Summary of the content on the page No. 1
INSTRUCTION MANUAL
Summary of the content on the page No. 2
CONTENTS INTRODUCTION.....................................................................................2. USING.THIS.MANUAL.............................................................................2 SYSTEM.FEATURES..................................................................................3 UDR16.RECEIVER....................................................................................4 UHT16.HANDHELD.MICROPHONE.TRANSMITTER.....................................7. UBP16.BODYPACK.MICR
Summary of the content on the page No. 3
SYSTEM.FEATURES UDR16.RECEIVER. • Frequency rotary DIP switch with 16 user-selectable channels in the wide- open UHF band for interference-free use anywhere • 120dB Dynamic Range • 150-250 ft. typical operating range — up to 500+ ft. line-of-sight • DigiTRU Diversity™ for maximum range and dropout protection • Full LED indicators (including A/B - diversity and 5 segment audio level displays) • Both 1/4” unbalanced and XLR balanced outputs • Mute (squelch) adjust control • Tone Squelch™ for loc
Summary of the content on the page No. 4
UDR16.RECEIVER. 1..Rack.Mounting.the.Receiver There are 2 options available (as accessories) for rack mounting the UDR16 receiver: single or side-by-side with another UDR16 receiver. a. Single mounting: Remove the receiver SIDE.MOUNT.CLIPS.(1) from each side of the receiver (as shown) and slide in the optional wider RACK.EARS.(2). b. Side-by-side double mounting: After removing the SIDE.MOUNT.CLIPS.(1) from both UDR16 receivers, join the two receivers with the JOINING.CLIP. (3) a
Summary of the content on the page No. 5
5...Channel.Selection Turn the frequency rotary DIP.SWITCH.(11) to one of the sixteen channels. The slot on the switch shaft should match a number or letter on the dial, which indicates the selected channel. 6..Audio.Level.and.Peak.LED.Indicator The UDR16 receiver is equipped with a five segment LED.AUDIO.LEVEL.DISPLAY. ....(15). Occasional flickering of the top Peak LED indicator on loud inputs to the transmitter is normal. If this LED lights continuously, turn down the
Summary of the content on the page No. 6
UDR16.UHF.Receiver 2 1 2 4 1 3 4 5 11 10 9 8 7 6 16 16 12 13 14 15 6
Summary of the content on the page No. 7
UHT16.HANDHELD.MICROPHONE.TRANSMITTER 1. Install batteries by unscrewing the BATTERY. COMPARTMENT. COVER. (28). ....counterclockwise and remove, exposing the BATTERY.HOLDER.(26). Insert two fresh AA. ALKALINE. BATTERIES. (27), observing the correct polarity, and screw the cover back on to the microphone. Make sure the cover is screwed clockwise completely. Fresh alkaline batteries can last up to 10 hours in use, but in order to ensure optimum performance, it is recommended t
Summary of the content on the page No. 8
UBP16.BODYPACK.MICROPHONE.TRANSMITTER 1. Open the BATTERY.DOOR.(30) by pulling on side tabs and swinging the lid open. Insert two fresh AAA ALKALINE BATTERIES into the BATTERY.COMPARTMENT. ....(31), observing the correct polarity. Fresh alkaline batteries can last up to 5 hours in use, but in order to ensure optimum performance, it is recommended that the batteries be replaced after 3-4 hours of use. 2. The UBP16 is provided with a 3.5 mm LOCKING.JACK.(33) for connecting the
Summary of the content on the page No. 9
(Note: Observe care in selecting P.A. volume, transmitter location, and speaker placement so that acoustic feedback (howling and screeching) will be avoided. Please also note the pickup pattern characteristics of the microphone selected. Omni-directional mics pickup sound equally from all directions, and are prone to feedback if not used carefully. Uni-directional mics are more resistant to feedback, but best pick up sound sources that are directly in front of the mic. Also, mics that are
Summary of the content on the page No. 10
UBP16.Body-Pack 40 33 39 CLIP 32 located on rear of Unit 38 31 30 10 37 34 35 36
Summary of the content on the page No. 11
SPECIFICATIONS OVERALL.SYSTEM.PERFORMANCE. RF.Carrier.Frequency.................UHF, 16-frequency group in separate bands within 470-510 MHz Frequency.Stability....................+/- 0.005%, PLL synthesized Modulation...............................FM (F3E), +/- 50 kHz normal Frequency.Response..................30 Hz - 21 kHz, -3dB Dynamic.Range........................120 dB Total.Harmonic.Distortion...........< 0.5% Operating.Range......................Up to 250 ft. typical (depending on site
Summary of the content on the page No. 12
WARRANTY Bogen products are warranted to be free from defects in material or workmanship for one (1) year from the date of sale to the original purchaser. Any part of the product covered by this warranty that, with normal installation and use, becomes defective will be repaired or replaced by Bogen, at our option, provided the product is shipped insured and prepaid to: Bogen Factory Service Department, 50 Spring Street, Ramsey, NJ 07446, USA. The product will be returned to you freight prep
