American Standard 2881 user manual

Summary of the content on the page No. 1

Installation
Instructions
SPREAD
THE
2881
“”
LAVATORY
™
COLLECTION
by
FAUCET
Thank you for selecting American-Standard...the benchmark of fine
quality for over 100 years.
Certified to comply with ANSI A112.18.1M
To ensure that your installation proceeds smoothly--please read these
instructions carefully before you begin. M968211
TOOLS REQUIRED
Channel Locks Adjustable Wrench Plumbers' Putty or Caulking Phillips Screwdriver
SPOUT ASSEMBLY
VALVE INSTALLATION
1 2
CAUTION
Turn off hot and cold wa

Summary of the content on the page No. 2

MAKE WATER SUPPLY CONNECTIONS 4 NOTE: FLEXIBLE SUPPLIES OR BULL-NOSE RISERS MUST BE PURCHASED SEPARATELY. Connect water supply to FAUCET (1) with 1/2" IPS FLEXIBLE SUPPLIES (3) or 3/8" O.D. BULL-NOSE RISERS (4). Use wrench to tighten connections. COUPLING Do not over tighten. Be careful not to kink copper supply when NUT bending. Use tubing cutter to cut to proper length. 1 4 FERRULE 3 INSTALL HANDLES 5 6 Push ADAPTER (1) on VALVE STEM (2), so that the hole of the 5 ADAPTER (1) without spline is

Summary of the content on the page No. 3

INSTALL POP-UP DRAIN 1 7 2 Push Tail piece (11) down into Trap (C) (threaded end up). D Thread Locknut (5), Washer (4) and Gasket (3) (Bevel side A up) onto Drain Body (10). E Apply a bead of Putty (D) to underside of Flange (2). Feed Drain Body (10) up through Sink (A) and thread the 3 6 Flange (2) fully onto Drain Body (10). Tighten Locknut (5) firmly, keeping the pivot rod hole pointed 4 7 towards the back of the sink. Assemble Pivot Rod (9) as shown in Figure-4B. Notice the 5 F position of