INSTEON 2842-422 user manual

Summary of the content on the page No. 1

Quick Start Guide
®
INSTEON Motion Sensor
Models: 2842-222, 2842-422, 2842-522
Tools Needed
• Small Phillips screwdriver
LED
Introduction
The INSTEON Motion Sensor is an indoor/outdoor motion sensor that will turn
INSTEON-controlled lights on and off in response to movement around your
home. The sensor also contains a photocell, allowing you to configure the unit to
only turn your lights on at night. Pair the Motion Sensor with INSTEON software for
almost limitless automation poss

Summary of the content on the page No. 2

Detecting Area Placement Tips Select a location that will provide the coverage required while keeping in mind the following potential problems: • Reflective surfaces - Do not aim the detector at reflective surfaces such as mirrors or windows as this may distort the coverage pattern or reflect sunlight directly onto the detector • Air flow - Avoid locations that are subject to direct high air flow such as near an air duct outlet • Moisture - Do not place th

Summary of the content on the page No. 3

Adjust Detection Area 1) Tap the Set button on Motion Sensor until the linked responder(s) turn off 2) Within 10 seconds walk well out of detection area 3) Wait 20 seconds 4) Walk into and near your detection area. Your linked responders will turn on (LED will flash upon initial motion, then once every 8 seconds during motion). a. If LED does not flash while you are moving within the desired detection area, re-aim sensor (usually means pointing the Sensor “up”) b. If LED flashes while

Summary of the content on the page No. 4

Sensor won’t control a) Make sure LED flashes to confirm it has power and is sensing motion linked responders b) Sensor is in night-only mode (and it is “day”) c) Move a dual-band INSTEON device (e.g., Access Point) closer to the Motion Sensor d) Sensor is in its 1 minute countdown LED flashing rapidly Sensor did not receive an acknowledgement from one or more linked devices. If this occurs after motion is repeatedly you may need to move a dual-band INSTEON device closer to the Sensor or