Summary of the content on the page No. 1
FAVORIT 60830
Dishwasher
User Instructions
Summary of the content on the page No. 2
Dear customer, Please read these user instructions carefully. Please observe the safety instructions on the first few pages of these user instructions! Please keep these user instructions for later reference. Pass them on to any subsequent owner of the appliance. The warning triangle and/or specific words (Warning!, Caution!, 1 Important!) are used to highlight instructions that are important for your safety or for the function of the appliance. It is imperative that these instructions are
Summary of the content on the page No. 3
Contents CONTENTS Operating Instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 Safety Instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 Disposal . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 Economical and Ecological Dishwashing . . . . . . . . . . . . . . . . . . . . . . . . . . 7 Appliance Features and Control Panel . . . . . . . . . . . . .
Summary of the content on the page No. 4
Contents Care and Cleaning . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 34 Cleaning the Filter . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 34 What to do, if ... . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 36 ...Error messages are displayed. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 36 ...there are problems with the operation of the di
Summary of the content on the page No. 5
Operating Instructions OPERATING INSTRUCTIONS 1 Safety Instructions The safety aspects of AEG electrical appliances comply with accepted technical standards and the German Appliance Safety Law. Neverthe- less, as a manufacturer we consider it our obligation to make you aware of the following safety information: Installation, Connection and Placing into Operation The dishwasher may only be transported upright. Check the dishwasher for transport damage. Do not in any circum- stances connect
Summary of the content on the page No. 6
Operating Instructions Never place the dishwasher in operation if the mains cable, water inlet or drain hose is damaged; or the control panel, work top or plinth area is damaged such that the inside of the appliance is freely accessible. If the mains lead is damaged, or is to be replaced for a longer lead, the cable (obtainable from AEG Service Force) must be changed by a service engineer authorised by AEG. Never unplug the appliance by pulling on the cable, always pull the plug.
Summary of the content on the page No. 7
Operating Instructions In the event of a fault, first close the tap, then switch off the appli- ance and unplug it from the mains. If the appliance is permanently wired to the mains: remove the fuse. 2 Disposal Disposing of the Packaging Material Dispose of the dishwasher packaging material correctly. All the packag- ing materials used are harmless to the environment and can be recy- cled. Plastic parts are marked with standard international abbreviations: – >PE< for polyethylene, e.g.
Summary of the content on the page No. 8
Operating Instructions Appliance Features and Control Panel Top Spray Arm Rubber Seal for Connecting the Water Feed to the Spray Arm Spray Arms Water hardness switch Container for Salt Container for Detergent Container for Rating Plate Filters Rinse Aid 8
Summary of the content on the page No. 9
Operating Instructions Control Panel Door Handle Set Start Delay Function Buttons Control Indicators 1 3 2 4 Function Buttons Control Panel Multi-Display The control panel consists of the ON/OFF button and the programme buttons with LED displays. Function buttons: In addition to the stated wash programme the fol- lowing functions can also be set using these buttons: Function Button 1 Adjust the water softener Function Button 2 Switch rinse aid supply on and off Function Button 3 - is not occu
Summary of the content on the page No. 10
Operating Instructions Control Indicators have the following significance: J Refill with special salt Refill with rinse aid H Open the tap ^ Clean the dishwasher’s filter system [ The [ indicator is intended to remind you to check the filters in the 3 dishwasher from time to time and, if necessary, to clean it. The indica- tor illuminates at regular intervals, independent of the amount of soil- ing of the filters. Prior to using for the first time Prior to using for the first time, remove al
Summary of the content on the page No. 11
Operating Instructions Setting the water softener To avoid scale deposits on the dishes and in the dishwasher, the dishes must be washed with soft water, i.e. water with a low lime content. The dishwasher therefore has a built-in water softener, in which tap water with a hardness of 4°d (German degree) and harder is softened with the aid of special salt. Your local water authority will be able to inform you about the hard- 3 ness and hardness range of the water in your area. The water soft
Summary of the content on the page No. 12
Operating Instructions Setting the water softener Using the table as a guide, adjust the water softener to that which cor- responds to the hardness of the water in your area: 0 The dishwasher must be switched off. Manual setting: 1. Open the dishwasher door. 2. Remove the lower basket from the dishwasher. 3. Turn the hardness range switch to 0 or 1 (see table). 4. Replace the lower basket. Electronic setting: 1. Press the ON/OFF button. The LED in the ON/OFF button will become illuminated.
Summary of the content on the page No. 13
Operating Instructions Special salt for the water softener If the water hardness in your area is less than 4 °d, then the water in 3 your dishwasher does not need to be softened and you do not need to use special salt or salt substitute. Water can be softened in one of two ways: If you are using dishwasher detergent that already contains salt sub- stitute, the detergent only is put into the detergent compartment. – In this case the water softener must manually be set to 0 and electronicall
Summary of the content on the page No. 14
Operating Instructions If the water softener is electronically set at “1” for the purpose of using 3 detergent that includes special salt, the special salt indicator is deacti- vated. Adding special salt If you are using dishwasher detergent and special salt separately, add the special salt: – Before using the dishwasher for the first time. – When the indicator for special salt SALT is illuminated on the control panel. 0 1. Open the door, remove the lower basket. 2. Undo the lid on the sa
Summary of the content on the page No. 15
Operating Instructions Rinse Aid Rinse aid ensures thorough rinsing, spot and streak free drying of dishes and glassware. Rinse aid can be added in one of two ways: If you are using dishwasher detergent that already contains rinse aid, the detergent including the rinse aid is put into the detergent compartment. – In this case the dispensing of rinse aid from the dispenser must be deactivated to avoid a double dosage. If you are using dishwasher detergent and rinse aid separately, the rin
Summary of the content on the page No. 16
Operating Instructions The multi-display will indicate the current setting: 0d Rinse aid dispenser deactivated Rinse aid dispenser activated (factory setting) 1d 4. Pressing function button 2 changes the setting. 5. Once the multi-display is indicating the required setting, press the ON/OFF button. The setting is now saved. Adding rinse aid If you are using dishwasher detergent and rinse aid separately, add the rinse aid: – Prior to using the dishwasher for the first time –When the RINSE AI
Summary of the content on the page No. 17
Operating Instructions 4. Fill with rinse aid exactly up to the level marked “max”; this corresponds to a quantity of approx. 140 ml. 5. Close the lid and press until it locks into place. 6. Wipe up any spilt rinse aid with a cloth. Otherwise too much foam will be formed during the wash. Adjusting Rinse Aid Dosing As the dishes are washed rinse aid is released from the dispenser into 3 the wash water. The dose is factory set at 4, and can be adjusted from 1 to 6. Only change the setting
Summary of the content on the page No. 18
Operating Instructions In Daily Use Check the salt and rinse aid levels. Load cutlery and dishes into the dishwasher Fill with dishwasher detergent Select a wash programme suitable for the cutlery and dishes Start the wash programme Loading Cutlery and Dishes Sponges, household cloths and any object that can absorb water should 1 not be washed in the dishwasher. For washing in the dishwasher the following cutlery/dishes are not suitable: are of limited suitability: Cutler
Summary of the content on the page No. 19
Operating Instructions – Do not lay small objects (e.g. lids) in the cutlery rack Loading Cutlery Long bladed knives stored in an upright position are a potential hazard. 1 Long and/or sharp items of cutlery such as carving knives must be posi- 1 tioned horizontally in the upper basket. Take care when loading or unloading sharp items such as knives. 1 0 Place knives, small spoons and small forks in the cutlery tray. Place forks and spoons that do not fit in the cutlery tray in the cutlery
Summary of the content on the page No. 20
Operating Instructions On some models of dishwasher it is possible to open the cutlery basket. To ensure that the cutlery basket 1 cannot open on removal from the appliance, you should always hold both parts of the two part handle. 0 1. Place the cutlery basket on a table or work surface 2. Open the two part handle 3. Remove cutlery 4. Close the two part handle. 20
