American Standard Cadet 3 Flushing System 2386 user manual

Summary of the content on the page No. 3

10 11 ARM TOP REFILL ADJUSTMENTS NIPPLE TUBE a. Adjust water level. Water level should TANK be adjusted to level indicated on tank LEVER CRITICAL LEVEL by adjusting float cup. MARK ("C.L.") MUST BE 1" ABOVE OVERFLOW PIPE See Step 11 for water level adjustment FLOAT CUP method FILL VALVE b. If bowl fails to siphon, an adjustment FLUSH may be required with the lift chain. VALVE Simply remove the bead chain from VALVE the retainment clip and take up slack BODY WATER L

Summary of the content on the page No. 4

TROUBLESHOOTING 13 IF FILL VALVE SHUTS OFF BUT CONTINUES TO LEAK SLOWLY, repeat Step 13. IF FILL VALVE TURNS OFF AND ON DURING PERIODS OF NON-USE, it is a signal you are wasting water because: • The end of the refill tube is inserted into overflow pipe, below LIFT ARM water level in tank. Attach refill tube to overflow pipe using "S" FIRST clip provided. • The flush valve is leaking because it's worn, dirty or misaligned with tank ball or flapper (replace with a new flapper). IF FILL

Summary of the content on the page No. 1

INSTALLATION INSTRUCTIONS
CARE AND MAINTENANCE
®
CADET 3 - 1.6 GPF TWO-PIECE TOILET
Models 2383 / 2384 / 2386 / 2447 / 2431 / 2880 / 3305
®
CADET 3 FloWise™ - 1.28 GPF TWO-PIECE TOILET
Models 2829 / 2832 / 2835 / 2838 / 2880 / 3305
Thank you for selecting American Standard - the benchmark of fine quality for over 100 years. To ensure this product is
installed properly, please read these instructions carefully before you begin. (Certain installations may require professional
help.) Also be s

Summary of the content on the page No. 2

6 7 For Tanks/Bowls using Speed Connect System (Tank mounting bolts pre-installed). RUBBER TANK MTG. GASKET BOLTS PRE- BOLT CAP INSTALLED CLOSET FLANGE WASHER/ NUT COMBO CLOSET BOLT WASHER NUT INSTALL TANK a. Install large rubber gasket over threaded outlet on bottom of tank and lower tank INSTALL TOILET onto bowl so that tapered end of gasket fits evenly into bowl water inlet opening, a. Position toilet squarely to wall and, with a rocking and tank mounting bolts go thr