary of the content on the page No. 1

BOLLARD MOUNTING POST
USER’S GUIDE
MOUNTING POST FOR PUSHPLATES
1 Description
The Bollard (Black-10BOLLARDBLK, Bronze-10BOLLARDBRZ & Silver-10BOLLARDSLV) is used for mounting pushplates that activate automatic
doors. It will accept BEA’s 4 ½” Square Pushplate, 4 ¾” Square Pushplate, 4 ¾” Panther Pushplate, Dual Vestibule Pushplate and 4 ½” Round
Pushplate. The post is made of durable carbon steel and the mounting bracket is made of stainless steel for strength. It can be mounted on either
e

Summary of the content on the page No. 2

3 Precautions  Shut off all power before attempting any wiring procedures.  Maintain a clean & safe environment when working in public areas. Constantly be aware of pedestrian traffic around the door area.  Always stop pedestrian traffic through the doorway when performing tests that may result in unexpected reactions by the door.  Always check placement of all wiring before powering up to insure moving door parts will not catch any wires and cause  damage to equipment. Ensure compliance

Summary of the content on the page No. 3

5 Installation (Continued) Attach Mounting Bracket Using ‘L’ Shaped Anchors - New Concrete 3 1” EXPOSED 6” 1. Pour concrete at least 6 inches deep. 2. Insert anchors into curing concrete. Leave 3. Once concrete has cured attach anchor and at least 1 inch exposed. tighten nuts onto mounting bracket. Attach Post to Mounting Bracket 4 1. Align post to mounting bracket and attach post to mounting bracket with four post mounting screws. Install Pushplate 5 PUSHPLATE INSTALLATION DUAL PUS

Summary of the content on the page No. 4

5 Installation (Continued) Attach Transmitter 6 ATTACH TRANSMITTER HERE TRANSMITTER MOUNTING TRAY ATTACH TO PUSHPLATE NOTE: PANTHER PUSHPLATES DO NOT REQUIRE A TRANSMITTER. CAUTION: IF THE TRANSMITTER IS ALLOWED TO HANG DOWN INSIDE THE BOLLARD, ERRATIC OPERATION MAY OCCUR. 1. If using the transmitter for this application, attach transmitter to mounting tray with velcro pad included in the package. Hardwired systems do not require this step. 2. Attach plastic cap to top of the post wit