Summary of the content on the page No. 1
INSTALL GUIDE
KE-4 KEYLESS ENTRY SYSTEM
U.S.A. Model
WWW.ULTRASTARTERS.COM
Technical Support 866-698-5872 ext 0
Support@ultrastarters.com
FCC/ID Notice
This device complies with Part 15 of the FCC rules. Operation is subject to the following conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause
undesired operation.
CAUTION: Changes or modifications not expressly approved by the part respon
Summary of the content on the page No. 2
Installation Manual KE-4 Table Of Contents....................................................................................... Page 2 System Contents. Pre-Installation. Installation Tips. Main Wiring Diagram................................................................................... Page 3 Quick Start Installation................................................................................ Page 4 Wiring Description. Transmitter Operation. Transmitter Programming....
Summary of the content on the page No. 3
10- Pin Connector Installation Manual KE-4 15 Amp Output Park Lights (+) White LT Ground Input Chassis Ground Black - Constant 12 volts Red Main Power (+) + Ignition Input Yellow Ignition (+) IG 500ma Output Pink 2nd Unlock (-) Un2 1st Unlock (-) Blue UN 500ma Output Lock (-) Green LK 500ma Output Gray Ch2 Trunk Rel. Out (-) 500ma Output HR (-) Horn Honk Brown 500ma Output ST Starter Kill (+) 500ma Output Orange Antenna - Do Not Ground the antenna wire. ***500
Summary of the content on the page No. 4
KE-4 Installation Manual STEP 1 - The following wires MUST be connected for proper operation. Red 12vt Power (+) 15amp Input Constant 12vt power sourse. Yellow Ignition (+) 12volt Input Main ignition wire. White Park Lights (+) 15amp Output Connect to positive park lights Black Ground (-) Input Connect to chassis ground. Green Lock Output (-)500ma Output Connect to door lock relay. Blue Unlock Output (-)500ma Output Connect to door unlock relay. Optional Connections O rang
Summary of the content on the page No. 5
Installation Manual KE-4 TRANSMITTER PROGRAMMING To add additional transmitters and delete existing transmitter code(s) from memory. 1) Turn the ignition On-Off-On-Off-On-Off-On-Off. The park lights will flash twice. 2) Press the Lock button on the transmitters to be programmed. 3) The park lights will flash once, each time a new transmitter is learned. *** If this does not happen wait ten seconds and repeat steps 1-3. Note: Each system can store a maximum of three transmitter co
Summary of the content on the page No. 6
KE-4 Installation Manual Entering The Program Menu 1) Make sure ignition is in the OFF position. 2) Turn the ignition key ON - leaving key in the ON position. 3) Press the transmitter button in the appropriate sequence. 4) After ten seconds the system will automatically exit Program Mode. Setting 1 - Passive/Active Mode (Factory Default Setting: Active Mode) Passive mode means that the system will automatically arm thirty seconds after The ignition key is turned off and the
Summary of the content on the page No. 7
Installation Manual KE-4 Setting 4 - Long Door Lock Pulse (Factory Default Setting: Pulse Off) Long Door Lock Pulse means that the system can accommodate the factory central locking systems of import vehicles having vacuum door lock actuators that require a three-second lock pulse. 1 Turn the ignition on. Ignition on means normal driving position. 2 Within 10 seconds, press and release the transmitter buttons Lock Unlock Trunk Lock in succession. LONG DOOR LOCK PULSE MODE is co
Summary of the content on the page No. 8
Installation Manual KE-4 POSITIVE TRUNK RELEASE Trunk Release Solenoid Trunk Release Switch 87 +12V Grey 87a 86 85 30 NEGATIVE PARK LIGHTS Parking Lights Parking Light Switch 87 White Ground 87a 86 85 30 STARTER KILL IG2 ACC IG1 IG1 Cut Off S Sttart art x To Starter Motor 87 or Relay 87a 86 85 30 Orange
