Summary of the content on the page No. 1
DVR1 Series
Instruction Manual
EN Single Channel,
Color Digital Video
Recorder
Applicable Models:
DVR1EP08, DVR1EP16,
DVR1EP32, and DVR1EP32A
Summary of the content on the page No. 2
Important Safeguards 1. Read, Follow, and Retain Instructions - All safety and 10. Power Sources - Operate the unit only from the type of operating instructions should be read and followed before power source indicated on the label. If unsure of the type operating the unit. Retain instructions for future reference. of power supply to use, contact your dealer or local power 2. Heed Warnings – Adhere to all warnings on the unit and company. in the operating instructions. • For units intended to o
Summary of the content on the page No. 3
WARNING: For Indoor Product Electrostatic-sensitive device. Use 1. Water and Moisture - Do not use this unit near proper CMOS/MOSFET handling water - for example, in a wet basement, in an precautions to avoid electrostatic ATTENTION OBSERVE PRECAUTIONS discharge. unprotected outdoor installation, or in any area FOR HANDLING ELECTROSTATIC SENSITIVE DEVICES classified as a wet location. 2. Object and Liquid Entry - Never push objects of NOTE: Grounded wrist straps must be worn and proper ESD an
Summary of the content on the page No. 4
FCC & ICES INFORMATION Sicherheitshinweise (U.S.A. and Canadian Models Only) This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired VORSICHT: UM EINEN ELEKTRISCHEN SCHLAG ZU operation. VERMEIDEN, IST DIE ABDECKUNG (ODER RÜCKSEITE) NICHT NOTE: This equipment has been tested and found to com
Summary of the content on the page No. 5
Veiligheidsmaatregelen Medidas de Segurança VOORZICHTIG: OPEN DE BEHUIZING OF DE ACHTERKANT CUIDADO: PARA REDUZIR O RISCO DE CHOQUE VAN HET APPARAAT NIET. ZO VERMINDERT U HET RISICO ELÉCTRICO, NÃO RETIRE A TAMPA (OU A PARTE OP ELEKTRISCHE SCHOKKEN. IN HET APPARAAT POSTERIOR). NO INTERIOR, NÃO EXISTEM PEÇAS QUE BEVINDEN ZICH GEEN ONDERDELEN DIE U ZELF KUNT POSSAM SER REPARADAS PELO UTILIZADOR. REMETA A REPAREREN. LAAT SERVICE EN ONDERHOUD UITVOEREN ASSISTÊNCIA PARA OS TÉCNICOS QUALIFICADOS. DOOR
Summary of the content on the page No. 6
TABLE OF CONTENTS SECTION 1: INTRODUCTION TO THE DVR1 SERIES DIGITAL VIDEO RECORDERS 9 1.1 Guide to This Manual ..............................................................................................................9 1.2 Unpacking ................................................................................................................................9 1.3 Understanding the DVR1 Series ................................................................................................9
Summary of the content on the page No. 7
7.1.1 Extended Archiving Applications ..........................................................................................................27 7.1.2 Backup Archiving Applications ............................................................................................................27 7.1.3 Selective/Manual Archiving Applications ..............................................................................................27 7.2 Using CD-Writers .........................................
Summary of the content on the page No. 8
8
Summary of the content on the page No. 9
SECTION 1: INTRODUCTION TO THE DVR1 SERIES DIGITAL VIDEO RECORDERS 1.1 Guide to This Manual This manual contains all of the information necessary to safely install, program, and operate Bosch DVR1 Series Digital Video Recorders. Step-by-step procedures and sample menus guide you through each phase of the DVR1’s setup and programming. The DVR1 package includes the Remote Viewer software, which allows remote access to a DVR1 through a network interface. Complete installation and operation instruc
Summary of the content on the page No. 10
SECTION 2: INSTALLING THE DVR1 BOSCH BOSCH BOSCH BOSCH Audio BOSCH (Optional) Microphone (Optional) CONSOLE SVHS IN VCR VCR 9 10 KEYBD MON B MON A 1 2 3 4 5 6 7 8 11 12 13 14 15 16 IN OUT SVHS OUT SDA ALARM Multiplexer ACCESSORIES RS- 232 IN S-video IN VIDEO IN AUDIO 15 ET 1 ALARM IN ETHERN 2 ALARM OUT 10/100 3 RECORD START IN 69 4 ALARM
Summary of the content on the page No. 11
2. Connect all peripherals (e.g. cameras, monitors, etc.) to the corresponding inputs/outputs on the DVR1 rear panel. CAUTION: DO NOT connect both S-video and Composite inputs at the same time. A hardware conflict will occur, which could damage the unit. 3. When all connections have been completed, apply power to the system. S-Video • Cable must be purchased separately. Pin Signal 3 4 1. GND (Y) 2. GND (C) 3. Y-signal IN or OUT 4. C-signal IN or OUT 1 2 Ethernet Port Ethernet port uses stand
Summary of the content on the page No. 12
Input: Active Low Alarm Out: The Alarm Output is activated when a teletext alarm is read, or while the High: 12 V Alarm Input is active. The Alarm output is only active for the duration of the alarm Low: Ground event. Current Out: 50 mA Max Short Circuit Protected. Low for duration of alarm Record Start In: When activated, this connection places the unit in record mode. Input: Active Low TTL with pull-ups Compatible with the Disk End Out signal from a second unit. or Normally Open Relay.
Summary of the content on the page No. 13
SECTION 3: GUIDE TO THE DVR1 CONTROLS Before attempting DVR1 programming, you should become familiar with the function of the DVR1 controls. This section provides a summary of the front panel controls and indicators, as well as hints for navigating the DVR1 menus and entering values via the front panel controls. 3.1 DVR1 Front Panel Controls Figure 3A provides an illustration of the DVR1 front panel controls and their functionality. Figure 3B shows the components of the Front Panel LCD display.
Summary of the content on the page No. 14
3.3 Navigating with the DVR1 Controls Navigating and entering parameter values with the DVR1 controls are designed to be easy and intuitive. Most menus use the same navigation for programming operations. Pull-down Menus Pull-down menus are the top-level menus, and are accessed by pressing MENU. For example, the following DVR1 Main Menu is a pull-down menu. TIME/DATE ALARMS TIMER SETTINGS RECORD SETTINGS DISPLAY SETTINGS ARCHIVE SETUP ADVANCED MENU ABOUT DSR • Use the Left/Right Arrows to scroll
Summary of the content on the page No. 15
SECTION 4: DVR1 MAIN MENU PROGRAMMING 4.1 Overview of the DVR1 Main Menu The DVR1 Series Main Menu allows quick and easy programming of vital system data and operating parameters. The following table provides a summary of user actions that are accessible via the DVR1 Main Menu. User Action Corresponding Menu Item/Sub-menu Set Time/Date TIME/DATE Configure Alarms ALARMS Configure Scheduled Recordings TIMER SETTINGS Configure Recording Parameters RECORD SETTINGS Configure On-screen Display Options
Summary of the content on the page No. 16
4.4 Configuring Scheduled Recordings Main Menu ➝ Timer Settings This menu allows the scheduling of a timed-recorded event. A sample menu is shown here. DAY START STOP SPD (pps) QUALITY ON/OFF 31 16:45 17:05 20 VHS ON SAT 7:55 8:10 10 SVHS OFF MON-FRI 9:56 11:05 60 VHS ON SAT-SUN 14:23 14:50 60 SVHS ON MON-SUN 2:23 3:34 20 VHS OFF -- --:-- --:-- -- -- -- [OK] EDIT MODE HIT "ENTER" TO TOGGLE EDIT MODE The fields to be programmed in the above menu are as follows: • Day: The date or day(s) o
Summary of the content on the page No. 17
4.6 Configuring On-screen Display Options Main Menu ➝ Display Settings Use this menu to specify the status information to be displayed on the primary CURRENT TIME / DATE monitor (usually shown in the upper right or upper left corner of the screen). RECORD CAPACITY Each of the following parameters may be set ON or OFF for the on-screen ARCHIVE STATUS display: LAST ALARM • Current time and date. • Remaining amount of time before the hard disk runs out of record capacity RECORD/PLAYBACK SPEED (au
Summary of the content on the page No. 18
When all required search criteria has been entered, highlight [START SEARCH], then press ENTER. The Archive Search Results window will appear. ARCHIVE SEARCH RESULTS START DATE START TIME SIZE (MB) 000 11/28/00 17:52:14 26842 [ ] 001 11/29/00 9:35:20 2062 [ ] 002 11/29/00 10:00:04 278 [X] 003 11/29/00 10:03:25 66 [X] SELECTED [ 383 ](MB) AVAILABLE ON TARGET MEDIUM [ 652 ](MB) "ENTER" TO PLAY "SEARCH" TO ARCHIVE Use the Left/Right Arrows to navigate the Search Results menu, highlig
Summary of the content on the page No. 19
• Write Once: When the archive device is full, archiving stops. Archiving will resume after the user acknowledges that the archive device is full and that archiving should resume. • No Overwrite: When the archive device is full, archiving stops. Archiving will resume only after a user enters the advanced menu, manually erases the media, and resumes archiving. • Continuous: When the archive device is full, archiving will continue, writing over the oldest video first. Main Menu ➝ Archive Setup ➝ E
Summary of the content on the page No. 20
SECTION 5: DVR1 ADVANCED MENU PROGRAMMING 5.1 Overview of the DVR1 Advanced Menu Enhanced DVR1 operating features are programmed via the Advanced Menu. The following table provides a summary of these actions that are accessed via the DVR1 Advanced Menu. User Action Corresponding Menu Item/Sub-menu Overwrite the Hard Disk DISK OVERWRITE MODE Erase, Delete, and Recover Hard Disk Data DISK MAINTENANCE Invoke Audio Recording AUDIO RECORD SETTING Use the Auto Delete Feature AUTO DELETE MODE Configure
