Polycom RMX 4000 user manual

Summary of the content on the page No. 1

RMX™ 4000
During the first-time power-up the red ERR LED on the RMX’s front panel remains
Installation Quick Start Guide for
• Two people are required to lift the MCU out of the box and when installing it in a
ON until both the Management and IP Network Services have been defined.
rack.
RMX 4000 3 Remove the USB key.
• LAN 4, LAN 5 and the Serial ports are only for debugging and not for customer
use. Enter the IP address of the RMX Control Unit and press Enter.
• Do not remove the protectiv

Summary of the content on the page No. 2

RMX™ 4000 13 Create a new User with Administrator permissions and delete the default User Modifying the Default IP Service (POLYCOM). For system security reasons, only when this step is completed and if This section describes the definition of H.323 Network Service. For detailed description there are no System Errors, the system is fully configured and the green RDY LED of H.323, SIP and ISDN Network Service definitions, see the RMX Getting Started Guide, on the CNTL module (on the RMX’s