Gianni Industries GEM DG-101 user manual

Summary of the content on the page No. 1

The DG-101 Digital Keyless Entry system
Operation User's Manual




This series of request to exit can be
Surface mounting Installation:

mounted directly in ANSI electrical box
SMB-750 housing is optional for

(Flush mount)
surface mount.


1. Product Characteristic:
Allows up to 49+50 PIN codes
Dual relays programmable On/Off or pulsed or latched mode
Fully Programmable via keypad and master code
Door Reed Switch Input for Anti-Trailing
3 LED

Summary of the content on the page No. 2

3. The indicator signal chart: Sound and LED indicator: Green LED Power on, stand-by Red LED Relay 1 activated LED signal Yellow LED Relay 2 activated 1 Beep Effective PIN codes Entering 、Exiting from the Program mode 2 Beeps Sound signal Data computing error 、 other operation mistakes 3 Beeps Master Code reset to Factory （12345 ） 5 Beeps 4. Operation Instruction: Enter Program Mode: 1. Compose twice the master code (Factory master is 「12345 」) → 2 beeps → you ar

Summary of the content on the page No. 3

Changing the Master codes: Enter the Programming mode, Enter 「＊000 」Followed by the new 5 digit master code → （beep ） →enrolled →Enter 「# 」 to exit from the programming mode, or program other operating. Master Code reset to Factory 「12345 」 Insert the jumper P1 2-3 position 5 audible beeps Reset successful Return Insert the jumper to 2-3 position. 5. Wiring diagram: Note: The suggested wire gauge is #22~26 AWG. The varistor or diode must be connected a