Summary of the content on the page No. 1
TL-SC2020N
Wireless N Network Camera
Rev: 1.0.0
1910010671
Summary of the content on the page No. 2
COPYRIGHT & TRADEMARKS Specifications are subject to change without notice. is a registered trademark of TP-LINK TECHNOLOGIES CO., LTD. Other brands and product names are trademarks or registered trademarks of their respective holders. No part of the specifications may be reproduced in any form or by any means or used to make any derivative such as translation, transformation, or adaptation without permission from TP-LINK TECHNOLOGIES CO., LTD. Copyright © 2012 TP-LINK TECHNOLOGIES CO.,
Summary of the content on the page No. 3
FCC STATEMENT This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to pro-vide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not in-stalled and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guaran
Summary of the content on the page No. 4
CE Mark Warning This is a class B product. In a domestic environment, this product may cause radio interference, in which case the user may be required to take adequate measures. National Restrictions This device is intended for home and office use in all EU countries (and other countries following the EU directive 1999/5/EC) without any limitation except for the countries mentioned below: Country Restriction Reason/remark General authorization required for outdoor use and Bulgaria
Summary of the content on the page No. 5
Industry Canada Statement: This device complies with RSS-210 of the Industry Canada Rules. Operation is subject to the following two conditions: 1) This device may not cause harmful interference, and 2) This device must accept any interference received, including interference that may cause undesired operation. IMPORTANT NOTE: Radiation Exposure Statement: This equipment complies with Canada radiation exposure limits set forth for an uncontrolled environment. This equipment should be
Summary of the content on the page No. 6
TP-LINK TECHNOLOGIES CO., LTD DECLARATION OF CONFORMITY For the following equipment: Product Description: Wireless N Network Camera Model No.: TL-SC2020N Trademark: TP-LINK We declare under our own responsibility that the above products satisfy all the technical regulations applicable to the product within the scope of Council Directives: Directives 1999/5/EC, Directives 2004/108/EC, Directives 2006/95/EC, Directives 1999/519/EC, Directives 2011/65/EU The above product is in conf
Summary of the content on the page No. 7
CONTENTS Package Contents..............................................................................................................1 Chapter 1 Safety Instructions..........................................................................................2 Chapter 2 Minimum System Requirement & Product Feature......................................3 2.1 System Requirement ........................................................................................................ 3 2.2 Product
Summary of the content on the page No. 8
Appendix .......................................................................................................................40 A. Frame-rate and Bitrate Table – Help to set Camera with your network environment to access Internet. ..................................................................................................................... 40 B. Storage Requirement Table - Help to set Recording Storage System............................... 40 C. System Requirement – Help to setu
Summary of the content on the page No. 9
Package Contents The following items should be found in your package: TL-SC2020N Wireless N Network Camera Power Adapter Mounting Bracket with three screws, a Lock Ring, a Brace and a Base Plate RJ45 Cable Quick Installation Guide Resource CD, including: This User Guide Application Guide Other helpful information Note: Make sure that the package contains the above items. If any of the listed items is damaged or missing, please contact your distributor. 1
Summary of the content on the page No. 10
Chapter 1 Safety Instructions Before you use this product This product has been designed with safety in mind. However, the electrical products can cause fires which may lead to serious body injury if not used properly. To avoid such accidents, be sure to heed the following. Legal Caution Video and audio surveillance can be forbidden by laws that vary from country to country. Check the laws in your local region before using this product for surveillance purposes. Don't open the h
Summary of the content on the page No. 11
Chapter 2 Minimum System Requirement & Product Feature 2.1 System Requirement For normal operation and viewing of the network camera, it’s recommended that your system meets these minimum requirements for proper operation: Item Requirements CPU Pentium 4 2.8GHz (or equivalent AMD) Graphic Card 256 MB RAM graphic cards (or equivalent on-board graphic cards) RAM 2 GB RAM Operating Windows 2000 / Windows 2003 / Windows XP / Windows Vista / System Windows 7 Web Browser Internet Expl
Summary of the content on the page No. 12
TCP/IP, DHCP, PPPoE, ARP, ICMP, FTP, SMTP, DNS, NTP, UPnP, Supported protocols RTSP, RTP, RTCP, HTTP, TCP, UDP Simultaneous Up to 3 users Connection 0°C ~ 40 ℃ (32 ℉ ~ 104 ℉) Operating conditions HARDWARE Lens F 2.4 fixed lens Audio Output 1 Power 5V DC, 1A Wireless IEEE 802.11b/g/n with WEP/WPA/WPA2. Up to 150 Mbps WPS 1 (Wi-Fi Protected Setup) 2.3 Physical Overview 2.3.1 Front View Built-in Microphone Power LED Indicator Network LED Indicator: It lights up when the Camera
Summary of the content on the page No. 13
Solid Blue: The Camera has been connected to a network. Built-in Microphone: The location where the voice from your partner comes out. 2.3.2 Rear View Power Jack LAN Port WPS LED Indicator RESET Button WPS Button Base Plate Power Jack: The power connector is where you connect the power adapter. RESET: Press the button for more than 15 seconds, and the Camera will be restored to factory defaults. LAN Port: Through this port, you can connect the Camera to your computer or th
Summary of the content on the page No. 14
2.4 Mount the Camera 2.4.1 The Screw Size There are three supplied screws for mounting the Camera. The length of the screws is 25±1 mm and the diameter is 4±0.2 mm. 2.4.2 Wall and Ceiling Mount There are two ways to mount the Camera. See the following two pictures. Ceiling Mount Wall Mount To mount the Camera, please follow the steps below: 1. Use the three supplied screws to fix the base plate to a flat surface. 2. Loosen the lock ring to adjust the desired angle of the Camer
Summary of the content on the page No. 15
Wireless section of 5.3.2 Network. Please connect the Camera according to the following steps. 2.5.1 Wired Connection 1. Connect the Camera to the LAN network (Router or Switch) via Ethernet cable. 2. Connect the power adapter cord to the Power Jack. 3. Plug the power adapter into the power outlet. 2.5.2 Wireless Connection (by WPS) Power on the Camera and make sure that the Power LED is flash red. Then take the following steps. A. Press the WPS button on the Router supporting WPS
Summary of the content on the page No. 16
Chapter 3 Using Camera via Web Browser 3.1 Obtain the IP Address 1. Insert the provided CD into your CD-ROM driver. The Setup Wizard will automatically pop up on your computer’s screen as shown in the figure below. Figure 3-1 2. Choose the Intelligent IP Installer, and then the next screen appears. Click on Intelligent IP Installer to begin the installation. Figure 3-2 8
Summary of the content on the page No. 17
3. After the installation is finished, click Start > All Programs > TP-LINK >Intelligent IP Installer to start using the program. Figure 3-3 4. The following screen will then display. Click the Search button to search Network Cameras in the network; it displays Network Cameras information including IP Address. Figure 3-4 9
Summary of the content on the page No. 18
3.2 .2 W Wiindows ndows W We eb Browser b Browser The configur The configuration of brow ation of browser is ser is si similar milar in Windows XP/V in Windows XP/Viist sta/7. a/7. Here w Here we e t ta ake IE browser in Windows XP ke IE browser in Windows XP for example. for example. 1 C 1 Click lick Link to Link to IE IE button in button in Figure 3 Figure 3- -4 4 di directly rectly. Y . You can also laun ou can also launch your w ch your web eb browser browser and and then ent then e
Summary of the content on the page No. 19
3 The monitor image will be displayed in your browser. In the far left side of main configuration are Home, Information, Basic setup, System and Language. 11
Summary of the content on the page No. 20
Chapter 4 Operating Camera via Mobile Phone 4.1 Mobile Phone Viewing 4.1.1 3G Mobile Phone Streaming Viewing For 3G mobile phone viewing, type “rtsp://:/video.3gp” into your 3G Streaming Link. is the Public IP address of your Camera; is the RTSP port of your Camera (Default value is 554.) Example: rtsp://100.10.10.1:554/video.3gp. Note: You can also use RTSP clients (RealPlayer, VLC, QuickTime Player…etc.) to view RTSP streaming, just type in “rtsp://:
