Summary of the content on the page No. 1
FACSIMILE
UX-B800
UX-B800_TINSE4533
MODEL
UX-B800
FACSIMILE
OPERATION MANUAL
IMPORTANT
PLEASE KEEP THE EXTERNAL & INTERNAL PACKAGING SAFE.
PLEASE DO NOT THROW IT AWAY.
IN THE UNLIKELY EVENT OF A HARDWARE FAILURE, OUR
REPAIR CENTRE WILL ASK YOU TO PUT YOUR SHARP
FACSIMILE IN THIS BOX.
THANK YOU FOR YOUR ASSISTANCE.
Summary of the content on the page No. 2
all.book Page 2 Thursday, August 10, 2006 2:22 PM MAINS PLUG WIRING INSTRUCTIONS This equipment is fitted with a moulded type mains plug which incorporates a detachable fuse cover, under no circumstances should the plug be used without the fuse cover fitted. In the unlikely event of the socket outlet in your home not being compatible with the plug supplied, cut off the mains plug and fit an appropriate type observing the wiring code below. DANGER: The fuse from the cut-off plug should b
Summary of the content on the page No. 3
all.book Page 1 Thursday, August 10, 2006 2:22 PM Table of Contents Introduction 2 Using AUTO Mode . . . . . . . . . . . . . . 35 Using MANUAL Mode. . . . . . . . . . . . 36 Reception to Memory . . . . . . . . . . . . 37 A Look at the Operation Panel 5 5. Making Copies 38 1. Installation 8 6. Special Functions 39 Unpacking Checklist. . . . . . . . . . . . . . 8 Setup . . . . . . . . . . . . . . . . . . . . . . . . . 8 Broadcasting . . . . . . . . . . . . . . . . . . . 39 Loading Paper . .
Summary of the content on the page No. 4
all.book Page 2 Thursday, August 10, 2006 2:22 PM Introduction Specifications 1, 2 Replacement cartridge: SHARP UX-C80B Print cartridge yield Ink Save mode ON: Approx. 800 A4 pages Ink Save mode OFF: Approx. 480 A4 pages (The initial cartridge has the same yield as the above replacement cartridge.) 2 Paper tray capa
Summary of the content on the page No. 5
all.book Page 3 Thursday, August 10, 2006 2:22 PM Reception modes AUTO, MANUAL, TEL/FAX Applicable telephone line Analog public switched telephone network (ES203021) / PBX 2 Automatic document A4: 20 sheets max. (60 - 80 g/m paper; temperature: feeder 18 - 28°C; humidity: 45 - 65% RH) Input document size Automatic feeding: Width: 148 to 210 mm Length: 140 to 297 mm Manual feeding: Width: 70 to 210 mm Length: 140 to 356 mm Scanning Resolution Standard: 203 x 98 dpi Fine: 203 x 196 dpi Supe
Summary of the content on the page No. 6
all.book Page 4 Thursday, August 10, 2006 2:22 PM Important: This machine is not designed for use on a line which has call waiting, call forwarding, or certain other special services offered by your telephone company (errors may occur during transmission and reception of faxes). This machine is not compatible with digital telephone systems. Important safety information Do not disassemble this machine or attempt any procedures not described in this manual. Refer all servicing to qualified
Summary of the content on the page No. 7
all.book Page 5 Thursday, August 10, 2006 2:22 PM A Look at the Operation Panel 1 2 3 4 5 6 7 8 01 02 03 04 05 06 07 08 09 10 11 FUNCTION COPY/HELP STOP ABC DEF RESOLUTION/ 12 13 14 15 16 17 18 19 20 21 RECEPTION MODE GHI JKL MNO UP SPEED DIAL 22 23 24 25 26 27 28 29 30 31 PQRS TUV WXYZ .co.uk RZA 32 33/G1 34/G2 35 36 REDIAL DEL B'CAST SECURE DUPLEX SPEAKER DOWN 9 10 11 12 13 14 15 16 17 18 Note: Affix the Rapid Key labels as shown above. STOP key: Press to cancel an Number keys: Use to dial
Summary of the content on the page No. 8
all.book Page 6 Thursday, August 10, 2006 2:22 PM R key: If you are on a Flash-type START/MEMORY key: Press after 15 17 PBX, use this key to dial out (page dialling to send a fax (p. 28). Press 28). before dialling to send a fax through memory (p. 34). Press in the date SPEAKER key: Press to listen to 16 and time display to show the the line and fax tones through the percentage of memory currently speaker when faxing (p. 28). used. Note: This is not a speakerphone. It cannot be used
Summary of the content on the page No. 9
all.book Page 7 Thursday, August 10, 2006 2:22 PM Monitoring phone conversations When speaking through the SPEAKER handset, you can press to allow a third person to listen to the conversation through the speaker. (To turn off the speaker, press the key again.) To adjust the volume of the speaker when monitoring a conversation, press or (the volume reverts to the lowest setting each time the handset is replaced). Note that the speaker cannot be used for speaking; it is only for
Summary of the content on the page No. 10
all.book Page 8 Thursday, August 10, 2006 2:22 PM Unpacking Checklist 1. Installation Unpacking Checklist Setup Remove the packing tape Paper Document Received Handset tray exit tray document cord 1 Open the cover (➊) and remove the tray Handset tape (➋). (Do not install the print cartridge yet.) 2 1 Phone Print Rapid Manual Setup line cartridge Key guide cord labels Extension phone 2 Close the cover. adapter Points to keep in mind when setting up ♦ Do not place the machine in dire
Summary of the content on the page No. 11
all.book Page 9 Thursday, August 10, 2006 2:22 PM Loading Paper 2 Pull the paper plate forward and Attach the paper tray insert the stack of paper into the tray, print side up. Attach the document exit tray The stack must and flip out the not be higher extension than this line Pull the received document tray extension all the way out • If paper remains in the tray, take it out and combine it into a single stack Loading Paper with the new paper. • Printing on the reverse side of th
Summary of the content on the page No. 12
all.book Page 10 Thursday, August 10, 2006 2:22 PM Connecting the Power Cord Connecting the Power Cord Installing the Print Cartridge Plug the power cord into a 230 V, Print cartridge yield 50 Hz, earthed (3-prong) AC outlet. SHARP UX-C80B replacement ♦ The power outlet must be installed cartridge near the equipment and must be Ink Save mode OFF: easily accessible. Approx. 480 A4 pages Caution! Remove all packing tape Ink Save mode ON: before plugging in the power cord Approx. 800 A4
Summary of the content on the page No. 13
all.book Page 11 Thursday, August 10, 2006 2:22 PM Installing the Print Cartridge 4 Insert the new print cartridge (➊). If the display shows [PRINTER ERROR] Close the holder (➋), making sure it or [PRINTER ERROR/CHECK PAPER], clicks into place. open the cover and check for jammed paper. Remove any jammed paper (see 2 page 67) and close the cover. 1 2 Remove only the tape from the new cartridge. • Make sure all tape is removed. • CAUTION! DO NOT touch 5 Close the cover, pressing fir
Summary of the content on the page No. 14
TEL. TEL. LINE SET TEL. TEL. SET LINE all.book Page 12 Thursday, August 10, 2006 2:22 PM Connecting the Phone Line If you selected "NEW", the machine Connecting the Phone Line will print an alignment page. Continue with the steps below. Insert one end of the line cord into the 8 In the alignment page, locate the socket on the back of the machine line that is closest to a straight line. marked TEL. LINE. Insert the other end into a wall telephone socket. TEL. LINE socket In this examp
Summary of the content on the page No. 15
all.book Page 13 Thursday, August 10, 2006 2:22 PM Name and Fax Number Name and Fax Number Setting the Date and Time Enter your name and fax number. Set the date and time. ♦ Your entered name and fax number ♦ The date and time will be printed will be printed automatically at the top automatically at the top of all fax of all fax pages you send. pages you send. The date and time also appear in the display. FUNCTION 1 Press , then until FUNCTION 1Press , then until [ENTRY MODE] appears.
Summary of the content on the page No. 16
all.book Page 14 Thursday, August 10, 2006 2:22 PM Setting the Reception Mode To set the reception mode, make sure a • The currently set time appears document is not loaded in the (example): [TIME 12:19] document feeder, and then press 7 Enter a two-digit number for the RESOLUTION/ RECEPTION MODE hour ("00" to "23") and a two-digit until the desired mode number for the minute ("00" to "59"). appears in the display. Example: 9:25 For more information on receiving faxes, see Chapter 4
Summary of the content on the page No. 17
all.book Page 15 Thursday, August 10, 2006 2:22 PM Connecting the Machine 2. Scan to E-mail The Scan to E-mail feature lets you Connecting the Machine scan a document and directly send the image to an e-mail recipient. The machine is connected using an Ethernet cable (not included). Please ♦ This saves you the trouble of scanning purchase a straight-through (regular) the document into a computer and cable that supports 10Base-T. sending the scanned file using an e- mail program. Conn
Summary of the content on the page No. 18
all.book Page 16 Thursday, August 10, 2006 2:22 PM Connecting the Machine IP address 3Press . The machine requires an IP address to communicate on the Internet. • If the machine has automatically received an IP address and is able If your network is set up to to communicate, [IP ADDRESS/ automatically assign IP addresses, you DHCP: ON] will appear on the top do not need to do anything; the line of the display, followed by the IP machine will automatically receive an address on the bo
Summary of the content on the page No. 19
all.book Page 17 Thursday, August 10, 2006 2:22 PM E-mail Settings If the machine is unable to E-mail Settings communicate... Before the Scan to E-mail function can ♦ Check the Ethernet cable. Are the be used, you must configure the e-mail connections secure? Are you using settings. straight-through (not crossover) cable that supports 10Base-T? The e-mail settings specify your outgoing mail server, as well as your ♦ There may be a problem in the router sender name, sender address, an
Summary of the content on the page No. 20
all.book Page 18 Thursday, August 10, 2006 2:22 PM E-mail Settings Accessing the machine’s Web Using the machine’s operation page panel to configure the settings To access the Web page, you will need Follow the steps below to display the e- to know the machine’s host name or IP mail settings, and then configure each address (usually it is most convenient to setting as explained in the table on the use the host name). next page. To check the machine’s host name or IP FUNCTION 1Press , then
