Summary of the content on the page No. 1
10
INTRODUCTION
DIGITAL HIGH DEFINITION RECEIVER
15
STARTUP GUIDANCE
HD-C26H
OWNER'S MANUAL
27
FUNCTIONS
49
APPENDICES
©2005 Toshiba Corporation DVB registration identification reference number: 3765.
Trade Mark of the DVB Digital Video Broadcasting Project
1
(1991 to 1996)
Summary of the content on the page No. 2
PRECAUTIONS WARNING: TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. TO PREVENT ELECTRIC SHOCK, DO NOT OPEN THE COVER. REFER SERVICING TO QUALIFIED PERSONNEL ONLY. This unit is not disconnected from the AC power source as long as it is connected to the wall outlet, even if the unit itself is in standby mode. NOTE The rating label and the safety caution are on the rear of the unit. Changes or modifications to this equipment not expressly authoris
Summary of the content on the page No. 3
DO NOT use or place the receiver in the following environments: 1. Near heat sources • Places subject to direct sunlight • Near radiators or air ducts • On top of an amplifier 2. Dusty places 3. Places subject to vibration or shock 4. Near strong magnetic fields such as loudspeakers or large motors 5. Places subject to moisture such as a kitchen or bathroom 6. Places without adequate air circulation • On top of a carpet or sofa • In a bookcase • Near materials such as curtains, et
Summary of the content on the page No. 4
NOTES ON COPYRIGHT • It is forbidden by law to copy, broadcast, show, broadcast on cable and play in public copyrighted material without permission. NOTES ON HANDLING • This unit is susceptible to surrounding environmental changes such as shock, vibration and temperature. 1. Do not apply shock or vibration to the unit. 2. Do not use the unit on a shaky or unstable place. 3. Do not install the unit on a non-flat surface. 4. Do not cover up the ventilation holes of the unit. 5. Do
Summary of the content on the page No. 5
Exemptions Toshiba is not liable for any damage caused by fire, natural disaster (such as thunder, earthquake, etc.) acts by third parties, accidents, misuse, or uses in other improper conditions. Toshiba is not liable for incidental damages (such as profit loss or interruption in business, etc.) caused by use or inability to use of this product. Toshiba is not liable for any damage caused by neglect of the instructions described in the owner’s manual. Toshiba is not liable for any
Summary of the content on the page No. 6
6
Summary of the content on the page No. 7
TABLE OF CONTENTS PRECAUTIONS......................................................................................................................................................................... 2 CHAPTER ONE......................................................................................................................................................................... 9 INTRODUCTION ..................................................................................................
Summary of the content on the page No. 8
INFORMATION ......................................................................................................................................................... 41 QUICK CONTROL.............................................................................................................................................................. 42 INFO (I-Plate)............................................................................................................................................
Summary of the content on the page No. 9
Chapter One INTRODUCTION Introduction 10 Identification of Controls 1 Front Panel 11 2 Rear Panel 12 3 Remote Control 13 9
Summary of the content on the page No. 10
INTRODUCTION Toshiba HD-C26H Digital High Definition Receiver opens up to a new world of free-to-air terrestrial HDTV (High Definition Television) and SDTV (Standard Definition Television) programs. The receiver can receive channels from both VHF and UHF bands. All the major terrestrial free-to-air station numbers currently available in your area are listed in the on-screen menu. To watch a channel, simply select the channel number and you will be accessing a wide range of high qu
Summary of the content on the page No. 11
INTRODUCTION IDENTIFICATION OF CONTROLS FRONT PANEL 1 3 4 5 6 7 8 9 2 1 RED LED INDICATOR ON: Receiver in standby mode 2 FOUR-DIGIT LED DISPLAY - Shows current time or off in standby mode - Shows current time or channel number in power-on mode - Shows “8888” when time information is not available - Shows “ ” when receiver is switching from standby to power-on mode - Momentarily shows the new video format when changing the video format setting 3 ORANGE LED INDICATOR ON: Signa
Summary of the content on the page No. 12
REAR PANEL 2 3 7 13 1 4 5 6 8 9 10 11 12 14 1 AC MAINS SUPPLY 100~240 V , 50/60 Hz AC 2 SERIAL PORT For connection to PC for software upgrade or to other external devices for external control 3 ANT.IN For connection to UHF/VHF antenna RF OUT 4 For connection to analogue TV’s antenna input 5 HD MODE-SWITCH To switch HD output mode between RGB and YPBPR 6 S-VIDEO OUT For connection to TV’s S-Video input 7 COMPOSITE VIDEO OUT For connection to TV’s composite video input 8 H,V OUT Used to
Summary of the content on the page No. 13
INTRODUCTION REMOTE CONTROL 16 1 17 2 18 19 3 4 20 5 21 6 22 23 7 8 24 9 25 10 26 11 27 12 28 13 29 14 30 15 31 13
Summary of the content on the page No. 14
REMOTE CONTROL MUTE button Page 26 STANDBY/ON button Page 24 1 17 2 TV FUNCTION button* SET TOP BOX button** 18 3 PROG. Button Page 60 19 PIP SWAP button Page 44 4 PIP button Page 44 20 PIP POS. button Page 44 VIDEO FORMAT button Page 45 SLEEP button Page 46 5 21 ASPECT RATIO button Page 46 CHANNEL NUMBER button Page 26 6 22 7 CHANNEL UP/DOWN buttons Page 26 VOLUME UP/DOWN buttons Page 26 23 8 EPG button Page 43 24 TV/RADIO
Summary of the content on the page No. 15
Chapter Two STARTUP GUIDANCE Read this chapter first to make all necessary preparations. 1 Installing the Receiver 16 - Connections 16 - Preparing your remote control 22 - Setting up your receiver 24 2 Viewing programs 26 3 Turning off the receiver 26 15
Summary of the content on the page No. 16
Antenna Cable (Not Supplied) INSTALLING THE RECEIVER Follow steps A to C below. Your receiver will be ready to display digital programs on your TV. STEP A: CONNECTIONS DO NOT PLUG THE RECEIVER INTO THE MAINS YET. Before you use this receiver, it is necessary to connect it to your TV. 1 CONNECTING TO TV 1-1. Connection to Antenna Disconnect the antenna cable from your TV and connect it to the “ANT. IN” terminal on the back of the receiver. 1-2. “RF OUT” Connection to TV
Summary of the content on the page No. 17
STARTUP GUIDANCE 1-3. Connections to TV – Video Connection In the accessory box, you will find two sets of cables: One is the component video cable (with red, green and blue connectors) and the other is the Audio/Video cable (with yellow, white and red connectors). For better video quality, it is recommended that you use the HDMI cable, the Mini D-Sub 15-pin cable or the RGBHV video cable (with 5 RCA connectors). These cables are not included in the HD-C26H package. HD MODE Switch s
Summary of the content on the page No. 18
TV HD-C26H To TV Mini D-sub 15-pin video input HD MODE Mini D-sub 15-pin video cable (not supplied ) YP BP R RGB Note: This diagram illustrates video connections only. Refer to Page 20 for Audio connection. (c) RGBHV (RCA) connection: If your TV has RGBHV video inputs, use a RGBHV video cable (not supplied) to connect the receiver to your TV. Set the HD MODE Switch (refer to page 54) to RGB, and then connect the Y/G, P /B, P /R, H and V connectors from “HD VIDEO OUT” on the r
Summary of the content on the page No. 19
STARTUP GUIDANCE (d) YP P connection: If your TV has component video inputs, use the component video cable included B R in the HD-C26H accessory box. Set the HD MODE Switch (refer to page 54) to YP P , and then B R connect the Y/G, P /B and P /R connectors from “HD VIDEO OUT” on the rear of the receiver to the B R corresponding jacks on the TV. TV Match the colors when connecting HD-C26H Y TOSHIBA To TV Y/P /P B R P B video inputs P R P Y R P B HD MODE YP P RGB B R Component video cable
Summary of the content on the page No. 20
(f) Composite video connection: If your TV has composite video inputs, use the yellow connector of the Audio/Video cable included in the HD-C26H accessory box. Connect the yellow video connector from “SD VIDEO OUT” on the rear of the receiver to the corresponding jack on the TV. TV HD-C26H To TV composite video input Audio/Video cable (supplied) Note: This diagram illustrates video connections only. Refer to Audio connection below. 1-4. Connections to TV – Au
